LG | WP-750N | LG WP-750N Owner’s Manual

SPECIFICATIION
W
Machine
Washing
D
OWNER'S MANUAL
MODEL
H
:
WP-600N(P)/WP-601N(P)
WP-605N(P)/WP-610N(P)
WP-620N(P)/WP-650N(P)
WP-680N(P)/WP-690N(P)
WP-700N(P)/WP-701N(P)
WP-750N(P)
Please read the
Power
operating instructions carefully
and thoughly before in stalling and operating
your washing machine.
This washing machine is designed and manufactured
for household use only
ON SPECIFICATION LABEL
source
Water Level
H:50
Water Pressure
Less than 100kPa
Dimension
700 XX
430
Weight
(1kgf/cm 2)
D
900mm.(W XX
H)
For
Non-Pump
For
Pump
Model
Model
19
kg
20.5
kg
How to read the manufactured month and year from the label stuck
back of the product.
on
the
EX)401TW00001
Serial No.
Product code
Month
Year
Main service
service call.
Part
-
-
-
-
-
-
(The
last
part list
:
digit
to
year)
Refer to below listed
part
name
when you need
Remark
90W
25-40 W
name
WASH MOTOR
SPIN MOTOR
S.D.BASKET
CYCLE TIMER ASSEMBLY
CAPACITOR
GEAR CASE ASSEMBLY
PLASTIC
P/No.
:
3828EY3038A
8
FEATURES
CAUTION
*For
CAUTION
Installation Area
Avoid
rain,
heater, candle light,
cigarette light, bug smoker,
etc.
cause
near
WASHING
SPIN DRYER
COVER
COVER
the machine.
It may ignite
deform
WATER SUPPLY
or
SELECTOR LEVER
plastic part.
SAFETY
OVER FLOW
COVER-2
FILTER
Hot water
Switch Area
Avoid watering
switch area.
It may cause
electric shock
or fire.
on
Avoid
the
hot water
using
SPIN DRYER
BASKET
50°C. It may
deform plastic parts
or cause malfunction.
over
EARTH WIRE
(For models with
two prong plug)
ROTATION
Volatile Material
Do not
In
volatile material such as
Benzene, Gasoline, bug killer.
Do not leave strong alkaline substance
such as bleach inside
the tub. Damage on
plastic surface and
rubber parts may occur.
FILTER-C
Operation
Do not insert the hand inside the spin
dryer basket while the machine is in
operation (Do not let children climb on
the machine or climb into
the tub injury may accur.)
use
Installation
washing machine
horizontal support.
POWER CORD
2
Electric Outlet
to reroute the hose
body
so
of the
Avoid connecting several electric
devices to single outlet. It may cause
fire.
machine
kinked; kinks
as
or
prevent proper drainage.
Make sure water is draineded smoothly by placing
machine or by applying other appropriate mean.
For Pump Model
m.
Off 0
1
12
6
4
2
Supply
Inlet
3
Wash Timer
Wash
Program
Drain Selector
Spin Timer
6
Connect here with the inlet hose from the
water faucet to feed water to the tub.
5.
Timer
Spin
Connect here with the inlet hose from the
water faucet to feed water to the tub.
or
6. Water Selector
Select "WASH" to
washing and
Set the program to "GENTLE","NORMAL",
"STRONG" according to kinds and
supply water for
rinsing and "SPIN" for spin
shower rinse.
quantity of the laundry.
sharp
base under the
For
L
Non-Pump
For
rinsing
Select "WASH RINSE" for washing and
rinsing
Pump
Model
Select "WASH RINSE" for washing and
Model
and "DRAIN" to drain the water out
and "DRAIN" to drain the water out
of Cabinet, and "OFF" to turn off the
drain pump.
of the tub.
2
Off Wash Rinse Drain
5
Water Selector
Only*
5
3
4. Drain Selector
a
Strong
Model
Pump
15
rinsing.
