LG | LD120P-C1 | LG LD120P-C1 Owner’s Manual

OWNER'S MANUAL
Color Video Camera
Please read this manual carefully before operating
your set and retain it for future reference.
MODEL
LD120P
LD120N
P/NO : MFL62723790
D120P-C1.COMMON_MFL62723790_ENG1 1
2010.6.11 10:54:11 AM
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This lightning flash with arrowhead
symbol within an equilateral triangle
is intended to alert the user to the
presence of uninsulated dangerous
voltage within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and maintenance (servicing) instructions in the
literature accompanying the product.
FCC WARNING : This equipment may generate
or use radio frequency energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly
approved in the instruction manual. The user could
lose the authority to operate this equipment if an
unauthorized change or modification is made.
REGULATORY INFORMATION: FCC Part 15
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case
the user will be required to correct the interference
at his own expense.
• A suitable conduit entries, knock-outs or glands
shall be provided in the cable entries of this
product in the end user.
• Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.
• Holes in metal, through which insulated wires
pass, shall have smooth well rounded surfaces or
shall be provided with brushings.
This Class A digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Warning: Do not install this equipment in a confined space such as a bookcase or similar unit.
Warning: Wiring methods shall be in accordance
with the National Electric Code, ANSI/NFPA 70.
Warning: This is a class A product. In a domestic
environment this product may cause radio interference in which case the user may be required to
take adequate measures.
Warning: To reduce a risk of fire or electric shock,
do not expose this product to rain or moisture.
Caution: This installation should be made by a
qualified service person and should conform to all
local codes.
D120P-C1.COMMON_MFL62723790_ENG2 2
2010.6.11 10:54:12 AM
Caution: To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel only.
Caution: The apparatus shall not be exposed to
water (dripping or splashing) and no objects filled
with liquids, such as vases, shall be placed on the
apparatus.
To disconnect power from mains, pull out the
mains cord plug. When installing the product,
ensure that the plug is easily accessible.
Disposal of your old appliance
1.
2.
3.
4.
LG Electronics hereby declares
that this/these product(s) is/are
in compliance with the essential
requirements and other relevant
provisions of Directive 2004/108/
EC, 2006/95/EC, and 2009/125/EC.
European representative :
LG Electronics Service Europe B.V.
Veluwezoom 15, 1327
AE Almere, The Netherlands
(Tel : +31-(0)36-547-8888)
When this crossed-out wheeled
bin symbol is attached to a product it means the product is covered by the European Directive
2002/96/EC.
All electrical and electronic
products should be disposed of
separately from the municipal
waste stream via designated collection facilities appointed by the
government or the local authorities.
The correct disposal of your
old appliance will help prevent
potential negative consequences
for the environment and human
health.
For more detailed information
about disposal of your old appliance, please contact your city
office, waste disposal service or
the shop where you purchased
the product.
EEE Compliance with Directive. (for Turkey only)
D120P-C1.COMMON_MFL62723790_ENG3 3
2010.6.11 10:54:13 AM
Impo­rtant Safety Instructions
1.
2.
3.
4.
5.
6.
7.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8. Do not install near any heat sources
such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of
the polarized or grounding-type plug.
A polarized plug has two blades with
one wider than the other. A grounding
type plug has two blades and a third
grounding prong. The wide blade or
the third prong are provided for your
safety. If the provided plug does not fit
into your outlet, consult an electrician
for replacement of the obsolete outlet.
10. Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles, and
the point where they exit from the
apparatus.
11. Only use attachments/accessories
specified by the manufacturer.
12. Use only the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with apparatus. When a
cart is used, use caution when moving
the cart/ apparatus combination to
avoid injury from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in
any way, such as power- supply cord
or plug is damaged, liquid has been
spilled or objects have fallen into the
apparatus, the apparatus has been
exposed to rain or moisture, does
not operate normally, or has been
dropped.
D120P-C1.COMMON_MFL62723790_ENG4 4
2010.6.11 10:54:13 AM
Safety Precautions
Do not attempt to disassemble
the camera
Avoid the camera with direct
sunlight
Do not use strong solvents or
detergents
Handle the camera with care
To prevent electric shock, do not remove
screws or covers. There are no user serviceable parts inside. Ask a qualified service
personnel for servicing.
