LG | LPC12W | LG LPC12 Owner’s Manual

LGEIL_LPC12_ENG_MFL39617918
ENGLISH
MODEL : LPC12W
LPC12
There is so much your MP3/CD CASSETTE RECORDER can do
Play CDs
Go to page 4
Play cassettes
Go to page 5
Record from a CD
or radio to cassette
Go to page 5
CONTENTS
PAGE
Power Source
Listening to the Radio
Listening to CDs
Listen to cassette tapes
Recording
Safety Precaution
Troubleshooting
Specifications
2
3
4
4-5
5
5
6
7
7
PORTABLE MP3/CD CASSETTE RECORDER ] OWNER’S MANUAL
Listening to the Radio
Go to page 4
Power Source
Battery Installation
1. Press and open the battery cover.
2. Put six “C” (R14) batteries (not supplied) into the compartment making sure the 3 and # are correctly positioned.
3. Replace the battery cover.
Adjusting the voltage - OPTIONAL
If your unit is equipped with a voltage selector at
the bottom side, be sure to set it to your local power
supplied before connecting the AC power cord.
AC Power Cord Connection
1. Before connecting the AC power cord, check that
the operating voltage of your unit is identical with
the voltage of your local power supplied.
2. Connect one end of the AC power cord (supplied)
to the AC IN socket located at the backside of your
unit.
3. Plug the other end into the wall outlet.
Note:
• Unplug the AC power cord from the wall outlet if you do not to use for
an extended period of time.
• To avoid damage from possible battery leakage, remove the batteries
if you do not plan to use the unit for an extended period of time.
• When the batteries are weak, replace all the batteries with new ones.
• During the AC power cord connect to the wall outlet, the batteries are
not worn out.
PORTABLE MP3/CD CASSETTE RECORDER ] OWNER’S MANUAL
3
Listening to the Radio
Listening to CDs
ON RECORDER
1. Select either AM or FM
2. Select the radio station
FUNCTION SWITCH
TUNING dial
Listening to the Radio - more you can do
Setting STEREO/MONO
• Set the RIF/FM MODE SWITCH to “RIF” when a lot of noise occurs in AM
mode.
• Set the RIF/FM MODE SWITCH to “FM ST.” if you want to listen to FM
broadcasting on stereo mode.
• Set the RIF/FM MODE SWITCH to “FM MONO” when a lot of noise
occurs in FM mode. Selecting this function will substantially reduce the
noise. However the stereo effect will be lost.
Adjust the antenna to get more clear reception.
• AM antenna : This antenna is built within the unit so rotate the unit
for better reception.
• FM antenna : Pull the telescopic antenna out and adjust the angle
and direction for better reception.
To turn off the radio
Set FUNCTION SWITCH to TAPE or CD (OFF) to turn off your unit.
ON RECORDER
1. Select the CD function
2. Open the CD drawer
3. Insert the CD
Label facing up.
4. Close the CD drawer
The display will show the total number of
tracks (files)
5. Start the CD playing
6. To stop a CD playing
FUNCTION SWITCH
Z PUSH OPEN
B/[]
x
Listening to CDs - more you can do
Pause or restart a CD
Press B/[] (PLAY/PAUSE) during playback.
When a track is paused “[]” will flash in the display.
Press this button again to resume play.
Skipping a Track
• Press > to go to the next track (file).
• When the . is pressed once midway through a track (file), the player
returns to the beginning of that track (file). When it is pressed again, a
track is skipped each time the button is pressed.
• When you press +10, next 10 tracks (files) are skipped in a lump and the
next 11th track (file) is played back.
Searching a Track
Hold ./> during playback, then release at the point you want.
(This function is only available for Audio CD’s.)
Repeat
Press REPEAT once during playback to play one or all tracks (files) repeatedly.
Note:
In the case of some Mixed CD, the unit may not normally operate
depending on the conditions of CD-R/RW discs.
4
PORTABLE MP3/CD CASSETTE RECORDER ] OWNER’S MANUAL
About MP3
MP3 Disc compatibility with this unit is limited as follows:
1. Sampling Frequency : 8 - 48 kHz
2. Bit rate : 8 - 320 kbps
3. CD-R physical format should be “ISO 9660”
4. If you record MP3 files using the software which cannot create a FILE
SYSTEM, for example “Direct-CD” etc., it is impossible to playback
MP3 files. We recommend that you use “Easy-CD Creator”, which
creates an ISO 9660 file system.
5. Do not use special letters such as “/ : * ? “ < >”etc.
6. Even if the total number of files on the disc has more than 512, it will
only be shown up to 511.
