LG GC-154SQW.CSWQCIS, GC-154S, GC-154SQW.CSWQVLD Owner's manual

LG GC-154SQW.CSWQCIS, GC-154S, GC-154SQW.CSWQVLD Owner's manual
Please read this manual carefully before operating
your set and retain it for future reference.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Identification of Parts
This is a basic model. The shape of refrigerator is
subject to change.
Electrical connection
This appliance should be connected to the mains AC
230V , 50 Hz. You must connect this appliance only
to the power socket with grounding complying with the
related regulations and only an approved expert should
install this appliance.
Before switching it on, leave the appliance standing for
at least 2 hours, so that the circulation of the refrigerant
stabilizes and no operating problems occur.
When the appliance powers on, the initial state displayed
on LED is "-18°C".
Button K1 (Defrost):
Press button K1 for three seconds the first time, indicator "-", " C",
"h" shut off, compressor stop running and the value displayed on
LED is"OF". Press button K1 for three seconds the second time ,
indicator "-", " C", "h" display normally, compressor running
normally and LED displays the initial state.
Button K2 (Quick freezing):
Press butoon K2 for the first time, indicator "-", "°C"shut off,
indicator "h" light on and initial freezing time displayed is"3h".
Press button K2 for the second time the freezing time displayed
is "2h". Press button K2 for the third time the freezing time
displayed is "1h". The compressor will ren from 1hour to
3 hours according to the freezing time displayed on LED.
Press button K2 for the fourth time, the indicators will recover
the state before quick freeze.
Button K3 (Temperature regulation):
Press button K3 continuously, the provided temperature
displayed will be from -14°C to -24°C circularly.
Energy-saving method
To Reverse the Doors
How to Reverse the Door
Your refrigerator is designed with a reversible door, so
you may open from either left or right. It is best to
reposition the door hinge as necessary at the outset since
it is inconvenient to do so later.
To change the door hinge please refer to the diagram
below and proceed as follows.
1. First unplug the appliance.
2. Remove foods and accessories like shelves or trays
which are not fixed in the refrigerator.
3. Carefully lay the appliance on a cushion like packing
material to avoid the damage of refrigeration circuit.
4. Use ‘+’ driver or spanner to fix or remove the bolts.
1. Unscrew the 2xBOLTS
2. Remove the LEG
, then remove the hinge (L)
3. Gently pull the door downwards to remove it.
4. Before refitting the door, swap the Hinge Cap by pulling
it out from its current location and repositioning it on the
other side of the door. Care should be taken not to damage
the adjacent surfaces when removing the Hinge Cap.
5. Unscrew the Upper Hinge pin (U)
opposite side hole.
and screw it into the
To Reverse the Doors
How to Reverse the Door
6. After refitting the door, fix the Lower Hinge(L) in the
opposite side by using 2xBOLTS.
7. Fix the Leg.
8. Carefully place the appliance in an upright position.
Adjust the Leveling screw to make sure the appliance
is steady and check that the door opens and closes
In case of applying Reversible door, when you close
the door with excessive force, there could be the case
that the door doesn’t close because of Reaction
force. Please ascertain if the door closes properly.
Reversing the doors is not covered by the warranty.
Door handle(Option)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF