LG | V-C3460NT | LG V-C3460NT Owner’s Manual

V-C3440NB/ND/NT/NBV/NDV/NTV
V-C3440SB/SD/ST/SBV/SDV/STV
V-C3460NB/ND/NT/NBV/NDV/NTV
V-C3600ST
31
19
2
15
17
18
2
22
1
16
4
5
3
23
6
12
9
13
11
14
10
12
4
21
4
4
65
3
13
14
9
10
11
15
12
--2--
17
17
30
18
16
21
20
19
19
22
24
25
23
26
29
27
--3--
28
Information for your
Using the cleaning head and Accessory
Nozzles(depending on model) Fit the large
safety
Please read all the
which contains
following information,
important instructions for the
safety, the use and the maintenance of
appliance.
This appliance complies with the following
cleaning
?
the
EC
Directives: -73/23/EEC, 93/68/EEC-Low
Voltage
Directive-89/336EEC-EMC Directive.
Never allow children to
the
use
appliance
?
unsupervised.
Do not
appliance If the mains lead is
faulty.
If the mains lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent as special tools are needed
to repair it.
Always switch the vacuum cleaner off
use
damaged
the
?
changing
changing
If
?
?
Dusting brush (14)
For vacuuming picture frames, furniture
outlines, books and other uneven objects.
Upholstery Nozzle (15)
For vacuuming upholstery, mattresses, etc.
the dust
How to
or
Pull out the mains lead to the desired
dust
no
position head is equipped with a
pedal (10) or two pedals (12) which allows
you to alter its position according to the type
of floor to be cleaned. Hard floor position
(tiles, parquet floors...). Press on the pedal to
lower the brush. Carpet or rug position.
Press on the pedal to lift the brush up.
Crevice Tool (13)
For vacuuming in those normally inaccessible
places like a window frame or a crevice in the
wall.
or
before:
?
head onto the end of the tube.
The 2
bag
cleaning the filters.
bag is inserted, the
cover
and
plug
plug
Press button
by force!
To
vacuum
flammable
substances(liquids
Do not
vacuum
or
explosive
or
gases).
hot ash, embers
or
sharp
objects.
Do not
vacuum
water
or
other
liquids.
the
Connecting
(2)
vacuum
To
(1)
on
into the attachment
on
the
remove
the flexible hose from the
vacuum
on
(depending on model)
Metal or plastic tube (4)
Fit together the two tubes by twisting slightly.
Telescopic tube (5)
Hold spring latch (6)
Pull out the tube to required length.
Release spring latch to lock.
?
-
?
-
-
manual air
regulator (19)
model).
?
cleaner.
cleaner, press on the button (3) situated
the head, then pull upwards.
Assembling the tubes
a
which allows you to briefly
reduce the suction level(depending on
the flexible
point
right,
you slide the button towards
greater the suction power.
more
the
The flexible hose handle has
flow
the flexible hose
Push the end of the head
hose
?
the power level
If your appliance is equipped with an
electronic variable power control (17), you
can choose the power appropriated for the
task. The
How to Use
length
(16) to start the vacuum cleaner.
stop it press the button (16) again.
Adjusting
?
use
into the socket.
cannot be closed. Please do not close it
Do not
in and
Booster:If you push the booster button (30),
you can use higher power than normal power
for 10 seconds. The mode returns to the
previous
one
automatically.
Park-System (20)
For short breaks
during vacuuming, for
piece of furniture or
a rug, use the [Park system] to support the
flexible hose and cleaning head.
Slide the hook attached to the large cleaning
tool into the slot on the rear of the appliance.
example
?
-
--4--
to
move a
small
Carrying
and storage
(21)
You
can
move or
store your
vertical
position by sliding
large cleaning head into
underside of the appliance.
Changing
The dust
bag
the dust
needs
appliance
the hook
the
clip
in
on
on
the
by tapping
it to
regularly
the dirt.
every 6
or
anti-odor
changed regularly
bag changes).
What to do if your
does not work
when the cleaner
completely coloured red.
bag does not appear to be full
at this stage, it should be changed. It could be
that a great deal of fine dust has clogged up
the pores of the dust bag.
Turn off the appliance and unplug it.
Open the cover by pulling the latch (23) and
lifting it up.
Your appliance is equipped with either a paper
dust bag or a fabric dust bag (26) (depending
on model)
Take hold of the dust bag by the handle and
pull. Remove the bag and throw it away.
To refit a new bag, push the cardboard
support of a new bag (24) into the bag mount
(25) until it will go no further.
cover
charcoal filter should be
(approximately
is
remove
The electrostatic filter
?
the
Even if the dust
filter
and then,
The foam filter, should be cleaned
a
is set to maximum power and the cleaner head is
off the floor but the "bag full" indicator window
(22)
change these filters, open the
(29) by pulling the latch (23)
change these filters.
?
bag
changing
To
?
When you have switched off and unplugged
the appliance, press the button (18) to
automatically rewind the cord.
Check that the
is
appliance
appliance
correctly plugged
working.
in and that the electrical socket is
What to do when the suction
performance reduces?
?
?
cleaning
?
?
If your appliance is fitted with a fabric
dust bag follow the same instructions as above.
it and
Cleaning
replace
it
(26).
Do not wash it.
the motor filter
The motor filter is situated inside the
appliance
bag and the motor. Each
time that you change the air outlet filter we
advise you to remove the motor filter (27) and
to clean it by tapping to remove the dirt and
then replacing it in the vacuum cleaner.
between the dust
Changing
the air outlet filters
Depending on
your appliance
of filters
:
the model you have chosen,
equipped with different types
is
foam filter
or
anti-odor charcoal filter
electrostatic filter
or
(28).
--5--
tool
are
unplug
it.
Check that the tubes, flexible hose and
?
appliance
and
Stop
?
?
Empty
the
?
blocked
Check that the dust
or
not.
bag
is full
or
Replace if necessary.
Check that the air outlet filter is blocked
Replace
if necessary.
or
not.
not.
P/No.: 3828Fi3810A
Download PDF

advertising