LG ATCC6030 Owner's manual

LG ATCC6030 Owner's manual
Connections
Installations
side
when
of the unit
panel
removing
the unit
from the installation sleeve,
since it may be hot. On this
side the
ribs
cooling
The unit is
designed
operate only
Panel Car Receiver
to
12 volt DC
on
Do not
electrical
negative ground
OWNER'S MANUAL
MODEL:TCC-6030
each wire as mentioned in
chapter "Connections".
Take time to read this OWNER'S MANUAL
amperage may cause
serious damage to the unit.
Using
thoroughly. Familiarity with installation and
operating procedures will help you obtain the
best performance from your CAR Receiver.
a
fuse of
A
A
higher
on
Connections
If you need to remove the unit
from the installation sleeve,
proceed
Installation
sleeve
1
as
rear
2
Remove the front
from the unit.
3
Insert the lever
hole
A
Insert the
the
2
3
5
4
panel
Connect the
(black)
into
any
other button to turn the unit on.
POWER
BAND
Press POWER button
RELEASE
VOL.
TUNE
1
13
12
23
11
10
45
9
8
7
1
POWER Button
8
CLOCK Button
2
EJECT Button
9
PRESET Button
LCD
TUNE +/- Button
3
CASSETTE Door
10
4
REW/FF(
)
Button[DIRECTION]
11
5
BAND Button
12
6
RELEASE Button
13
AS/PS Button
14
1
momentarily
to
compensate the
1
once
HOUR
pressing
TUNE
-
the unit
returns to the initial mode.
2
clock within 5 seconds.
Pressing TUNE button
adjusts the minute.
this buttons within
selecting modes,
displayed
Adjust the
the
button,
display returns to the
previous display after 5
seconds.
The
Radio
Basic
Operating display
A numeric
converted
buttons.
can
1
Turn the power ON.
2
Press the BAND button to
band.
Select the desired stations.
AUTO
Tuning
Press the TUNE +/- buttons
more
than 1 seconds.
in all
MANUAL
display is
by pressing
Tuning
Press the TUNE +/- buttons
this
repeatedly
until the desired
station appears.
4
[18FM, 6AM(MW)]
and the 6
stations
buttons. Stations often
can
be
the
quickly
the cassette
Press
more
(VOL
/
)
of the
than 2 seconds. The
now
one
and
Repeat steps
2
remaining
Note:
1
cassette
playback
compartment, tape
starts
automatically.
2
(AS)
or
panel
high
to
direct
sunlight.
Do not
drop
the front
otherwise
subject
strong impact.
or
panel
it to
agents
or
as
benzine, thinner,
insecticides to
come
into
contact with the surface of
the front
panel.
try
the front
to disassemble
panel.
Power..........................................................45 W
Output
x
4(Max.)
Speaker impedance................................................4Ωx 4 or 8Ωx 4
System .................................................................Negative
Dimensions(W x H x D)..188 x 58 x 166 mm(Without Front Panel)
Net Weight ............................................................................1.3 kg
Ground
Tape Player
Tape Drive System .............................................Full Auto Reverse
Tape Speed ................................................................4.75 cm/sec.
Wow/Flutter ..............................................................0.2% (WRMS)
(1-6)
one
buttons.
When the AS/PS button is
the
preset stations
monitored in sequence
for 5 seconds each, The
3
Frequency Response ................................................40-14,000
Hz
Tuner
FM
station number is shown in
Frequency Range ..............................65.0-74.0 MHz, 87.5-108 MHz
S/N Ratio ..................................................................................60 dB
Distortion (T.H.D. 0.5W).............................................................0.5%
the
Channel
preset station indicator.
When the desired station is
received, press the AS/PS
button again to stop
scanning.
Separation
..................................................................30 dB
AM(MW)
Frequency Range ......................................................522-1,
620 kHz
S/N Ratio ..................................................................................50 dB
Distortion (T.H.D. 0.5W).............................................................0.5%
automatically.
Turn the power ON.
Select the desired band of
stations to be received.
3
Scanning (PS)
station for each
are
3
6 stations in the selected band
be stored
a
pressed,
preset
for each of the
Auto Store
can
When the power is on, if a
cassette tape is inserted in the
2
been
of the
Store
of PRESET
button for
and Tone
button.
are
Press the AS/PS button to
Preset
buttons.
CONTROL UP/DOWN
exposed
S/N Ratio ...............................................................................50 dB
one
stored at
tape.
4
Adjust the Volume
using MD/LD and
preset stations
stations.
the TUNE +/-
area
Power Source...............................................................DC 12-15 V
stored. Then
Tune in the desired station
station has
button and
strongest
are
stop scanning the preset
the BAND button.
1
3
scanned
displayed repeatedly.
5
Select the desired band
5 PRESET buttons.
4
control
or
General
The selected band is
automatically
buttons.
stop playback, press
)
display
Specifications
preset using PRESET
PRESET(1-6)
select the desired
3
be
using
reverses
Operatiion
Operation
frequency
Operation
Memorizing Stations
24 stations
(1-6)
(
Place the Front Panel in
the supplied protective
Front Panel
been reached.
To
drop
Never
be
tape end has
or
control
the front
or
Protective Case
tape direction
when the
5
for
modes:
Press the CLOCK
can
by pressing
) buttons
automatically
6
mode mute
by
5 seconds. After you finish
MINUTE
3
5
the
temperatures
put pressure
case.
RELEASE
4
1
on
the front
put pressure
Do not allow such volatile
3
using
TUNE
do not
in any
panel.
