LG | TCC-5730 | Owner's Manual | LG TCC-5730 Owner's manual

LG TCC-5730 Owner's manual
Connections
Installations
Precautions:
Be careful not to touch the
rear side panel of the unit
when removing the unit
from the installation sleeve,
since it may be hot. On this
side the cooling ribs are
located.
Detachable Front
The unit is
designed to
operate only on 12 volt DC
negative ground electrical
Panel Car Receiver
system.
OWNER'S MANUAL
MODEL: TCC-5730
Power
Notes:
When you replace the fuse,
besuretouseafuseof
specified amperage for
each wire as mentioned in
chapter Connections
Using a fuse of higher
.
amperage may cause
serious damage to the unit.
Use only the parts included
with the unit to ensure
proper installation. The use
of unauthorized arts can
cause malfunctions.
Do not
use
the front
Mounting
the unit
If you need to remove the unit
from the installation sleeve,
proceed
Installation
sleeve
as
panel
Insert the lever A into
hole on one side of the
unit, and pull the lever
toward you. Do the same
operation on the other side
and pull out the unit from
the installation sleeve.
Bend the claws
according to the
thickness
of the dashboard.
BZ03
P/N:3834RR0007K
Location of Controls
Sound
Power(PWR)
567
Button
Press PWR button
MD/LD
VOL
TUNE
Press PWR button
RELEASE
on.
to
8
456
BAND
again
turn it off.
123
AS/PS
Note:
14
POWER
12 11 10
13
(PWR)Button
Display
BAND Button
Button
CASSETTE Door
TUNE +/- Button
MD/LD Button
CONTROL UP/DOWN
RELEASE Button
Button
the Clock Time
once
MENU
CLOCK
Press the CLOCK button 2
VOL
MD/LD
TUNE
Adjust
Pressing
adjusts the
TUNE
change
the
+
-
minute.
button
button
MINUTE
HOUR
Press the CLOCK button,
the display returns to the
seconds.
state on/off.
relesing
state is when any button is
exposed
pressed again.
side
after 5
Operation
desired function
band.
by pressing
Operating display
in all
converted
buttons.
display is
by pressing
frequency
AUTO Tuning
Press the TUNE +/- buttons
for
more
than 1 seconds.
MANUAL
modes:
Tuning
Press the TUNE +/- buttons
this
buttons
repeatedly
until the desired
station appears.
Use 4~8Ohm
impedance
speakers. Refer to the following
connections diagram.
RELEASE
Button
on
front
panel is not attached
properly. If this occurs,
gently press the front panel.
(Optional)
temperatures
Do not
direct
drop
the front
otherwise
subject
strong impact.
or
panel
it to
Do not allow such volatile
agents
as
benzine, thinner,
Place the Front Panel in the
or
supplied protective
contact with the surface of
case.
Protective Case
insecticides to
come
into
panel.
Never try to disassemble
the front panel.
Front Panel
Operation
Memorizing Stations
Specifications
[18FM, 6AM(MW)]
can be preset using PRESET
(1-6) buttons. Stations often
listened to can be quickly
automatically
the 6 strongest stations
stored. Then the preset
stations
stations.
Preset
button for
remove
the cassette tape.
buttons.
stored at
now
one
of the preset
for
5
PRESET buttons.
Adjust the Volume and Tone
using MD/LD and CONTROL
Auto Store
(AS)
6 stations in the selected band
can
be stored
When the AS/PS button is
the preset stations
monitored in sequence
pressed,
been
and
Repeat steps
each of the remaining
Scanning (PS)
Store a station for each one
of PRESET (1-6) buttons.
than 2 seconds. The
station has
displayed
stop scanning the preset
of the
PRESET(1-6)
are
are
repeatedly.
buttons.
one
scanned and
Press the AS/PS button to
Tune in the desired station
using the TUNE +/Press
General
The selected band is
24 stations
playback, press the
() button and
are
Power ..........................................................40 W 4(Max.)
Power Source...............................................................DC 12-15 V
Output
Speaker impedance .............................................4 x 4 or 8 x 4
Ground System .................................................................Negative
Dimensions(W H D) ..188 x 58 x 166 mm(Without Front Panel)
Net Weight ............................................................................1.3 kg
Tape Player
Tape Drive System .............................................Full Auto Reverse
Tape Speed ................................................................4.75 cm/sec.
Wow/Flutter ..............................................................0.2% (WRMS)
S/N Ratio ...............................................................................50 dB
Frequency Response ................................................40-14,000
Hz
Tuner
FM
for 5 seconds each, The
station number is shown in
..............................65.0-74.0 MHz, 87.5-108 MHz
S/N Ratio ..................................................................................60 dB
the preset station indicator.
Distortion (T.H.D. 0.5W).............................................................0.5%
Channel Separation ..................................................................30 dB
When the desired station is
Frequency Range
received, press the AS/PS
button again to stop
AM(MW)
scanning.
S/N Ratio ..................................................................................50 dB
Distortion (T.H.D. 0.5W).............................................................0.5%
Frequency Range .......................................................522-1,620
kHz
automatically.
Turn the power ON.
When the power is on, if a
cassette tape is inserted in the
playback
or
sunlight.
the front
To stop
EJECT
cassette
do not put pressure
the display or control
Line Out Jack
more
Note:
the front
The control buttons may
not work properly if the
panel.
when the tape end has
been reached.