Listen to cassette tapes
ON RECORDER
1. Select the TAPE function
2. Open the tape door
3. Insert the tape
4. Close the tape door
5. Start the tape playing
6. To stop a tape playing
Cassette deck will automatically stop at
the end of the tape
Recording
Record from a CD or radio to cassette
ON RECORDER
1. Open the tape door
2. Insert a blank tape
3. Close the tape door
4. Select a mode (FM, AM or CD) in which
you want to record
- For CD, press B/[] (PLAY/PAUSE)
5. Start the Recording
6. To stop a Recording
x/Z
FUNCTION SWITCH
z
x/Z
CD Synchronized Recording
FUNCTION SWITCH
ON RECORDER
x/Z
b
x/Z
Listen to cassette tapes - more you can do
To Play Fast backward or Forward
1. Open the tape door
2. Insert a blank tape
3. Select the CD function
4. Start the Recording
The synchronized recording is started
automatically after about 7 seconds
5. To stop a Recording
x/Z
FUNCTION SWITCH
z
x/Z
Note:
On recording, press [] (PAUSE) to pause.
After pressing bb/BB during playback, or stop, press b at a point you
want.
PORTABLE MP3/CD CASSETTE RECORDER ] OWNER’S MANUAL
5
Safety Precaution
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT
REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS
INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle is intended
to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the product.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO
NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
WARNING: Do not install this equipment in a confined space such as a book case or similar
unit.
CAUTION:
This product employs a Laser System.
To ensure proper use of this product, please read this owner’s manual carefully and retain it for
future reference. Should the unit require maintenance, contact an authorized service center.
Use of controls, adjustments or the performance of procedures other than those specified herein may result in hazardous radiation exposure.
To prevent direct exposure to laser beam, do not try to open the enclosure. Visible laser radiation when open. DO NOT STARE INTO BEAM.
6
PORTABLE MP3/CD CASSETTE RECORDER ] OWNER’S MANUAL
CAUTION: The apparatus should not be exposed to water (dripping or splashing) and no
objects filled with liquids, such as vases, should be placed on the apparatus.
CAUTION concerning the Power Cord
Most appliances recommend they be placed upon a dedicated circuit;
That is, a single outlet circuit which powers only that appliance and has no additional outlets or
branch circuits. Check the specification page of this owner's manual to be certain.
Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension
cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these
conditions could result in electric shock or fire. Periodically examine the cord of your appliance,
and if its appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer.
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked,
pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and
the point where the cord exits the appliance.
To disconnect power from the mains, pull out the mains cord plug. When installing the product,
ensure that the plug is easily accessible.
Troubleshooting
Symptom
Specifications
Cause
Correction
POWER
No power
The power cord is not plugged in.
The battery is not remaining.
Plug in the power cord.
Change the battery with a new
one.
The function switch is not set to
the Radio mode.
There are electronic devices near
the player.
Set the switch to the Radio mode.
An unplayable disc is inserted.
The disc is placed upside down.
Insert a playable disc.
Place the disc with the playback
side down.
Place the disc on the disc tray
correctly inside the guide.
Clean the disc.
RADIO
No sound
Some noise
occurs.
Set the player far from the
devices.
CD
The unit does not
start playback
The disc is not placed within the
guide.
The disc is dirty.
TAPE
Unable to record
Record protect tabs are removed.
Cover holes on back edge of tape
with tap.
General
Power supply
Refer to the back panel of the unit.
Power consumption
Refer to the back panel of the unit.
Net Weight
2.3 kg
External dimensions (W x H x D)
330 x 166 x 148 mm
Output Power (T.H.D 10%)
1WX2
Speakers
8Ω X 2
Battery Operation
DC 9V, six “C”(R14) batteries
(not supplied)
Tuner
FM
Tuning Range
65 - 108 MHz, 87.5 - 108.0 MHz
Intermediate Frequency
10.7 MHz
Antenna
Telescopic antenna
AM
Tuning Range
522 - 1620 kHz or 520 - 1720 kHz
Intermediate Frequency
455 kHz
Antenna
Ferrite bar antenna
CD
Frequency response
100 - 18000 Hz
Signal-to-noise ratio
55 dB
T.H.D
0.5 %
Cassette tape player
Recording System
4 Tracks 2 channel stereo
Frequency Response
125 - 8000 Hz
Signal to Noise Ratio
40 dB
Designs and specifications are subject to change without notice.
PORTABLE MP3/CD CASSETTE RECORDER ] OWNER’S MANUAL
7
P/NO : MFL39617918
Download PDF