MUTE
button, control the
desired function
indication will be
button
MD/LD
volume, bass, treble, balance
MD/LD
display the
Pressing TUNE +
adjusts the hour.
VOL.
replacing
panel,
The control buttons may
not work properly if the
front panel is not attached
Note:
buttons,
2
as
Hold the right part of the
front panel and pull it
towards you gently.
Take care not to
on the
display
1
"muted" state on/off.
When
Do not leave the front
(Optional)
the control
After you have selected the
proper mode by using the
Button
properly. If this occurs,
gently press the front
panel.
recalled.
remove
CONTROL UP/DOWN
(VOL / ) Button
RELEASE
Line Out Jack
cassette
BAND
2
1
impedance
following
diagram.
Refer to the
Antenna Jack
POWER
and fader.
Button
connection
Use 4~8Ohm
buttons.
playback automatically
begins.
side
of
4-Speakers
Signal
listened to
pressed again.
MD/LD Button
Press the RELEASE button
(
)to release the
detachable front panel.
Front Panel
tape direction
both(
together.
MD/LD Button
seconds, and clock
for 5 seconds.
received,
sensitivity
The
reversed
to
exposed
change
1
2
MUTE Button
relesing
and
panel against
the main unit to reattach it.
Panel
your stereo unit.
speakers.
Radio
3
exposed tape side
the right. If radio
broadcast is being
Push the front
Detaching the Front
the
two conductor
speaker
Panel
Notes:
Your will find a separate lead,
blue with a male terminal
suitable to many automatic
antenna. This lead is not to be
used with non-automatic
antenna. If an automatic car
antenna is used, when
connecting the lead, the
antenna will be automatically
extened when the main switch
is turned on. This can also be
used as a remote turn-on wire
connection for amplifiers that
have a remote sensing lead.
Using this connection will
allow simultaneous turning
on/off of the radio and an
external amplifier.
tape with
the
the loudness circuit which
The
Always
use
wire between each
connections
Antenna
the EJECT
CONTROL UP/DOWN
Press the CLOCK button 2
cassette
state is when any button is
Press the to
)
a
Whenever you turn on the unit,
it will operate at the volume
time.
2
Insert
seconds, activates
operated
speaker to
Attaching the Front
Amplifier Remote
level memorized.
the Clock Time
Press CLOCK button
Turn the power ON.
2
This button is
MUTE Button
/
or
the proper Volume level
and notice your setting is
memorized simultaneously.
(CLOCK Adjust)
(VOL
Setting
Display
part of the
1
6
When you press the POWER
button for 2 seconds after
lead
ground
metal
something other than a metal
part of the car, noise or
malfunction may result.
to bass at low levels.
setting
7
than 2
boosts to
operation.
from the
radio.
position.
connection can
result in noise or hamper
Tape Playback
human ear's lack of
Note:
MUTE
14
again
to turn it off.
MD/LD
a
If this connection is loose,
if the cord is connected to
the other
Press the MD/LD button for
more
to
vehicle for this purpose.
Loudness Function
or
at
vehicle and secure it using
the screw provided on the
6
Press POWER button
jack
Connection(Black)
Adjustment
POWER Button
1
path
Improper
Turn-on Lead
car
Ground
P/N:3828RCF003A
Sound
of the
of the unit.
rear
supporter
side and pull out the unit
from the installation
sleeve.
Location of Controls
plug
antenna cable into the
side of the
unit, and pull the lever
toward you. Do the same
on
the electrical return
as
not work.
Lead/External
on one
operation
chassis
The front panel of this unit can
be detached to prevent theft.
Power Antenna
Antenna Connection
from the unit.
Bend the claws
according to the
thickness
of the dashboard.
the back
on
follows.
Remove the
locked into
to utilize the vehicle's
Jacks(Optional)
the female connector
of the unit.
Dashboard
Secure the connectors
securely so that they are
receiver is not
car
desingned
Connect to the Line-in RCA
jacks of the power amplifier.
Connect the main connector to
When removing the
unit from the
installation sleeve
will rise when the vehicle is
driven.
Lead
Line Out
Main connector
Mounting the unit
all, the unit will
at
the
the back of the
front panel with a cotton
swap moistened with
alcohol.
Periodically wipe
contacts
near
parts whose temperature
yellow memory
power supply wire to a 12V +
terminal that is always supplied
with power regardless of the
vehicle's ignition switch
position. If this connection is
made incorrectly or is not made
panel
the
bring
connecting cords
Connect the
way of gripping the unit
during installation and
wiring. The front panel may
come away and the unit
may drop on the floor.
This
Precautions
Do not
Memory Back-up
(Yellow)
as a
system.
When you replace the fuse,
besuretouseafuseof
specified amperage for
the front
use
Lead
Supply
Connect the red power supply
wire to the 12V + terminal
controlled by the car ignition
switch.
Consult with your nearest
car audio dealer if
installation requires the
drilling of holes or other
modifications of the vehicle.
are
located.
Detachable Front
(Red)
Use only the parts included
with the unit to ensure
proper installation. The use
of unauthorized arts can
cause malfunctions.
Be careful not to touch the
rear
Power
Notes:
Precautions:
Detachable Front Panel
Note
:
The
design
and
notice in the
specifications are subject to change without
of product improvement.
course
Press the AS/PS button
for
more
than 2
seconds,
and then this function
"The
implements.
date of
working life of
purchase."
this
product
is 7 years since the
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement