English -2- -3- E Information for your Using safety Fit the Please read all the following information, which contains important instructions for the safety, the use and the maintenance of the appliance. This appliance complies with the following EC Directives: -73/23/EEC, 93/68/EEC-Low Voltage use the appliance ? unsu- pervised. Do not or the switch the Always changing changing ? If no vacuum or bag cleaning the dustbag is cleaner off before ? stances(liquids ? filters. inserted, the cover flammable or sub- explosive gases). hot vacuum or Upholstery Nozzle (11) For vacuuming uphostery, mattresses, etc. The thread collectors help to pick up the threads Dusting brush (10) For vacuuming picture ash, embers etc. nor sharp How to plug frames furniture uneven in and water or other liquids. do not reach into the running plug use To brush roller. ? How to Use the flexible hose Insert the hose holder (1) (12) (2) Electronic power control(15) OFF:Power off MIN: Low power MAX:Full power. AUTO: Suction capacity will change automatically according to the quantity of surface dust. to move a small is to be disconnected from the press the release button (3) and the hose holder out of the suction opening. to start the vacuum cleaner. stop it press the button again. For short breaks appliance, and Park-System (16) into the suction open- ing. When the hose length into the socket. Press button appli- outlines, objects. Pull out the main lead to the desired vacuum Connecting sofa! a books and other When you vacuum with an attachment ance that has a rotating brush roller: ? (9) vacuuming in those normally inaccess- ible places i.e. reaching cobwebs, or down the side and fluff. cannot force! use contains accessories. (8) Crevice Tool of : objects. Do not position head (6) is equipped with a pedal (7) which allows you to alter its position according to the type of floor to be cleaned. Hard floor position(tiles, parquet floors...). Press on the pedal to lower the brush. Carpet or rug position. Press on the pedal to For ? vacuum Do not head onto the end of the The 2 The accessory holder the dust be closed. Please do not Do not large cleaning If the main lead is appliance faulty. If the main lead is damaged, it must be replaced by an approved LG Electronics Service Agent as special tools are needed to repair it. ? Accessory lift the brush up. use damaged head and cleaning tube. Directive-89/336EEC-EMC Directive. Never allow children to the Nozzles the pull Park cleaning Adjusting the tube (4) Hold spring latch (5) Pull out the tube to required length. Release spring latch to lock. ? system to support the flexible hose and head. Slide the hook attached to the tool into the slot ? during vacuuming, for example piece of furniture or a rug, use on the rear of the large cleaning appliance. ? Carrying ? Connecting the accessory holder When the accessory holder (8) is to be connected to the hose (2), hold the hose (2) and push the holder at the desired position and storage(17) When you have switched off and unplugged the appliance, press on the button (13) to automati- cally of the hose. -4- rewind the cord. E You appliance in a vertical on the large cleaning underside of the appli- The working life of this set is 7 years since the delivery to the consumer. Upon the expiry of the said period, it might be unsuitable for the use according to their destination. store your can move or position by sliding head into the clip the hook the on date of ance. Changing the dust bag dustbag needs changing The when the cleaner is What to do if your does not work set to maximum power and the cleaner head is off the floor but the "bag Even if the dustbag It could be that a ? Turn off the ? Press the release Open the lifting it up Your dust changed. and appliance holder out of the cover Check that the unplug button(3) and pull suction opening. the hose by pressing the hook(19) place. either and ? a and take out the dust ? Press the one-touch release button (20) ? bag. ? (21) and the a new into the a new If your appliance is fitted with a fabric dust bag follow the same instructions as above. Empty it and Note: as it Do not wash it. replace the appliance is fitted with device which checks that the cannot close the lid if the Cleaning bag bag is not a safety place you fitted correctly. is in the motor filter The motor filter is situated inside the between the dust that you change bag tapping the filter(24) we advise you and to clean it by to remove the dirt and then vacuum appliance and the motor. Each time the air outlet filter to remove the motor replace it in cleaner. Changing & Cleaning the washable HEPA filter To change the washable HEPA filter(25), remove the cover of the filter compartment(26) situated at the rear of the appliance, by lifting the ? little catch. ? The washable HEPA filter should be cleaned with cold and - - Do not use running water at least once a year. the brush. Allow HEPA filter to dry in a shaded place for the a day. -5- appliance Check that the are and unplug it. tubes, flexible hose and cleaning not blocked. Check that the dust bag is not full.Replace if necessary. Check that the air outlet filter is not blocked. Replace in dust bin. bag push the cardboard support bag bag mount (22) until it is trapped by the wall of button (21) of Stop tool paper ? Hold the handle To refit in What to do when the suction performance reduces? it. ? ? correctly plugged working. bag. until it snaps into bag drops is and that the electrical socket is appliance is equipped with bag or a fabric dust bag (23). dust appliance appliance great deal of very fine dust has up the pores of the dust clogged ? does not appear to be full at it should be stage, window(18) is coloured red. completely this full" indicator if necessary.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project