LG | V-CA504CEU | LG V-CA504CEU Owner’s Manual

V-CA504CEU
V-CA504CT
Table of contents
Information for Your
How to Use
cleaner
the and
How to
use
Changing
Operation
How to
..........................................................................................
Accessory
elbow
Dust
Nozzles
........................................................................
tube, Air turbine brush...............................................................
Bag
...........................................................................................
........................................................................................................
in and
Plug
Adjusting
.............................................................................
......................................................................................................
Assembling
Using
Safety
use
......................................................................................
the Suction level
.................................................................................
Park-System
...................................................................................................
Cleaning
2
the Exhaust Filter
................................................................................
3
4
4
6
8
9
9
9
10
10
11
Information for Your
Safety
Please read all the
following information, which contains important instructions for the safety,
appliance.
This appliance complies with the following EC Directives: -73/23/EEC,
93/68/EEC-Low Voltage Directive-89/336EEC -EMC Directive.
Never allow children to use the appliance unsupervised.
Do not use the appliance If the power cord is damaged or faulty.
If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to
Always switch the vacuum cleaner off before:
Cleaning or changing the filters.
Do not vacuum flammable or explosive substances(liquids or gases).
Do not vacuum hot ash, embers etc. nor sharp objects.
Do not vacuum water or other liquids.
Do not unplug by pulling on cord.
Use only LG's recommended filters.
When you vacuum with an attachment appliance that has a rotating brush roller:
Do not reach into the running brush roller.
the
use
and the maintenance of the
avoid
a
hazard.
?
?
Thermal
protector: This vacuum cleaner has a special thermostat that protects the cleaner in
overheating. If the cleaner suddenly shuts off, turn off the switch and unplug the cleaner.
Check the cleaner for a possible source of overheating such as a full dust chamber, a blocked hose or clogged
If these conditions are found, fix them and wait at least 30 minutes before attempting to use the cleaner.
After the 30 minutes period, plug the cleaner back in and turn on the switch. If the cleaner still does not run,
contact a qualified electrician.
case
of motor
filter.
3
How to Use
Fit the
large cleaning
Spring
Assembling
Cleaner
head onto the end of the tube.
latch
2
Elbow
(V-CA504CEU)
Telescopic
tube
1
(V-CA504CEU)
1
The 2
Push
position
telescopic
nozzle outlet.
4
head
tube into
2
Telescopic
tube
?
Press the
?
Pull out the tube to the desired
?
Release
?
Push
spring
latch to release.
length.
spring latch to lock the tube inposition.
telescopic tube into hose handle firmly.
Head
Flexible Hose
Button
3
Attachment Point
3
Connecting
?
the flexible hose
Push the end of the head
into the attachment
?
To
remove
point
the flexible hose
on
on
the
vacuum
cleaner.
the flexible hose from the
press on the button situated
then pull the head out of the
on
vacuumcleaner,
the head,
vacuum
cleaner.
5
How to Use
Using
the
Accessory
Nozzles
Crevice tool
Dusting
Upholstery
1
1
2
Upholstery
Nozzle
Upholstery Nozzle is for
vacuuming upholstery,
mattresses, etc.The thread
collectors
help
to
pick
the threads and fluff.
up
2
Dusting
brush
nozzle
3
Brush
Dusting Brush is for vacuuming
picture frames, furniture frames,
books and other irregular surfaces.
3
Crevice Tool
Crevice Tool is for
vacuuming in those
normally hard-to-reach
places such as
reaching cobwebs, or
between the cushions
of
6
a
sofa.
2
1
3
4
5
6
7
(V-CA504CEU)
4
5
Pedal
4
The 2
?
?
head
5
The 2 position cleaning head
equipped with a pedal which allows
you to alter its position according to
the
?
position
type of floor
Hard floor nozzle
?
Efficient
(Wood,
cleaning
Linoleum
of hard floors
etc.)
to be cleaned.
Hard floor
position
(tiles, parquets floor)
Press the pedal to lower brush.
Carpet or rug position
Press the pedal to lift the brush
up.
7
How to
use
6
elbow tube, Air turbine brush
(V-CA504CEU)
7
Pile
Adjustment
Long
Spring
Pile
latch
(V-CA504CEU)
Short Pile
Spring
6
?
Air Turbine Brush
Slide the Pile
long pile
Adjustment to
latch
7
the
and to the left for short
right
pile
for
Elbow tube
Elbow tube is for
table and bed
?
cleaning
easily.
under the
sofa,
Connect the elbow tube to the flexible
hose
and,
connect the
the elbow tube.
telescopic
(You
telescopic
can
tube to
also connect the
tube to the flexible hose without
the elbow
?
?
tube.)
pull the spring latch,
If you
is bended.
If you stretch the elbow
to its
8
position.
the elbow tube
tube, it is returned
How to
use Changing
dust
bag
Motor
Filter
Changing
dust
The dust
needs
bag
changing when the cleaner is set to maximum power and the cleaner
completely coloured red.
Even if the dust bag does not appear to be full at this stage, it should be changed.
It could be that a great deal of very fine dust has clogged up the pores of the dust bag.
Turn off the appliance and unplug it.
bag
head is off the floor but the
"bag
full"
indicator window is
?
?
Push the button and open the cover.
appliance is equipped with either
?
Your
?
Pull the handle up.
Push the yellow button and
?
Insert the
?
If your appliance is fitted with a fabric dust
it and replace it. Do not wash it.
new
dust
a
paper dust
the old dust
remove
bag
or a
fabric dust
bag.
bag.
bag.
bag
follow the
same
instructions
as
above.
Empty
Note:
as
the
is not fitted
appliance
correctly.
is fitted with
a
The motor filter is situated inside the
advise you to
remove
safety
device which checks that the dust
appliance
between the dust
the motor filter and to clean it
by tapping
to
bag
bag
is in
place
you cannot close the lid if the dust
bag
and the motor. Each time that you change the air outlet filter
the dirt and then replacing it in the vacuum cleaner.
we
remove
9
Operation
Cord reel button
Suction control switch
2
1
Plug
4
3
1
How to
Plug
2
in and Use
?
Adjusting the
Pull out the power cord to the
desired length and plug into
?
the socket.
Push the suction control switch
When you press the
button that you desire,
of the hose handle in the
the
direction of the
?
you want.
To stop it,
position what
push down the
switch in the direction of OFF.
Press the cord reel button to
retract the power cord after
10
?
light
comes on.
If you press the Auto
button, the power is
automatically adjusted
by the amount of dust.
suction control
?
Adjust the power by
using the power control
?
System
Storage
4
use.
To store after
vacuuming
?
When you have switched off
and unplugged
?
The
and pause while
switch in the handle.
?
?
Park
3
Suction level
?
vacuuming.
For deposit after
vacuuming, for
example to move a small
piece of furniture or a rug,
use the Park system
support the flexible
hose and
-
cleaning
to
head.
Slide the hook
on
large cleaning
head into
the slot
rear
on
the
dust chamber.
the
of the
appliance, press on
autornatically
the button to
rewind the cord.
?
You
can
store your
appliance in a vertical
position by sliding the hook
on the large cleaning head
into the clip on the
underside of the appliance.
the Exhaust Filter
Cleaning
Filter
cover
?
The exhaust filter is
?
To
?
Pull out the exhaust filter.
?
change
Clean it with
Do Not
-Using
use
a
washable reusable HEPA filter.
the exhaust
filter, removethe filter
cold, running
cover on
the
body by
release hook.
water.
the brush
the brush will
cause
Allow exhaust filter to
?
The exhaust filter should be cleaned at least
dry
in
permanent damage and allowdust
?
a
shaded location for
a
once a
dry
or
to
bypass the filter.
completely drys.
two until
year.
11
What to Do if Your Vacuum Cleaner Does Not Work:
Check that the
vacuum
is
plugged
in
correctly
and that the electrical socket is
working.
What to Do When Suction Performance Decreases:
12
?
Turn off the
?
Check the
vacuum cleaner and unplug it.
telescopic tube, flexible hose and cleaning tool
that the dust bag is not full. Empty if necessary.
?
Check
?
Check that the exhaust filter is not blocked. Clean the exhaust
for
blockages
or
obstructions.
filter, if necessary.
Note
13
Note
14
P/No.: 3828FI2847E
Download PDF