LG LCD5300R-BP User guide
CAUTION • A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this product in the end user. • Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions. RISK OF ELECTRIC SHOCK DO NOT OPEN • CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. LG Electronics hereby declares that this/these product(s) is/are in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC and 2011/65/EU. Contact office for compliance of this product: LG Electronics Inc. EU Representative, Krijgsman 1,1186 DM Amstelveen, The Netherlands Holes in metal, through which insulated wires pass, shall have smooth well rounded surfaces or shall be provided with brushings. This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. • Please note that this is NOT a Customer Service contact point. For Customer Service Information, see Warranty Card or contact the dealer that you purchased this product. Warning: Do not install this equipment in a confined space such as a bookcase or similar unit. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. Warning: Wiring methods shall be in accordance with the National Electric Code, ANSI/NFPA 70. Warning: This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Warning: To reduce a risk of fire or electric shock, do not expose this product to rain or moisture. Caution: This installation should be made by a qualified service person and should conform to all local codes. Caution: To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Caution: The apparatus shall not be exposed to water (dripping or splashing) and no objects filled with liquids, such as vases, shall be placed on the apparatus. OWNER'S MANUAL IR Dome Camera Please read this manual carefully before operating your set and retain it for future reference. MODEL LCD5300R-BN LCD5300R-BP FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Important Safety Instructions Power Supply 1. 2. 3. 4. 5. 6. 7. This camera must always be operated DC 12 V or AC 24 V. Certified/Listed Adaptor which comply with LPS. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments/accessories specified by the manufacturer. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Handling of the unit Be careful not to spill water or other liquids on the unit. Be cautions not to get combustible or metallic material inside the body. If used with foreign matter inside, the camera is liable to fail or to get cause of fire or electric shock. • • • Remove dust or dirt on the surface of the lens with a blower. Use a dry soft cloth to clean the body. If it is very dirty, use a cloth dampened with a small quantity of neutral detergent then wipe dry. Avoid the use of volatile solvents such as thinners, alcohol, benzene and insecticides. Operating and storage location Avoid viewing a very bright object (such as light fittings) during an extended period. Avoid operating or storing the unit in the following locations. • Extremely hot or cold places (operating temperature -10 °C to 50 °C, however, we recommend that the unit be used within a temperature range of 0 °C to 45 °C) Specification Item LCD5300R-BN LCD5300R-BP Item Signal System NTSC PAL Digital Zoom x16 Sens-up OFF / AUTO(x2, ... x512) White Balance AUTO / ATW / ONE PUSH / MANUAL Privacy Zone Masking 14 Masks Image Device Total/Effective Pixels Number 6 mm (1/3 Type) Exview HAD CCD II 520 000 Pixels / 480 000 Pixels 610 000 Pixels / 570 000 Pixels Horizontal Resolution 650 TV Lines (Color), 700 TV Lines (B/W) ISP XDI-V Lens Minimum Illumination (30 IRE) 2.8 mm to 11 mm Vari-focal Lens, F1.2 LCD5300R-BN LCD5300R-BP Motion Detection 8 Zones Digital Effect OFF / V-FILP / MIRROR / ROTATE Communication Coaxial Communication Color 0.03 lx (Sens-up Off, F1.2), 0.000 3 lx (Sens-up Auto, F1.2), 0.000 1 lx (Sens-up x512, F1.2) Power Source DC 12 V / AC 24 V B/W 0 lx (IR LED ON) Power Consumption 3.5 W 290 mA • Damp or dust place Day & Night ICR (AUTO / DAY / NIGHT) Input Current • Places exposed to rain IRIS Control DC -10 ºC to 50 ºC / 0 % RH to 80 % RH • Places subject