3. Wash Program
shown in
Normal
4
9
Select the desired time for washing
in the hose will
L must less than 1
Gentle
2. Wash Timer
washing
that it is not
WASH
1. Water
drain hose
Push the clamp toward the
the figure.
For Non-Pump Model
3
Off 0
Be sure to earth the washer to prevent electric shock. To reduce
the risk of electric shock, do not install the washer in humid spaces.
bending
PULSATOR
If the power supply cord is damaged, it
must only be replaced by the
manufacture or its service agent or a
similarly qualified person in order to
avoid a hazard.
Be sure to disconnect the power cord
from the electric outlet before starting
care and maintenance.
sure
PULSATOR FIXING
SCREW
1
on
it may cause
vibration and noise.
Be
(Cabinet)
*For
Otherwise,
Connecting the
TUB
Power Cord
Install the
a
Only*
DRAIN HOSE
Avoid electric
exposed to snow,
where humidity
is high. It may
electric shock.
Model
Heat
area
or
Pump
3
INSTALLATION
Installation
Set
INSTALLATION & HOW TO WASH
Maintain
area
flat and firm floor
Incorect installation may course
severe noise and break down.
A
carpet
between
Before
washing
1. Check the washing instruction labels
clothing to be washed.
2. Remove all objects from the pockets of the clothing.Objects left in the pockets may
damage clothing or the washing machine (could cause the drain hose to clog).
3. After separating oiled or dyed clothing, wash.
4. For your convenience hang up the wash cover on the right or left side of the
washing machine tub when not in use.
openings.
arrester.
current and electric shock.
leaking
Gas
pipe
How to wash
Earth
telephone
1
wire
Warning-the appliance with two-pronged plug
must be
grounded.
Set the drain selector
For
Non-Pump
Set
Model For
the power
position.
(only
This washer is assembled for 220V, but
220V to 110V(or 127V).
to convert
Other
connecting
be
4Put
of
below
diagram
Set the desired wash
6 time.
earthing-only
installing it in an
area where earthing is
not possible, purchase
outlet.
amount
7
a
3
15
For
Non-Pump
Model
For
Wash Rinse Drain
1
Model
9
Drain Selector
Drain Selector
TABLE 1. WEIGHT GUIDE FOR CLOTHES
rinse
prior to regular rinsing helps removing sudsy water from
improve rinsing efficiency. Also is helpful to water saving.
2
Set the water
selector to "SPIN"
4
SPIN
Set the desired
rinse,
Type
the
After interim
move
laundry
Water Selector
3 spin flow
rinsing.
of fabric
Type
Handkerchief
Cotton
Bath towel
Cotton
Shirt
Mixed fabric
Socks (1 pair)
Mixed fabric
into the
wash tub for
clothing
Cotton
the
Pajama (shirt
1
5
of
Under shirt
spin
Off 0
and
Weight per piece
150g(53oz)
50g(1.8oz)
300g(10.6oz)
200g(7.1oz)
50g(1.8oz)
500g(17.6oz)
600g(21.2oz)
800g(28.2oz)
200g(7.1oz)
Cotton
pants)
Winter undershirt
Cotton
Workclothes
Mixed fabric
Blouse
Mixed fabric
2
4
3
Spin
Note for
Timer
TABLE 2. GUIDE FOR WASHING
spinning
laundry evenly
into the
Type
spin
basket.
2. Put the
down
spin dryer basket is off-balance and vibrates excessively, stop
spinning, rearrange the clothes evenly, and then resume spinning.
CARE
Detergent
Overflow filter & Rotation filter-C
over
over
arrow.
flow filter and take out the rotation filter-C
by pulling
remove
Before
Motor does not
operate,
6. Insert the rotation filter-C back into the overflow filter.
1
2
3
4
5
6
Spin dryer
not
basket does
operate.
A
6
0.5~2
5~10
min.
