LG V-C9156WA Owner's manual

LG V-C9156WA Owner's manual
Vacuum Cleaner
OWNER'S MANUAL
MODEL: V-9144WA
V-C9145WA
V-9155WA
V-C9156WA
V-C9165WA
Please read
carefully and thoroughly the operating
safety precautions before installing
and operating your vacuum cleaner.
instructions and
BZ03
P/No.
:
3828Fi3741K
Made in KOREA
1
2
1
2
2
1
3
4
5
6
7
8
2
1
9
10
2
11
3
1
--2--
12
13
14
Clip
Separation-button
Connector
15
16
Safety
17
device
18
19
21
22
2
1
20
OFF
ON
23
--3--
24
23
Red mark
Yellow mark
Handle
Hose
Cord reel button
Cover assy
Hose handle
Shampoo
tank cap
Shampoo
tank
Clamp
Shampoo
button
Power switch
button
Inlet dust
Power cord
Outlet cap
Pipe
Spray
nozzle
Valve
Dusting
Crevice
Upholstery
brush
tool
nozzle
Floor nozzle
--4--
Tank
Cloth filter
Shampoo bottle
OPERATING INSTRUCTION
Preparation
?
Before
Using
Connect the hose with the tank: Insert the end of the hose into the
opening
of the tank, and turn it
right.(Fig. 1)
?
?
?
?
Connect the outlet cap with the valve: Connect the outlet cap with the valve, and turn it
right.(Fig. 1)
pipe with the hose handle: There are two pipes. Connect the pipe which dose not have
the pipe holder.(Fig. 2)
Connect the other pipe.(Fig. 3)
Connect the nozzle with the pipe: Connect the nozzle which you want to use with the pipe. (Fig. 4)
Connect the
NOZZLE
?
Floor nozzle: Use it to clean the
dry dust.
carpet(without brush) and a tile(with brush).(Fig. 5)
Spray nozzle: Use it to suck water or to do a shampoo cleaning.
You can use it to clean a carpet(without brush) and a tile(with brush).(Fig. 6)
You
?
can use
it to clean
a
ACCESSORY
You
can use
all of accessories with
?
Upholstery
nozzle: Use it to clean
?
Crevice tool: Use it to clean
?
Dusting
a
brush: Use it to clean
How to
Cleaning
a
a pipe or directly with a hose handle.
upholstery such as furniture, curtain, etc..
crevice such
some
as
window frame, door crevice, etc.
where difficult to reach such
as
lampshade, shelf,
etc.
use
dry
dust
?
Open the cover, and check whether the inside of the tank is empty
If not empty, make the tank completely empty and make it dry.
?
Insert the cloth
?
Insert the floor
?
Connect the
or
dry.(Fig. 7)
to
weak, and you
filter(Fig. 8), and closer the cover.(Fig. 9)
nozzle.(Fig. 4)
plug, and press power button.(Fig. 10)
Making
the cloth filter empty
When the filter becomes to be
the
inside of
cleaning
any
full, the suction power becomes
can
not do
more.
Then, clean the cloth filter.
With the power
Slide out the
Sucking
?
Open
off, open the
clip
of the
cover
and
filter(Fig. 12),
remove
clean the
the
filter.(Fig. 11)
filter, and reinstall the clip again.
water
the cover, and check whether the cloth filter is installed at the tank
remove the filter.
or
not.
If installed,
?
Insert the spray
?
Insert the tube into the holder of the
?
Insert the connector
?
When
?
?
nozzle.(Fig. 13)
on
the
top
pipe,
and insert the
clip into the pipe.(Fig. 13)
trigger of the hose handle.(Fig. 14)
remove button of the trigger.(Fig. 14)
of the tube into the
disconnecting the connector, press the
Connect the plug, and press the power button.
You can suck water only with the hose handle after removing
--5--
the
pipe
from the hose
handle.(Fig. 15)
Make the tank empty
When the water in the tank goes to the
water from
the
specific level,
safety
device works to
prevent the
sucking.(Fig. 16)
Then, make the tank empty.
With the power
Open
turn the hose connected with the tank to the left to be
off,
the cover, and disconnect the tank from the main
Make the tank
removed.(Fig. 17)
body.
empty (Fig. 18), and reassemble it.
Shampoo cleaning
?
Do the
?
Open
?
Remove the floor nozzle from the
?
Insert the tube into the holder of the
?
Insert the connector
?
When you disconnect the connector, press the
?
Open the shampoo cap, and fill the shampoo tank with
shampoo.(Fig. 19)
Read the appropriate ratio value on the shampoo.
?
Connect the
?
Pull the handle of the hose handle, then the
?
Spray the shampoo evenly over the area to be cleaned, and press the power button to suck the
sprayed shampoo. At this time, you should pull to clean toward your body. If you push to clean, you
can not suck the shampoo.(Fig. 6)
?
dry
dust
cleaning.
the cover, and
plug,
remove
the
on
the filter from the tank.
and insert the spray nozzle.
pipe,
and insert the
into the
pipe.
button of the
remove
the
trigger.
appropriate
ratio of water and
shampoo button.(Fig. 20)
noise from the main
big
clip
top of the tube into the trigger of the hose handle.
and press the
When you hear the
pipe,
shampoo
is
body during
sprayed
the
at the spray
nozzle.(Fig. 21, 22)
shampoo cleaning,
refill the
shampoo
tank, because it indicates that the shampoo tank is empty.
Caution
Use
only
the
In order to
the
during
shampoo
remove
make the tank
the
solution dedicated for LG.
empty, and operate about for
Use the clean water
only.
tank is
shampoo
pressed.
Cleaning
Separate
Then,
inside the main
shampoo remaining
When the
button
shampoo cleaning
empty, do
not
operate for longer than
the exhaust filter and
exhaust
cover
wash filter in
Do not clean in
a
a
body
after the
one
soapy water.
washing machine.
sufficiently in shade
or
Remove the moisture and filter
minute with the
safety filter.(Fig. 23, 24)
and dust off.
dish-washer
shampoo cleaning,
shampoo cleaning.
30 seconds at the state of the
--6--
for about
a
day.
shampoo
Housekeeping
?
Turn the cleaner off, and disconnect the
?
Press the cord reel button to reel the
plug.
cord.(Fig. 25)
?
Place the
?
Water may be remained inside the cleaner. In order to
freezing, keep it at 0°C or higher.
The
pipe
working life
Upon the expiry
holder into the hole at the
rear
side of the
of this set is 7 years since the date of
of the said
period,
it
might
cleaner.(Fig. 26)
prevent the
delivery to
be unsuitable for the
--7--
water remained inside it from
to
consumer.
use
according
to their destination.
MEMO
--8--
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement