LG | V-C7760NT | LG V-C7760NT Owner’s Manual

V-C7760NT
V-C7760NE
Table of contents
Information for Your
Safety......................................................................................3
How to Use.................................................................................................................4
Assembling
Using
the
Emptying
the Cleaner ........................................................................................................4
cleaning
head and Accessories.............................................................................6
the Dust Chamber .................................................................................................8
Operation...............................................................................................................................9
Adjusting
the Suction power ..................................................................................................9
Park-System ..........................................................................................................................9
Cleaning
the Motor Filter / Air Cleaner ................................................................................10
Cleaning
the Dust Chamber ................................................................................................11
Cleaning
the Exhaust Filter .................................................................................................11
What to do if there is
something wrong
with your Vacuum Cleaner .................12
What to Do if your Vacuum Cleaner Does Not Work...........................................................12
What to Do When Suction Performance Decreases ...........................................................12
2
Information for Your
Safety
Please read all the
following information, which contains important instructions for the safety,
the use and the maintenance of the appliance.
This appliance complies with the following EC Directives: -73/23/EEC,
93/68/EEC-Low Voltage Directive-89/336EEC -EMC Directive.
Do not use the appliance If the power cable is damaged or faulty.
If the power cable is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard.
Always switch the vacuum cleaner off before:
Emptying the dust chamber.
Cleaning or changing the filters.
Do not vacuum flammable or explosive substances(liquids or gases).
Do not vacuum hot ash, embers etc. or sharp objects.
Do not vacuum water or other liquids.
When you vacuum with an attachment appliance that has a rotating brush roller:
The application is not intended for use by young children or infirm persons without supervision.
Young Children should be supervised to ensure that they do not play with appliance.
If the appliance is supplied from a cord extension set or an electrical portable outlet device, the cord extension set
on electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of moisture.
3
Assembling Cleaner
2
Fit the
large cleaning
head onto
the end of the tube.
Spring
latch
Telescopic
tube
1
Nozzle outlet
Large cleaning
head
Push the head onto the
Telescopic
?
telescopic tube.
Press the
tube
spring latch
to
release.
?
Pull out the tube to the desired
length.
?
?
Release
spring latch to lock
the tube in position.
Push telescopic tube into hose
handle until catch clicks.
4
Head
Flexible Hose
Attachment Point
Button
3
Connecting
the hose to the cleaner
Push the end of the head
into the attachment
To
remove
pull
on
the flexible hose
the
vacuum
the flexible hose from the
cleaner, press
then
point
on
on
the button situated
the head out of the
vacuum
cleaner.
vacuum
on
the
head,
cleaner.
5
Using
the
Tear the
cleaning
head and
vinyl bag
and
pull
Accessory
Nozzles
out accessories.
Attach the accessory holder into the side hole of
And then, Fit the
Dusting
body.
Brush & Crevice Tool and
Upholstery
Nozzle onto the accessory holder.
Fit the accessory onto the end of the tube.
Upholstery nozzle
Dusting brush
& Crevice tool
1
2
Upholstery
Nozzle
Dusting
Upholstery Nozzle is for
vacuuming upholstery,
frames, furniture frames, books and other
mattresses, etc.
hard surfaces.
The thread collectors
Crevice Tool is for vacuuming in those
normally hard-to-reach places such as
help
to
pick up
the threads and fluff.
The
dusting Brush is for vacuuming picture
reaching cobwebs,
of
6
Brush & Crevice Tool
a
sofa.
or
between the cushions
1
2
(Refer
to
Page 6)
3
5
4
3
(See below)
(See below)
(Refer to Page 10)
4
Pedal
NE
Head
Spring
latch
Spring
latch
3
Large cleaning
head
4
Elbow tube
(V-C7760NE)
?
?
?
The 2
position cleaning head is
equipped with a pedal which allows
you to alter the brush position
according to the type of floor to be
Elbow tube is for
cleaning under the
sofa, table and bed easily.
?
Connect the elbow tube to the
cleaned.
flexible hose and, connect the
telescopic tube to the elbow tube.
Hard floor
(You
position(tiles, parquets floor)
Press the pedal to lower brush.
Carpet or rug position
Press the pedal to use the brush.
can
also connect the
telescopic
tube to the flexible hose without the
elbow
?
If
tube.)
you pull the spring latch, the elbow
tube
?
can
be bent.
If you stretch the elbow
returned to its position.
tube, it is
7
Emptying
the dust chamber
The dust chamber needs
emptying
reaches the MAX indicator
the dust tank.
on
when dust
?
Turn off the
?
Press the button of the
?
cleaner and
cover
unplug it.
and pull the dust
chamber out.
Remove the dust chamber cap and empty the dust chamber.
To reinstall the dust chamber, replace the dust chamber cap and
push
8
vacuum
the dust chamber into the tank mount
as
far
as
it will go.
Operation
2
1
Operation
?
Adjusting
Pull out the power cord to the
desired length and put plug into the
socket.
?
Press On/Off button to start the
vacuum
3
?
the Suction power
The flexible hose handle has
a
manual air flow
regulator which
allows you to reduce the suction
level briefly.
Park
?
To store after
vacuuming
vacuuming.
To
?
Press the cable reel button to retract
-
stop it, press On/Off button again.
the power cord after
use.
and
pause while
When you have finished
cleaner.
?
System
-
vacuuming, use the Park
System to support the flexible
hose and cleaning head.
Slide the hook on the large
cleaning head into the slot on
the handle of the dust chamber.
9
Cleaning
The
permanent
cap.
When the filter
motor filter is situated under the dust chamber
light
comes on
?
Press the button of
?
Open
?
?
the Motor Filter/Air cleaner
cover
the motor filter
and
pull
requires cleaning.
the dust chamber out.
the dust chamber cap.
Remove the motor filter by rotating it counter-clockwise.
Clean the motor filter with the brush under cold
running
water.
?
?
Allow the motor filter to
the motor filter should
be cleaned every 6 months.
The spare motor filter must be used while the other motor
filter is
10
dry naturally,
drying.
WARNING!
Gently
runs
rinse both parts
separately
clear. Hand wash
Shake off
Do not
excess
under cold
running
water until the water
only with damp cloth.
water from the filter.
tumble/spindry,
microwave
Ensure the filter is
completely dry.
Re-assemble and
place
or
place
in
oven or on
it back in your machine, filter frame.
direct heat.
Cleaning
the Dust Chamber
Cleaning
the Exhaust Filters
2
1
3
Open
the dust chamber cap.
Remove two
plates
from
the dust chamber.
?
The exhaust filter is
?
To clean the exhaust
filter,
the filter
cover on
body by rotating
the filter
cover
a
the
washable reusable HEPA filter.
counter-clockwise.
?
Pull out the exhaust filter.
?
Clean it with
Do not
?
use
remove
cold, running
the brush
Allow exhaust filter to
water.
this will
damage
dry completely in a
as
the filter.
shaded
location.
?
Wash both
parts with soft cloth.
Gently rinse both parts under cold running
The exhaust filter should be cleaned at least
a
once
year.
water.
11
What to do if there is
something wrong
with your
Vacuum Cleaner
What to Do if Your Vacuum Cleaner Does Not Work
Check that the
vacuum
cleaner is
plugged
in
correctly
and that the electrical socket is
working.
What to Do When Suction Performance Decreases
?
Turn off the
?
Check the
?
Check that the dust chamber is not full.
?
Check that the motor filter
?
Check that the exhaust filter is not
vacuum
cleaner and
telecsopic tube,
it.
unplug
flexible hose and
light
is not
cleaning tool for blockages
Empty if necessary.
or
obstructions.
filter, if necessary.
blocked. Clean the exhaust filter, if necessary.
on.
Clean the motor
WARNING!
Should it become necessary to
12
replace
the moulded
plug
then the detective
plug
should be
replaced by
a
qualified
electrician.
Notes
13
Notes
14
P/No.: 3828Fi2836G
Download PDF