LG | GN-V191RL | LG GN-V191RL Owner’s Manual

BEFORE CAL
LIN
LL
ING
G
FO
FOR
R SERV
RVIC
ICE
P/No.: 3828JP8003P
1. Select a good locations, place your refrigerator in a location
that suits your working convenience.
2. Avoid placing the unit in a narrow recess or near any heat
sources, direct sunlight or moisture.
3. Your refrigerator must adequate air circulation. If your
refrigerator is placed in a recessed area in the wall, allow at
least a clearance of 10 inches or more above and 1 inch or
more distance from the wall. There must be proper air
circulation around your refrigerator to keep it operating
efficiently. For maximum circulat ion, the refrigerator should
be elevated 1 inch from the floor, especially when it carpeted.
LAMP REPLACEMENT
1. Unplug the power cord from the outlet
2. Open the cover lamp
3. Turn the lamp counterclockwise
4 . Assemble in reverse order of disassembly.
Replacement bulb must be the
same specification as original.
ANTI CONDENSATION PIPE
The outside wall of refrigerator cabinet may some times get warm, especially
just after installation. This is not a trouble of refrigerator, but because of the anti
condensation pipe. It is pumping hot freon gas around the cabinet to prevent
“sweating” on the outer wall of the cabinet.
4. To avoid any vibrations, the unit is to be set leveled. If
needed, adjust the leveling screws to compensate
unevenness or the floor. It should be leveled side to side.
The front should be slightly higher than to rear to aid in door
closing. Leveling screws can be turned easily tipping the
cabinet slightly and adjustments can be made with your
fingers to raise or lower the cabinet.
ABOUT GROUNDING(EARTHING)
In the event of an electric short circuit, grounding
(earthing) reduces the risk of electric shock by providing an escape wire for the electric current.
DO NOT USE AN EXTENSION CORD
5. Clean your refrigerator thoroughly and wipe off all dust accumulated during transportation.
6. Fit up the accessories such ice tray, freezer shelf, etc. to their proper places, referring to
the “FEATURE CHART” section. They are packed together to prevent possible damages
during transportation.
7. Connect the power supply cord (or plug) to the outlet, don’t double appliances on the same
outlet.
8. Leave your refrigerator for an hour or so, and check the flow of cold air in the freezer
compartment. Now. Your refrigerator is ready for use.
If possible, connect the refrigerator to its own individual electrical outlet to prevent it and other appliances or household lights from causing an overload that could cause a power outage.
In order to prevent possible electric shock, this
appliance must be grounded.
The refrigerator-freezer should be so positioned
that the supply plug is accessible for quick
disconnection when accident happens.
Improper use of the grounding plug can result in an
electric shock. Consult a qualified electrician or service person if the grounding instructions are not
completely understood, or if you have doubts on
whether the appliance is properly grounded.
SUPPLY CORD REPLACEMENT
DO NOT MODIFY OR EXTEND THE
POWER CORD LENGTH
ACCESSIBILITY OF SUPPLY PLUG
If the supply cord is damaged, it must be replaced
It will cause electric shock or fire.
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
VERY DANGEROUS ATTRACTION
This appliance must be grounded(earthed).
An empty refrigerator can be a dangerous
attraction to children. Remove gaskets, latches,
lids or the entire door from your unused
appliance,or take some other action to make it
harmless.
DON'T WAIT! DO IT NOW!
NEVER STORE EXPLOSIVES AND CHEMICALS
7
FEATURE CHART
It is important that your refrigerator be keep clean to prevent
undesirable odor. Spilled food should be wiped up immediately,
since most of them may acidify and stain plastic surface if
allowed to settled.
Never use metallic scouring pads, brushes, coarse abrasive
cleaners or strong alkaline solutions on any surface.
Control Box/
Defrost Button
Before you begin cleaning, however, remember that damp
objects will stick or extremely cold surface with wet, or damps
hands.
EXTERIOR - Use a lukewarm solution of mild soap or detergent
to clean, the durable finish of your refrigerator. Wipe with a
clean, damp cloth and then dry.
INTERIOR - Regular cleaning of the interior and interior parts is
recommended. If you have the No Frost Model which defrosts
completely automatically, First open the both doors and leave
them open during the entire cleaning process. Disconnect
power supply and remove food and all compartment shelves,
storage tray etc. was entire freezer-refrigerator compartments
with a baking soda solutions. Rinse and dry.
FINAL - Place all parts and accessories to normal position and
re-adjust temperature control to you desired condition.
MAGNETIC DOOR GASKET - Wash with soft baking soda or soft detergent or rinse
and dry.
WARNING
Always remove power cord from the wall outlet cleaning the vicinity of
electrical parts (lamp, switches, control, etc) Wipe up excessive moisture with
sponge or cloth to prevent water of liquid from getting into an electrical part
and causing a electrical shock.
Do not use flammable or toxic cleaning liquids.
Egg Pocket
Freezer Room
Luxurious
Cover Lamp
Ice Tray
Can Pocket
Chiller Room
for fresh meat
Shelves
Detachable for
maximum efficiency
Bottle Pocket
Vegetable Box
Used to keep fruits
and vegetables,
etc.
keep fresh and crisp.
Door Magnetic
Gasket
Adjustable Leg
To compensate
the unevenness
of the floor.
WARNING
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
DISPOSAL OF THE OLD APPLIANCE
TE
NO
All parts shown may not be included with every model.
This appliance contains fluid (refrigerant, lubricant) and is made of parts and
materials which are reusable and/or recyclable .
All the important materials should be sent to the collection center of waste
material and can be reused after rework (recycling). For take back, please
contact with the local agency.
6
3
TEMPERATURE CONTROL
Your refrigerator has six option of thermo control to meet
individual requirement. Initially please turn at middle
position (2) if you want colder temperature turn to clockwise
and turn to counter clockwise to gain warmer temperature.
Do not turn at range 0 - 1 because it is not your thermo
control operating range.
TEMPERATURE
CONTROL
ICE MAKING
To make ice cubes, fill the ice cube tray with water to
.
slightly below the rim and place it in the freezer.
To remove ice cubes, hold the tray at its end and twist
gently.
To remove ice cubes easily, run water
on the tray before twisting.
It is necessary to regularly defrost your refrigerator in order to ensure efficient
operation. The frost on the surface of evaporator should not exceed 6 mm before
defrosting.
To defrost, press the defrosting button.
Remove food from the evaporator before you start defrosting operation.
When defrosting complete, defrosting button will return to normal position
automatically. Remove the drip tray, empty water, dry and put it back to its normal
position.
Download PDF

advertising