2~3
10~15
min.
on
on
-
kg
-
kg
3
H
kg~
30
30g
40
40g
50
50g
dry laundry.
a general synthetic detergent.
Requesting Service
Problem
all of the lint which has adhered to the overflow filter.
5. Insert the overflow filter back into the wash tub.
2~5
min.
is based
amount is based
laundry
Amount of Water Amount of Amount of
Level
Water
laundry
detergent
TROUBLESHOOTING GUIDE
and rinse in water.
hand to
NORMAL
soiled
STRONG
cotton and linen
Amount of
2. Lift up the area A of the
in direction as shown.
Selector
Very
the
1. Pull the overflow filter forward from the wash tub in the direction of the
Wash
Time
Woolen,
Cotton, Linen
If the
or
of fabric
Wash
Synthetics, Silk, GENTLE
Knits
Safety cover
laundry
lightly.
3. Place the safety cover horizontally
over the laundry.
4. Close the spin dryer cover.
brush
safety cover
horizontally on the
laundry.
REFERENCE
appropriately.
a
Place the
5
rinse
laundry into
the spin dryer basket.
Place the safety cover
horizontally on the
laundry.
4. Use
8Spinning
plate
spin
3. Turn the net
in the spin
dryer basket.
Move the laundry into
the spin dryer basket.
Put the laundry down
time
with the
spin timer.
Wash Timer
Move the
dryer
Program
spin
6
12
Short-circuit breaker
After washing.
1. Put the
Strong
Set the desired
Earth
HOW TO RINSE & HOW TO SPIN
and
Pump
Off Wash Rinse Drain
4
laundry
Normal
lightly.
75cm
spin
Gentle
Wash
Off 0
wire
Interim
quantity of the laundry.
(Refer to Tabel 2)
When washing is finished,
locate the drain selector to
"DRAIN" position and drain
the water out.
short-circuit breaker
connect it to the outlet.
Earth
Inter
to the kinds and
When
wire
Earth copper
the
"NORMAL" or
"STRONG" according
into the wash
tub. And add
water to the
desired water
level which
you want.
WASH
changed from
5Select
appropriate
detergent and the laundry
voltage)
Connect to the
deep under the wet
ground.
Drain Selector
the wash
program to "GENTLE",
mark "H". That
is because
clothes can
absorb adequate
amount of water
and water will not short.
Off Wash Rinse Drain
Set the water selector
to "WASH"
2
method
wire to the earth copper
plate, bury it at least 75cm
3
Water Selector
and follow the
the earth
as "WASH RINSE"
position.
Drain Selector
voltage.
earthing
After
source
for dual
can
Model
water supply and
fill water till water level
Open
plug
Insert the power plug into the outlet.
Before connecting the power plug, check if the voltage
setting of the washer matches the out let voltage.
If AC outlet with ground terminal is used, grounding is not
needed. If not, never forget earthing (Refer earthing method above).
The appliance must be positioned so that the plug is accessible.
Voltage Change
Pump
Set
as "OFF"
Wash Rinse Drain
Check your electrical
the
r
connecter, etc.
Connecting
on
the earth wire
Connect it to the metal water pipe.
If the water pipe is made of plastic,
it does not have the earth effect.
Do not connect the earth wire to the
pipe, lightning
cm
must not obstruct the
ventilation
Install the earth wire to prevent short-circuit due to
It is attached at the back of the washer.
gas
than 10
the side of drain hose and the wall.
on
Connecting
more
Checking point
Is the power cord firmly plugged in?
Is the timer turned to a suitable point except "OFF" ?
Is there any clothing dropped between the basket and tub?
Is the spin dryer cover closed?
Is the laundry gathered to one side of the spin dryer basket?
No draining
For Non-Pump Model
Is there lint stuck in the
For
Is the drain pump
Pump Model
Is the end of the drain
7
plunger valve?
hose guide located
operated?
at
an
exceed
height?
Download PDF