LG | WP-570N | LG WP-570N Owner’s Manual

SPECIFICATIION
W
D
Machine
Washing
OWNER'S MANUAL
MODEL
:
WP-570N(P)/WP-580N(P)
WP-590N(P)/WP-680N(P)
H
Please read the
Power
operating instructions carefully
and thoughly before in stalling and operating
your washing machine.
This washing machine is designed and manufactured
for household use only
ON SPECIFICATION LABEL
source
Water Level
H:34
Water Pressure
Less than 100kPa
Dimension
686 XX
412
Weight
(1kgf/cm 2)
D
835mm.(W XX
H)
For
Non-Pump
For
Pump
Model
Model
17
kg
18.5
kg
How to read the manufactured month and year from the label stuck
back of the product.
on
the
EX)401TW00001
Serial No.
Product code
Month
Year
Main service
service call.
Part
-
-
-
-
-
(The
last
part list
:
digit
to
year)
Refer to below listed
part
name
when you need
Remark
85-90 W
25-40 W
name
WASH MOTOR
SPIN MOTOR
WASH TIMER ASSEMBLY
CAPACITOR
P. SHAFT ASM.
P/No.
:
3828EY3032A
8
FEATURES
CAUTION
*
CAUTION
Installation Area
Avoid
rain,
is high. It may
electric shock.
WASHING
COVER
heater, candle light,
cigarette light, bug smoker,
etc.
cause
Model
SAFETY
COVER-2
Avoid electric
exposed to snow,
where humidity
Pump
near
the machine.
It may ignite
deform
CONTROL
or
SPIN DRYER
COVER
PANEL
plastic part.
Avoid watering
switch area.
It may cause
electric shock
or fire.
on
Avoid
the
using
SPIN DRYER
BASKET
FILTER
hot water
50°C. It may
deform plastic parts
or cause malfunction.
over
Volatile Material
Do not
OVERFLOW
Hot water
Switch Area
In
volatile material such as
Benzene, Gasoline, bug killer.
Do not leave strong alkaline substance
such as bleach inside
the tub. Damage on
plastic surface and
rubber parts may occur.
Installation
EARTH WIRE
TUB
STRAINER
Operation
Do not insert the hand inside the spin
dryer basket while the machine is in
operation (Do not let children climb on
the machine or climb into
the tub injury may accur.)
use
SAFETY
COVER-1
PULSATOR
POWER CORD
1
2
4
3
Power Cord
Off
Install the
a
washing machine
horizontal support.
If the power supply cord is damaged, it
must only be replaced by the
manufacture or its service agent or a
similarly qualified person in order to
avoid a hazard.
on
Otherwise,
it may cause
vibration and noise.
Be
sure
from the electric outlet before
care
4
Wash Timer
1
starting
and maintenance.
Non-Pump
Be
sure
bending
Pump
Spin
Pump
Tim er
Model
Only*
4
3
Off
4
Wash Timer
Drain Selector
Spin
Tim er
Model
to reroute the hose
so
that it is not
kinked; kinks
or
sharp
WATER INLET
in the hose will
prevent proper drainage.
Make sure water is draineded smoothly by placing
machine or by applying other appropriate mean.
For
2
Avoid connecting several electric
devices to single outlet. It may cause
fire.
Be sure to earth the washer to prevent electric shock.
To reduce the risk of electric shock, do not install the
washer in humid spaces.
For
Drain Selector
*For
Electric Outlet
to disconnect the power cord
Model
L must less than 1
a
base under the
WASH TIMER
DRAIN SELECTOR
SPIN TIMER
Entry point of water
Select the desired
Select "WASH
Used to select the
source.
time for
RINSE" for washing
desired time for
and
spining.
washing
rinsing.
or
rinsing,
and
"DRAIN" to drain
L
the washer from the
m.
1
cabinet
2
.
2
Only
DRAIN HOSE
Heat
area
or
For
3
3
4
*
INSTALLATION
Installation
Set
INSTALLATION & HOW TO WASH
Maintain
area
than 10
cm
between
A
Incorect installation may course
severe noise and break down.
carpet
must not obstruct the
ventilation
the earth wire and the power
Connecting
the side of drain hose and the wall.
flat and firm floor
on
more
Install the earth wire to prevent short-circuit due to
openings.
leaking
current and electric shock.
It is attached at the back of the washer. Connect it to the metal water
is made of
pipe
pipe, lightning
Connecting
the drain hose
Push the
clamp toward the body
of the washing machine as shown
in the figure.
?
outlet of the
at the back
plunger valve located
side of the washing
machine.
Gas
for Dual
4.
5.
the
back
remove
connecting
cover
Connect to the
When
installing it in an
area where earthing is
not possible, purchase
earthing-only outlet.
1. Check the washing instruction labels
Earth
Short-circuit breaker
Earth
wire
75cm
Earth copper
plate
Washing
1
clothing to be washed.
2. Remove all objects from the pockets of the clothing.Objects left in the pockets may
damage clothing or the washing machine (could cause the drain hose to clog).