to strong vibration Operation Temperature/ Humidity Sync. System Internal / Line Lock • Close to generators of powerful electromagnetic radiation such as radio or TV transmitters. Storage Temperature/ Humidity -20 ºC to 60 ºC / 0 % RH to 85 % RH Dimension (Ø x H) 140 mm x 90 mm Weight 390 g Scanning Frequency (H/V) 15.734 KHz / 59.94 Hz 15.625 KHz / 50 Hz S/N Ratio 50 dB Video Output Signal 1 Vp-p Composite (75 Ω) IR LED 8 EA IR Distance 20 m SmartIR IR Anti-Saturation BACKLIGHT BLC / HSBLC / OFF DNR 2D + 3D-DNR Exposure ALC /ELC Auto Gain Control Electronic Shutter Speed OFF/ LOW/ MIDDLE/ HIGH 1/60 to 1/120 000 1/50 to 1/120 000 Installation 1. Using the template as a guide, make a hole through the ceiling. 2. Install the camera mounting bracket to the ceiling. 3. Connect the cables to the cable jacks of the camera body. Assemble the camera and mounting bracket as illustrated step a and b. 4. <ITALIANO> Utilizzando il modello come guida, praticare un foro attraverso il soffitto. <ITALIANO> Installare la staffa per il montaggio della videocamera al soffitto. <ITALIANO> Collegare i cavi alle prese sul corpo della videocamera. <ITALIANO> Montare la videocamera e la staffa come illustrato nei passi a e b. <ESPAÑOL> Usando la plantilla como guía, haga un agujero en el techo. <ESPAÑOL> Instale el soporte de la cámara en el techo. <ESPAÑOL> Conecte los cables en los terminales del cuerpo de la cámara. <ESPAÑOL> Monte la cámara y el soporte como se muestra en los pasos a y b. <PORTUGUÊS> Conecte os cabos na tomada de cabos do corpo da câmera. <PORTUGUÊS> <PYCCKNЙ> Usando o molde como um guia, faça um furo no teto. Используя шаблон как вспомогательный элемент, сделать отверстие в потолке. <PORTUGUÊS> <PYCCKNЙ> Instale o suporte de montagem da câmera no teto. Прикрепить монтажный кронштейн камеры к потолку. <PYCCKNЙ> TILT <PORTUGUÊS> <PYCCKNЙ> Подключить кабелиROTATE к разъемам на корпусе камеры. Verilen şablonu kılavuz olarak kullanarak, tavanda bir delik açın. Соединить камеру и монтажный кронштейн, как показано на иллюстрации шага a и b. PAN TILT <TÜRKÇE> Monte a câmera e o suporte de montagem conforme mostrado nos passoa a e b. <TÜRKÇE> <TÜRKÇE> Kamera bağlantı parçasını tavana takın. <TÜRKÇE> Kamera kablolarını kamera üzerinde bulunan soketlere yerleştirin. Kamerayı ve bağlantı parçasını adım a ve b’de gösterildiği gibi monte edin. ROTATE PAN Camera Adjustment 1. Connect a portable monitor to the video jack. 2. Adjust the Pan/Tilt/Rotate position of the camera. 3. Adjust the zoom. FAR 4. Adjust the focus. NEAR TILT FAR TELE NEAR WIDE ROTATE PAN WIDE TELE NOTE: Disassemble the IR cover as illustrated in case of difficult occasion to adjust the focus lever. NOTE: Disassemble the IR cover as illustrated in case of difficult occasion to adjust the zoom lever. NOTE: To disassemble the camera from the mounting bracket, rotate the camera counterclockwise with pressing the PUSH button inside the camera body. <ITALIANO> Collegare un monitor portatile alla presa video. <ITALIANO> Regolare la posizione della panoramica/dell’inclinazione/della rotazione della telecameraRegolare lo zoom <ITALIANO> Regolare lo zoom <ESPAÑOL> Ajuste la posición Panorámica/Inclinada/Rotativa de la cámara. <ESPAÑOL> Ajuste el zoom. <ITALIANO> Regolare la focalizzazione <ESPAÑOL> Ajuste el enfocado. TILT <ESPAÑOL> Conecte un monitor portátil a la conexión de vídeo. FAR NEAR ROTATE <PORTUGUÊS> <PYCCKNЙ> <TÜRKÇE> Conecte o monitor portátil na tomada de vídeo. PAN Подключить переносной монитор к разъему видео. Video soketine taşınabilir bir monitör bağlayın. <PORTUGUÊS> <PYCCKNЙ> <TÜRKÇE> Ajuste a posição da Bandeja/Lente/Rotação da Câmara. Регулировка панорамы/наклона/вращения (Pan/Tilt/Rotate) положения камеры Kameranın Panlama/Eğim/Döndürme konumunu ayarlayın. TELE WIDE <PORTUGUÊS> <PYCCKNЙ> <TÜRKÇE> Ajuste o zoom. Регулировка приближения Yakınlaştırmayı ayarlayın. <PORTUGUÊS> <PYCCKNЙ> <TÜRKÇE> Ajuste o foco. Регулировка фокуса Odağı ayarlayın.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project