UP/DOWN button.
replacing
Do not leave the front panel
in any area exposed to high
reverses
Press the BAND button to
Select the desired stations.
seconds. After you finish
selecting modes, the unit
connection
Take care not to put pressure
on the display or control
buttons, or drop the front
Operation
select the desired
4-Speakers
Note:
The tape direction
mode mute
MD/LD button, control the
Press the RELEASE button
()to release the
detachable front panel.
Antenna Jack
RELEASE
456
After you have selected the
proper mode by using the
and
panel,
Select the desired band
using the BAND button.
automatically
Basic
speaker
Signal
recalled.
123
Radio
two conductor
Panel
Hold the right part of the
front panel and pull it
towards you gently.
as
Turn the power ON.
A numeric
previous display
both()
together.
the control
returns to the initial mode.
clock within 5 seconds.
Pressing TUNE
adjusts the hour.
AS/PS
BAND
seconds, and clock
indication will be displayed
for 5 seconds.
The
this buttons within 5
PWR
time.
CLOCK
muted
your stereo unit.
use
the Front
buttons.
PWR
BAND
Secure the connectors
securely so that they are
locked into position.
Improper connection can
result in noise or hamper
Always
Push the front panel against
the main unit to reattach it.
Front Panel
MENU
of volume, bass, treble, balance
and fader.
PRESET Button
momentarily to display the
The tape direction can be
reversed by pressing
cassette
AS/PS
wire between each
Radio
right. If radio broadcast
is being received, cassette
playback automatically
begins.
TUNE
speaker
Detaching
to the
the Front
Panel
When
Your will find a separate lead,
blue with a male terminal
suitable to many automatic
antenna. This lead is not to be
used with non-automatic
antenna. If an automatic car
antenna is used, when
connecting the lead, the
antenna will be automatically
extened when the main switch
is turned on. This can also be
used as a remote turn-on wire
connection for amplifiers that
have a remote sensing lead.
Using this connection will
allow simultaneous turning
on/off of the radio and an
external amplifier.
the
MD/LD
path
from the
driven.
Antenna
Lead/External
Amplifier Remote
tape with
the exposed tape side to
VOL
the electrical return
as
Attaching
Notes:
Mute Button
operated
chassis
The front panel of this unit can
be detached to prevent theft.
Power Antenna
Turn the power ON.
boosts to compensate the
human ear's lack of sensitivity
Whenever you
turn on the unit, it will operate
at the volume level memorized.
CONTROL UP/DOWN
Button
Press CLOCK button
other than a
metal part of the car, noise
or malfunction may result.
than 2 seconds, activates
the loudness circuit which
This button is
Press the to
CLOCK Button
Setting
or
something
more
to utilize the vehicle's
Connect to the Line-in RCA
jacks of the power amplifier.
MD/LD Button
(CLOCK Adjust)
REW/FF()
Button[DIRECTION]
If this connection is loose,
if the cord is connected to
a
desingned
radio.
operation.
Tape Playback
proper Volume level and notice
your setting is memorized
simultaneously.
AS/PS Button
MUTE Button
EJECT()
LCD
Connect the ground lead
(black) to a metal part of the
vehicle and secure it using
the screw provided on the
vehicle for this purpose.
to bass at low levels.
When you press the PWR button
for 2 seconds after setting the
9
Connection(Black)
Press the MD/LD button for
MUTE
CLOCK
Ground
Insert
receiver is not
will rise when the vehicle is
Turn-on Lead
Insert the plug of the car
antenna cable into the jack at
the rear of the unit.
Loudness Function
or
any
other button to turn the unit
PWR
Antenna Connection
Adjustment
car
Jacks(Optional)
Main connector
Remove the rear supporter
from the unit.
near
parts whose temperature
Lead
Line Out
follows.
Remove the front
from the unit.
bring the
connecting cords
Connect the yellow memory
power supply wire to a 12V +
terminal that is always supplied
with power regardless of the
vehicle s ignition switch
position. If this connection is
made incorrectly or is not made
at all, the unit will not work.
Connections
This
Precautions
Do not
Memory Back-up
(Yellow)
as a
When removing the
unit from the
installation sleeve
Dashboard
1
A
Connect the main connector to
the female connector on the back
of the unit.
thoroughly. Familiarity with installation and
operating procedures will help you obtain the
best performance from your CAR Receiver.
4
A
panel
way of gripping the unit
during installation and
wiring. The front panel may
come away and the unit
may drop on the floor.
Periodically wipe the
contacts on the back of the
front panel with a cotton
swap moistened with
alcohol.
Lead
Connect the red power supply
wire to the 12V + terminal
controlled by the car ignition
switch.
Consult with your nearest
car audio dealer if
installation requires the
drilling of holes or other
modifications of the vehicle.
Take time to read this OWNER S MANUAL
23
(Red)
Supply
Detachable Front Panel
compartment, tape
starts
automatically.
Select the desired band of
stations to be received.
Press the AS/PS button for
Note
:
The design and specifications
notice in the course of product
subject to change without
improvement.
are
than 2 seconds, and
then this function
more
implements.
"The
date
working life of
of purchase."
this
product
is 7 years since the
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising