LG | V-CQ263ST | LG V-CQ263ST Owner’s Manual

V-CQ243/NT/ND/ST/SD/STU/STV/STQ/HT/HTV/HTU/HTQ
V-CQ253/NT/ND/ST/SD/STU/STV/STQ/HT/HTV/HTU/HTQ
V-CQ263/NT/ND/ST/SD/STU/STV/STQ/STQB/HT/HTV/HTU/HTQ
V-CQ273/NT/ND/ST/SD/STU/STV/STQ/HT/HTV/HTU/HTQ
2
8
2
1
1
9
3
4
3
5
27
2
Information for your
Using
safety
maintenance
safety,use
appliance.
This appliance complies
of
Fit the
the
?
2-position head (6) is equipped with a
pedal (7) which allows you to alter its
position according to the type of floor to be
The
cleaned.
Voltage Directive-89/336EEC -EMC
Hard floor
use
the
Directive.
position (tiles, parquet
floors...). Press on the pedal to lower the
appliance
unsupervised.
brush.
appliance if the supply
or faulty.
If the main lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent in order to avoid a hazard.
Always switch the vacuum cleaner off
Do not use the
cord is damaged
before
?
(30)
Efficient
of hard floors
cleaning
linoleum, etc.)
?
Turbine brush nozzle
changing the dust bag.
changing or cleaning the filters.
If no dustbag is inserted, the cover cannot
?
force!
Do not vacuum flammable or
substances (liquids or gases).
vacuum
-
explosive
hot ash, embers etc.
sharp objects.
?
Do not
vacuum
water or other
liquids.
?
the flexible hose
Push the end of the head (1) on the flexible
hose (2) into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the
-
Telescopic tube (4)
Push spring latch (5)
-
-
-
Pull out tube to
Release
spring
Crevice Tool
(8)
For vacuuming
inaccessible places
down the side of
in
those
i.e.
reaching cobwebs,
a
normally
sofa!
Dusting brush (9)
For vacuuming picture frames,
furniture
outlines, books and other
objects.
plug
in and
uneven
use
the power level
Adjusting
(depending
by twisting
?
slightly.
?
brush nozzle (29)
Press the button on the rear side of the
nozzle to separate the air cover.
Use the dusting brush & crevice tool to
vacuum clean the brush and fan.
supply cord to the desired
length and plug into the socket.
Press button (12) to start the vacuum
cleaner. To stop it press the button (12) again.
the tubes
Metal or plastic tube (27)
Fit together the two tubes
(31)
Pull out the
cleaner, press on the button (3)
situated on the head, then pull upwards.
?
(wood,
adjustment (32)
How to
vacuum
Assembling
the
pile carpet.
Cleaning turbine
or
How to Use
Connecting
Air
on
Slide the air control lever to the right for
long pile carpet and to the left for short
?
use
or
Hard Floor Nozzle
-
be closed. Please do not
rug position. Press
lift the brush up.
Carpet
pedal to
:
Do not
model)
head onto the end of
large cleaning
Directives:-73/23/EEC,93/68/EEC-Low
Never allow children to
on
Accessory
the tube.
following EC
with the
head and
cleaning
Nozzles (depending
Please read all the following information,
which contains important instructions for the
and
the
?
required length.
latch to lock.
4
model)
The flexible hose handle
(13)
manual air flow
which allows
you to
forward.
on
briefly
regulator (14)
has
a
reduce the suction level.
Electronic power control (15)
Suction capacity increases smoothly up to
MAX.
?Electronic
the motor filter
power control(26)
OFF:Power off MIN:Low power
The motor filter is situated inside the
MAX:Full power
appliance
Cleaning
Park-System(16)
For short breaks
during vacuuming, for
example to move a small piece of furniture
or a rug, use the
Park system
to support
the flexible hose and cleaning head.
?Slide the hook attached to the large cleaning
tool into the slot on the rear of the appliance.
Storage(17)
When you have switched off and unplugged
the appliance, press the button (11) to
automatically rewind the cord.
You
can
store your appliance in a
by sliding the hook on the
position
large cleaning
head into the
underside of the
appliance.
the dust
Changing
The
dustbag
needs
clip
on
motor
the dirt and then
vacuum
cleaner.
Changing
is
the
by tapping to
replacing it in the
the air outlet filters
Depending on the model you have chosen
your appliance is equipped with different
types of filters : foam filter or electrostatic
r(24
.
?To
change
these filters
remove
of the filter
the
compartment(23)
of the appliance.
rear
?The
bag
remove
and to clean it
foam
filter should
regularly by tapping
it to
the
cover
situated at
be
remove
cleaned
the dirt.
?
changing
window(18)
filter(22)
remove
the
when the
cleaner is set to maximum power and the
cleaner head is off the floor but the "bag full"
indicator
bag and the
change the air
motor. Each time that you
outlet filter we advise you to
move or
vertical
between the dust
completely
?Wash
the washable HEPA filter with water
at least
coloured
once a
year.
red.
Even if the
dustbag does not appear to be
full at this stage, it should be changed, as
very fine dust can clog up the pores of the
dust bag.
appliance and unplug it.
?Open the cover by pressing the hook(19)
and lifting it up until it snaps into place.
?
Turn off the
What to do if your
does not work?
Check that the
appliance
in and that the electrical
appliance is equipped with either a
paper dust bag (20) or a cloth paper (28)
or a fabric dust bag (25).
(depending on model)
appliance
is
correctly plugged
socket is working.
Your
?Take
hold of the dust
and
pull.
away.
?To refit
Remove
a
support of
(21)
bag by the handle
the bag and throw it
new
the cardboard
a
the
bag push
new bag into
until it will go
no
bag
mount
as
the
appliance
and
unplug
it.
?Check
that the tubes, flexible hose and
cleaning tool are not blocked.
?Check
that the dust
bag
is not
full.Replace
if necessary.
?Check
that the air outlet filter is not
blocked.
above.
replace it(25). Do not wash it.
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
fitted correctly.
Empty
?Stop
further.
If your appliance is fitted with a
fabric dust bag follow the same
instructions
What to do when the suction
performance reduces?
it and
5
Replace
if necessary.
http://www.lge.com/
P/No.: 3828FI2856F
Download PDF

advertising