3. After separating oiled or dyed clothing, wash.
4. For your convenience hang up the wash cover on the right or left side of the washing
on
a
short-circuit breaker
connect it to the outlet.
from 220V to
washing
machine tub when not in
the earth
wire
For Non
Before
wire
method
earthing
deep under the wet
ground.
110(127)V, disconnect the coupler
marked "220V" and connect the coupler marked "110(127)V", to change the voltage
setting from 110(127)V to 220V, disconnect the coupler marked "110(127)V" and
connect the coupler marked "220V".
Cover the couplers with the bag and reattach the back cover.
Be sure to indicate the new voltage setting on the
"Present Voltage" label for future reference.
voltage setting
Earth
WARNING-THIS APPLIANCE MUST BE EARTHED.
Voltage)
the power cord from the electric outle, Use screwdriver to
2. Remove the bag covering the lead wire couplers.
change
telephone
wire to the earth copper
plate, bury it at least 75cm
Unplug
3. To
pipe
of the washer matches the out
voltage setting
let voltage.
After
1.
arrester.
Insert the power plug into the outlet.
Before connecting the power plug, check if the
Other
Voltage Change (Only
If the water
connecter, etc.
Connect the drain hose to the
?
pipe.
it does not have the earth effect.
plastic,
Never connect the earth wire to the
gas
plugh
the
Pump
Caution
:
Don't rotate knob
over on
Fill water till water level
Set the drain selector to
"WASH RINSE" posi-
2 mark"H".That is because 3
clothes
absorb
can
adequate
amount of
water and water will not
short.
For
(
curve.
)
Model
tion.
use.
spot
Put the
appropriate
amount of detergent and
the laundry into the wash
tub. And add water to the
desired water level which
you want.
Model
Pump
Off
H
???
?
Drain Selector
r
??
4
5
REFERENCE & AFTER FINISHING
HOW TO WASH & HOW TO RINSE
TABLE 1. WEIGHT GUIDE FOR CLOTHES
4
Set the desired wash
time.
When
washing
is
5 finished, locate the
Non-Pump
Model
Pump
Model
Type
Off
drain selector to
"DRAIN"
position
of
Cotton
Handkerchief
Cotton
Bath towel
Cotton
Shirt
Mixed fabric
drain the water out.
Drain Selector
Interim
Interim
spin
laundry
and
1
spin
Drain Selector
rinse
prior to regular rinsing helps removing sudsy water from
improve rinsing efficiency. Also is helpful to water saving.
After washing.
Move the
laundry into
the spin dryer basket.
Place the safety cover
horizontally on the
laundry.
Socks
rinse
2
Set the desired spin
flow
appropriately.
3
After interim
rinse,
move
laundry
the
into the
rinsing.
1.
2
Mixed fabric
Amount of water
(Maximum Level)
Amount of
34L
laundry from the spin dryer
spin dryer cover.
detergent
34g
basket and
then
put it back
to "OFF" )
Disconnect the power cord from the electrical outlet.
Clean the washing machine.
Timer
For Pump Model
Only
Ensure without fail the drain selector is turned to "OFF" Position after
using
If washing and spinning must be operated together, starting washing and
spinning operation
HOW TO SPIN
dryer
Blouse
(For Pump Model Only : and
6.
shall be done at the
same
time to cope with EMC
requirement.
TROUBLESHOOTING GUIDE
Safety cover
spinning
into the
Mixed fabric
If there is water in the wash tub, set the drain selector
to "DRAIN" in order to drain it out.
.
5.
laundry evenly
Workclothes
close the
4.
1. Put the
Cotton
Cotton
Remove the
4
Note for
Winter undershirt
H
3.
Spin
Mixed fabric
Weight per piece
150g(53oz)
50g(1.8oz)
300g(10.6oz)
200g(7.1oz)
50g(1.8oz)
500g(17.6oz)
600g(21.2oz)
800g(28.2oz)
200g(7.1oz)
TABLE 2. GUIDE FOR WASHING
spin
wash tub for
(1 pair)
Pajama (shirt and pants)
Water level
the
of fabric
Type
Under shirt
and
Wash Timer
clothing
Before
Requesting Service
Problem
spin
Motor does not
basket.
laundry down lightly.
3. Place the safety cover horizontally
over the laundry.
4. Close the spin dryer cover.
operate,
2. Put the
Spin dryer
not
If the
spin dryer basket is off-balance and vibrates excessively, stop
spinning, rearrange the clothes evenly, and then resume spinning.
the
operate.
Is there lint stuck in the
No
draining
For Non-Pump
For
6
basket does
Pump
Checking point
Is the power cord firmly plugged in?
Is the timer turned to a suitable point except "OFF" ?
Is there any clothing dropped between the basket and tub?
Is the spin dryer cover closed?
Is the laundry gathered to one side of the spin dryer basket?
Model
Model
plunger valve?
Is the end of the drain hose
Is the drain
guide
pump operated?
7
located at
an
exceed
height?
Download PDF

advertising