SPECIFICATION W D Machine Washing OWNER'S MANUAL MODEL : WP-891R(S)(P) WP-970(N,Q,R)(S)(P) WP-971Q(S)(P)/WP-980Q(S)(P) WP-1050R(S)(P)/WP-1150R(S)(P) H WP-1070R/WP-1070RB Please read the Power operating instructions carefully and thoroughly before installing and operating your washing machine. This washing machine is designed and manufactured for household use only. ON SPECIFICATION LABEL source Water Level H:61 Water Pressure Less than 100kPa Dimension 820X482X986mm.(WXDXH) Weight ,M:54 For Non-Pump For Pump ,L:46 2 (1kgf/cm ) Model Model 31.5 kg 32.1 kg How to read the manufactured month and year from the label stuck back of the product. on the EX)401TW00001SerialNo. Product code Month Year Part - - - - - - (The last digit to year) Remark 90 W (Output) 40 W (Output) name WASH MOTOR SPIN MOTOR S.D. BASKET CYCLE TIMER ASSEMBLY CAPACITOR GEAR CASE ASM PLASTIC P/No. : Specification (N,Q,R) : Pulsator Type : See Through Cover Only (S) : Pump Model Only (P) 3828EY3044A 8 FEATURES CAUTION *For Pulsator Table CAUTION Installation Area Avoid rain, heater, candle light, cigarette light, bug smoker, etc. cause near WASHING COVER the machine. It may ignite deform or Use for WP-****N(S)(P) WATER SUPPLY SAFETY SELECTOR LEVER COVER-2 Hot water Switch Area on Avoid the SPIN DRYER COVER plastic part. Avoid watering switch area. It may cause electric shock or fire. OVER FLOW hot water using FILTER 50°C. It may deform plastic parts or cause malfunction. SPIN DRYER BASKET over Use for ROTATION WP-****Q(S)(P) FILTER-C EARTH WIRE (For Volatile Material Do not In volatile material such as Benzene, Gasoline, bug killer. Do not leave strong alkaline substance such as bleach inside the tub. Damage on plastic surface and rubber parts may occur. Operation Installation PULSATOR Use for WP-****R(S)(P) (See detail in Pulsator Table) POWER CORD washing machine horizontal support. it may cause vibration and noise. Avoid connecting several electric devices to single outlet. It may cause fire. 1. Water to reroute the hose Wash Program Water Supply Inlet of the washing that it is not machine as or a Timer **For pump model water faucet to feed water to the tub. Select "WASH RINSE" for washing and supply water for rinsing and "SPIN" for spin 4. sharp For washing of the washing and and "DRAIN" to drain the water out Pump rinsing Model washing and and "DRAIN" to drain the water out of Cabinet, and "OFF" to turn off the drain pump. or rinsing. Wash Program quantity Model Select "WASH RINSE" for 6. Set the program to "GENTLE","NORMAL", "STRONG" according to kinds and base under the only** of the tub. 3. Wash Timer shown in Non-Pump rinsing laundry. L L<=1m. 2 Spin For Select "WASH" to in the hose will prevent proper drainage. Make sure water is draineded smoothly by placing machine or by applying other appropriate mean. For Pump Model Drain Selector Connect here with the inlet hose from the Select the desired time for kinked; kinks Selector 5. Drain Selector shower rinse. body so Supply 2. Water Selector drain hose Push the clamp toward the the figure. For Non-Pump Model bending Wash Timer 2 Be sure to earth the washer to prevent electric shock. To reduce the risk of electric shock, do not install the washer in humid spaces. sure 6 WASH Electric Outlet Be sure to disconnect the power cord from the electric outlet before starting care and maintenance. Be 5 1 Off If the power supply cord is damaged, it must only be replaced by the manufacture or its service agent or a similarly qualified person in order to avoid a hazard. on Otherwise, Connecting the 4 Power Cord Install the plug) TUB Do not insert the hand inside the spin dryer basket while the machine is in operation (Do not let children climb on the machine or climb into the tub. Injury may occur.) use models with two prong 3 a Only* DRAIN HOSE Avoid electric exposed to snow, where humidity is high. It may electric shock. Model Heat area or Pump 3 Spin Timer Connect here with the inlet hose from the water faucet to feed water to the tub. INSTALLATION Installation Set INSTALLATION & HOW TO WASH Maintain area on cm. between Before A carpet 1. Check the washing instruction labels clothing to be washed. 2. Remove all objects from the pockets of the clothing.Objects left in the pockets may damage clothing or the washing machine (could cause the drain hose to clog). 3. After separating oiled or dyed clothing, wash. 4. For your convenience hang up the wash cover on the right or left side of the washing machine tub when not in use. must not obstruct the ventilation Install the earth wire to prevent short-circuit due to It is attached at the back of the washer. openings. Gas arrester. How to wash Earth telephone 1For wire Warning-the appliance with two-pronged plug must be grounded. (only This washer is assembled for 220V, but 220V to 110V(or 127V). Other connecting be as "OFF" Drain Selector below diagram Set the desired wash 6 time. earthing-only installing it in an area where earthing is not possible, purchase 4Put of Wash 7 When washing is finished, locate the drain selector to "DRAIN" position and drain the water out. a For Non-Pump Model For Pump Off W R time with the spin timer. Short-circuit breaker Wash Timer Drain Selector Drain Selector plate 5 Interim rinse spin rinse prior to regular rinsing helps removing sudsy water from improve rinsing efficiency. Also is helpful to water saving. After washing. 