LG | FH4G6TDNL32 | LG FH0G7QDNL52 Owner’s Manual

WASHING
MACHINE
Please read this manual carefully before operating
your washing machine and retain it for future reference.
FH0G7QDNL(0~9)2
FH0G6QDNL(0~9)2
FH0G7EDNL(0~9)2
FH2G6EDNL(0~9)2
FH4G6TDNL(0~9)2
FH4G6VDNL(0~9)2
P/NO : MFL67584564
Rev. No.: 00_04/03/2017
MFL67584564
Copyright © 2017 LG Electronics. All rights reserved.
Power Plug
If the supply cord is damaged,
it must be replaced by the
manufacturer or its service agents
Drawer
(For detergent and
fabric softener)
order to avoid a hazard.
Control Panel
Drum
Door
Drain Pump Filter
Lower cover
Drain Plug
Adjustable leg
Lower Cover Cap
59kg / 2100W
7.0kg : [FH0G7QDNL(0~9)2 / FH0G6QDNL(0~9)2]
7.5kg : [FH0G7EDNL(0~9)2/FH2G6EDNL(0~9)2]
8.0kg : [FH4G6TDNL(0~9)2]
9.0kg : [FH4G6VDNL(0~9)2]
No Spin/400/600/800/1000 : [FH0G7QDNL(0~9)2/ FH0G6QDNL(0~9)2/
FH0G7EDNL(0~9)2]
No Spin/400/800/1000/1200 : [FH2G6EDNL(0~9)2]
No Spin/400/800/1000/1400 : [FH4G6TDNL(0~9)2/FH4G6VDNL(0~9)2]
* Part can be different according to different models.
o
carpeted floor.
subjected
in
caused
Machine.
5
adjustable legs
It is advisable to avoid, the usage of trolley & the movement of Washing Machine after installation.
As it may disturb the levelling of washer, which can create excessive noise & vibration.
6
Centre
(1.0~10kgf/cm²)
Part can be different according to different models.
Two rubber seals are provided
with inlet hose connectors.
These are used to prevent water
leakage.
Make sure the connection to tap
is sufficiently tight.
Check rubber seals in inlet hose
connectors.
Hose
Connector
Rubber
seal
Screw the hose connector onto
water supply tap.
Break
PE Bags
getting wet
getting wet
/leakage
Cotton
Do not exceed the maximum fill line.
Cotton Large
6.0 kg
95
4.0 kg
2.0 kg
4.0 kg
2
Rinse+Spin
Normal fabrics which can be
washable.
_
- Intensive
- Pre Wash
2.0 kg
_
Rating
- Press and hold Power button for 1 second
to turn the washing machine off
specific
1000 rpm [FH0G7QDNL(0~9)2/
FH0G6QDNL(0~9)2/
FH0G7EDNL(0~9)2]
1200 rpm [FH2G6EDNL(0~9)2]
1400 rpm [FH4G6TDNL(0~9)2/
FH4G6VDNL(0~9)2]
(1)
hold Power button for 1 sec to turn power off.
(10) (6) (2)
(7) (3)
(4) (8)
Press &
[FH0G7QDNL(0~9)2/FH0G6QDNL(0~9)2/
FH0G7EDNL(0~9)2]
Cotton Program / Main wash /
Normal Rinse / 1000 rpm / 40 0C
[FH2G6EDNL(0~9)2]
Cotton Program / Main wash /
Normal Rinse / 1200 rpm / 400C
[FH4G6TDNL(0~9)2/FH4G6VDNL(0~9)2]
Cotton Program / Main wash /
Normal Rinse / 1400 rpm / 400C
Large
(5) (9)
(11)
By Pressing the Option Button, all Option
functions may be selected.
Change the
desired
program
so that moisture present inside the
washer can dry.
1000
1200
1400
800
600
1000
800
1000
800
400
400
400
No Spin
No Spin
No Spin
Rinse Hold
Rinse Hold
Rinse Hold
Spin
Spin
Spin
FH0G7QDNL(0~9)2
FH0G6QDNL(0~9)2
FH0G7EDNL(0~9)2
FH2G6EDNL(0~9)2
FH4G6TDNL(0~9)2
FH4G6VDNL(0~9)2
FH0G7QDNL(0~9)2/FH0G6QDNL(0~9)2/
FH0G7EDNL(0~9)2
Cotton Large
600 - 800- 1000
To proceed through to No Spin (drain) or Spin,
once the rinse hold function is completed, use
the spin button to select the required spin program
600
FH2G6EDNL(0~9)2
Cotton Large
1000 - 1200
FH4G6TDNL(0~9)2/FH4G6VDNL(0~9)2
Cotton Large
1000 - 1400
(i roubleshooting guide
Symptom
Washer does not start
Possible Cause
, Electrical power cord may not
be plugged in or connection
may be loose.
Make sure plug fits tightly in wall
outlet.
, House fuse blown, circuit
breaker tripped,or a power
outage has occurred.
Reset circuit breaker or replace fuse.
Do not increase fuse capacity.
If problem is a circuit overload, have
it corrected by a qualified electrician.
Turn on water supply tap.
, Water supply tap is not turned
on.
Washer will not spin
Solution
• Check that the door is firmly
shut.
Close the door and press the
StarVPause button. After pressing
the StarVPause button, it may take
a few moments before the clothes
washer begins to spin. The door
must lock before spin can be achieved.
Add 1 or 2 similar items to help balance
the load.
Rearrange load to allow proper spinning
Once machine has started, the door
can not be opened for safety reasons.
Check if the "Door Lock" icon is
illuminated. You can safely open the
door after the "Door Lock" icon
turns off.
Door does not open
The washing time may vary by the
amount of laundry, water
pressure, water temperature and
other usage conditions.
If the imbalance is detected or if the
suds removing program works, the
wash time shall be increased.
Wash cycle time
delayed
Fabric softner
overflow
Softeners dispensed
too early
• Too much softener may cause
an overflow.
Follow softener guidelines to ensure
appropriate amount is used.
Do not exceed the maximum fill line.
Close the dispenser drawer slowly.
Do not open the drawer during the
wash cycle.
2Z
Close the door and press
Start/Pause button two times.
*Still, if
is not released , call for
service.
4. This product does not contain any of the hazardous substances as specied in rule 13(1) and (2) of the e-waste
( Management and Handling ) Rules, 2011.
5.
यह उ पाद ई-अपिश ( बंधन और हथालन) िनयम 2011 के अ तगत 13(1) एवं (2) के तहत िन द खतरनाक पदाथ क आव यकता का
पालन करता है
MFL67584564
Download PDF