LG | WP-1410R | LG WP-1410R Owner’s Manual

10.0
8.0
330
185
Rev. : 01
Install the earth wire to prevent short-circuit due to leaking current and electric shock.
It is attached at the back of the washer. Connect it to the metal water pipe.
If the water pipe is made of plastic, it does not have the earth effect.
Do not connect the earth wire to the gas pipe, lightning arrester, telephone connecter, etc..
*Warning - the appliance with two pronged plug must be grounded.
Insert the power plug into the outlet.
Before connecting the power plug, check if the voltage setting of the washer matches the outlet voltage.
If AC outlet with ground terminal is used, grounding is not needed. if not, never forget earthing.
The appliance must be positioned so that the plug is accessible.
Wash Rinse
Wash Rinse
Drain
Connecting to the
earthing-only outlet.
When installing it in an area
where earthing is not possible,
purchase a short-circuit
breaker connect it to the outlet.
ot
a te
Normal
Gentle
’t r
o ta
Don’t rotate
Off
For Non-Pump Model
Be sure to reroute the hose so that it is not kinked, kinks or sharp
bending in the hose will prevent proper drainage.
Make sure water is drained smoothly by placing a base under the
machine or by applying other appropriate mean.
For Pump Model
L <= 1 m.
Do
n
Off
’t r
te
ota
1
5
2
4
3
Do
n
Connecting the drain hose
Connect the drain hose to the outlet of the plunger valve located at the back side.
Push the clamp toward the body of the washing machine as shown in the figure.
Drain
Strong
n
Do
After connecting the earth wire
to the earth copper plate, bury
it at least 70cm deep under
the wet ground.
r
n’t
Do
This washer is assembled for 220V, but can be changedfrom 220V to 110V ( or 127V).
Check your electrical source and follow the diagram below to convert voltage.
te
o ta
’t r
3
15
6
12
9
te
Download PDF

advertising