2 Move the laundry into the spin dryer basket. Place the safety cover horizontally on the laundry. Set the water selector to "SPIN". 4 SPIN rinse, move laundry Water Selector the After interim Handkerchief Cotton Bath towel Cotton Shirt Mixed fabric Socks (1 pair) Mixed fabric into the rinsing. Pajama (shirt 3 spin flow Timer into the Type Cotton Workclothes Mixed fabric Blouse Mixed fabric Safety cover laundry lightly. 3. Place the safety cover horizontally over the laundry. 4. Close the spin dryer cover. the clothes Wash evenly, NORMAL soiled cotton and the STRONG CARE flow filter and take out the rotation filter-C 2. Pull the overflow filter forward from the wash tub in the direction of the 3. Turn the net 4. Use a brush over or by pulling arrow. and rinse in water. hand to remove Before 3 5 6 0.5 M 4.0 H L M H 42~46 5.0 54 51~55 61 56~60 4.0 46 42~46 5.0 54 51~55 61 56~60 4.0 46 42~46 5.0 54 51~55 61 56~60 ~ ~ ~ 5.0 0.5 ~ ~ 4.0 ~ 5.0 detergent (g) 46 ~ 5.0 (l) 4.0 ~ 4.0 Water Amount of ~ dry laundry. on a general synthetic detergent. spinning mest be operated together, starting washing and spinning be done at the same time to cope with EMC requirement. on No draining For Non-Pump Model Checking point Is the power cord firmly plugged in? Is the timer turned to a suitable point except "OFF" ? Is there any clothing dropped between the basket and tub? Is the spin dryer cover closed? Is the laundry gathered to one side of the spin dryer basket? Is there lint stuck in the plunger valve? Is the end of the drain hose guide located at an exceed height? For Is the drain pump Spin dryer not operate, basket does operate. A 6 0.5 Amount of Requesting Service Motor does not 4 min. laundry (kg) H L is based amount is based Problem 6. Insert the rotation filter-C back into the overflow filter. 2 10~15 L M Amount of TROUBLESHOOTING GUIDE all of the lint which has adhered to the overflow filter. 5. Insert the overflow filter back into the wash tub. 1 min. laundry Detergent If washing and operation shall Overflow filter & Rotation filter-C over 5~10 linen Amount of 1. Lift up the area A of the in direction as shown. min. Knits Very and then 2~5 GENTLE Linen excessively, stop resume spinning. Wash Water Selector Time Level Cotton, basket is off-balance and vibrates spin dryer spinning, rearrange of Synthetics, Silk, Woolen, spin down If the Cotton pants) Winter undershirt fabric basket. 2. Put the and Weight per piece 150g(53oz) 50g(1.8oz) 300g(10.6oz) 200g(7.1oz) 50g(1.8oz) 500g(17.6oz) 600g(21.2oz) 800g(28.2oz) 200g(7.1oz) TABLE 2. GUIDE FOR WASHING spinning laundry evenly of fabric Type Cotton the wash tub for clothing Under shirt spin Set the desired Spin Note for of Type appropriately. dryer safety cover horizontally on the laundry. spin TABLE 1. WEIGHT GUIDE FOR CLOTHES 1. Put the Place the wire REFERENCE 1 8Spinning Set the desired HOW TO RINSE & HOW TO SPIN and in the spin dryer basket. Move the laundry into the spin dryer basket. Put the laundry down Earth 4 laundry Model connect it to the outlet. 75cm spin Program lightly. wire Interim quantity of the laundry. (Refer to Tabel 2) into the wash tub. And add water to the desired water level which you want. short-circuit breaker Earth Earth copper to the kinds and the When outlet. "NORMAL" or "STRONG" according appropriate amount detergent and the laundry WASH changed from 5Select program to "GENTLE", mark. That is because clothes can absorb adequate amount of water and water will not short. position. Set the water selector to "WASH" 2 the wash 3 level of tap voltage) Connect to the deep under the wet ground. Model Pump Set Drain Selector method wire to the earth copper plate, bury it at least 75cm For Water Selector and follow the the earth RINSE" position. voltage. earthing After source as "WASH Model water supply and fill water till your desired Open plug for dual can Non-Pump Set Insert the power plug into the outlet. Before connecting the power plug, check if the voltage setting of the washer matches the outlet voltage. If AC outlet with ground terminal is used, grounding is not needed. If not, never forget earthing (earthing method above). The appliance must be positioned so that the plug is accessible. Voltage Change Set the drain selector Off the power Connecting pipe r connecter, etc. to convert the on current and electric shock. leaking Connect it to the metal water pipe. If the water pipe is made of plastic, it does not have the earth effect. Do not connect the earth wire to the Check your electrical washing the earth wire Connecting pipe, lightning than 10 the side of drain hose and the wall. flat and firm floor. Incorrect installation may course severe noise and break down. gas more Pump Model 7 operated?