LG | F1207NMTW | LG F1207NMTW Owner’s Manual

WASHING
MACHINE
Please read this manual carefully before operating
your washing machine and retain it for future reference.
F1006NMTS
F1265NMTS
F1207NMTW
MFL67584565
P/NO : MFL67584565
Rev. No.: 00_14/04/2017
Copyright © 2017 LG Electronics Inc. All Rights Reserved.
Power Plug
If the supply cord is damaged,
it must be replaced by the
manufacturer or its service agents
or a similarly qualified person in
order to avoid a hazard.
Drawer
(For detergent and
fabric softener)
Control Panel
Drum
Door
Drain Pump Filter
Lower cover
Drain Plug
Adjustable leg
Lower Cover Cap
6.0kg : [F1006NMTS]
6.5kg : [F1265NMTS]
7.0kg : [F1207NMTW]
No Spin/400/600/800/1000 : [F1006NMTS]
No Spin/400/800/1000/1200 : [F1207NMTW/F1265NMTS]
100-1000kPa (1.0-10kgf/cm 2 )
5
6
Centre
(1.0~10kgf/cm²)
Part can be different according to different models.
Two rubber seals are provided
with inlet hose connectors.
These are used to prevent water
leakage.
Make sure the connection to tap
is sufficiently tight.
Check rubber seals in inlet hose
connectors.
Hose
Connector
Rubber
seal
Screw the hose connector onto
water supply tap.
Break
PE Bags
getting wet
getting wet
/leakage
Cotton
Do not exceed the maximum fill line.
Cotton Large
4.5 kg
95
3.0 kg
1.5 kg
3.0 kg
3.0 kg
2
- Intensive
-
1.5 kg
2
- Press and hold Power button for 1 second
to turn the washing machine off
specific
[F1006NMTS]
[F1207NMTW/
F1265NMTS]
2
2
(1)
hold Power button for 1 sec to turn power off.
(10) (6) (2)
(7) (3)
(4) (8)
Press &
[F1006NMTS]
Cotton Program / Main wash /
Normal Rinse / 1000 rpm / 40 0C
[F1207NMTW/F1265NMTS]
Cotton Program / Main wash /
Normal Rinse / 1200 rpm / 40 0C
Large
(5) (9)
(11)
By Pressing the Option Button, all Option
functions may be selected.
Change the
desired
program
so that moisture present inside the
washer can dry.
1000
1200
800
600
1000
800
400
400
No Spin
No Spin
Rinse Hold
Rinse Hold
Spin
Spin
F1006NMTS
F1207NMTW
F1265NMTS
F1006NMTS
Cotton Large
600 - 800- 1000
600
To proceed through to No Spin (drain) or Spin,
once the rinse hold function is completed, use
the spin button to select the required spin program
F1207NMTW/F1265NMTS
Cotton Large
1000 - 1200
Washer does not start
, Electrical power cord may not be
plugged in or connection may be loose.
, House fuse blown, circuit
breaker tripped,or a power
outage has occurred.
, Water supply tap is not turned
on.
Make sure plug fits tightly in wall outlet.
Reset circuit breaker or replace fuse.
Do not increase fuse capacity.
If problem is a circuit overload, have
it corrected by a qualified electrician.
Turn on water supply tap.
Washer will not spin
• Check that the door is firmly
shut.
Close the door and press the
StarVPause button. After pressing
the StarVPause button, it may take
a few moments before the clothes
washer begins to spin. The door
must lock before spin can be achieved.
Add 1 or 2 similar items to help balance
the load.
Rearrange load to allow proper spinning.
Once machine has started, the door
can not be opened for safety reasons.
Check if the "Door Lock" icon is
illuminated. You can safely open the
door after the "Door Lock" icon
turns off.
Door does not open
The washing time may vary by the
amount of laundry, water
pressure, water temperature and
other usage conditions.
If the imbalance is detected or if the
suds removing program works, the
wash time shall be increased.
Wash cycle time
delayed
Fabric softner
overflow
Softeners dispensed
too early
Odor
• Too much softener may cause
an overflow.
Follow softener guidelines to ensure
appropriate amount is used.
Do not exceed the maximum fill line.
Close the dispenser drawer slowly.
Do not open the drawer during the
wash cycle.
• This odor is caused by the rubber attached • It is the normal odor of new rubber and will
disappear after the machine has been run a few
to the washing machine.
times.
• Be sure to clean the gasket and door seal
• If the rubber door gasket and door seal
regularly and check under the door seal for
area are not cleaned regularly, odors can
small items when unloading the washer.
occur from mold or foreign substances.
• Odors can occur if foreign substances are • Be sure to clean the drainage pump filter
regularly.
left in the drainage pump filter.
• When installing the drainage hose, be sure
• Odors can occur if the drainage hose is
that it doesn't become kinked or blocked.
not properly installed, causing siphoning
(water flowing back inside the washing
machine).
2Z
Close the door and press
Start/Pause button two times.
*Still, if
is not released , call for
service.
P/NO : MFL67584565
Rev. No.: 00_14/04/2017
MFL67584565
Download PDF

advertising