Use a dry cloth to the camera when it is
dirty. If it is hard to remove the dirt on the
camera, use a mild detergent and wipe it
gently.
Before operating, please check
proper temperature, humidity
and power source ratings.
Use the camera under conditions where
temperature is between -10 °C to +50 °C.
Do not expose the camera in
such conditions as shown
below.
Do not aim the camera at bright objects.
Never face it with direct sunlight or other
extremely bright objects. Otherwise blooming or smear may be caused.
Do not abuse the camera. Avoid striking,
shaking, etc. The camera could be damaged
by improper handling or storage.
Do not expose the camera to
rain or moisture
This product is designed for indoor use
or location where it is protected from rain
and moisture. When exposed to moisture,
turn the power off immediately and ask a
qualified service personnel for servicing.
Moisture can damage the camera and also
create the danger of electric shock.
Use in a room or area filled with cigarette
smoke, dust or gas.
D120P-C1.COMMON_MFL62723790_ENG5 5
2010.6.11 10:54:13 AM
What's in the box
Video Cable
Camera Body
M3 Tapping Screws (2 EA)
(Pan Lock Screw)
D120P-C1.COMMON_MFL62723790_ENG6 6
2010.6.11 10:54:15 AM
Construction
Front View
Tilt Base
Side View
D120P-C1.COMMON_MFL62723790_ENG7 7
Tilting Lock Screw
Lens
Dome Cover
2010.6.11 10:54:16 AM
Installation
Camera Installation
1
Installation Label
2
Dome cover
3
Lens cover
4~6
Hole for Fixing
Tilting Lock Screw (B)
M3 Tapping Screw (A)
Pan lock Screw (C)
1. Use the installation label to check
the place that you wish to install.
2. Turn the Dome Cover
counterclockwise simultaneously.
3. Remove the Lens cover.
4. Aim the LG logo of the Dome
Camera to face the place that you
wish to watch.
5. Tighten the M3 Tapping
Screws(A) to fix the Dome
Camera on the ceiling.
6. Loosen the Tilting Lock Screw
(B). Adjust the Tilt (Up/Down)
then tighten Tilting Lock Screw.
If you need to adjust the Pan,
Loose the Pan Lock Screw (C).
Adjust the Pan (Left/Right) then
tight the Pan Lock Screw.
7. Install the Lens cover.
8. Install the Dome Cover to the
main body by turning it clockwise.
Notes
• When you install the camera,
handle with care. The camera could
be damaged by improper handling
or storage.
• If this camera is mounted on the
other places except ceiling, you
need an extra bracket for mounting.
(not supplied)
D120P-C1.COMMON_MFL62723790_ENG8 8
2010.6.11 10:54:17 AM
Installation
Camera Connection
Connect the Power Adapter (12 V, 300 mA; optional) to the Power
Input Jack of the camera as shown below.
Cautions for Safe Operation
This camera must be operated a DC 12 V Certified/listed, class 2 power supply.
D120P-C1.COMMON_MFL62723790_ENG9 9
Power
Input Jack
Power Adapter
(Not supplied)
Adapter
Jack
BNC
Monitor
2010.6.11 10:54:18 AM
Setup
4-pin Dip Switch Setting
This camera has the 4-pin Dip Switch
for setting.
1. AGC (Auto Gain Control)
- ON :If the image is too dark,
increase the AGC value to
make the image bright.
- OFF :Not used.
2. BLC (Back Light Compensation)
- ON :Sets to this position when
strong light comes in
behind the target.
- OFF :Normal position.
3. HSBLC
1 2 3 4
ON
- ON :Use for masking brightness
of the specific area to view
the subject more clearly.
- OFF :Not used.
ON
1 2 3 4
ON
OFF
4. WIDE BLC
- ON :Use WIDE BLC option to
view the object clearly in
strong backlight conditions.
- OFF :Not used.
10
D120P-C1.COMMON_MFL62723790_ENG10 10
2010.6.11 10:54:19 AM
Troubleshooting
Check the following guide for the
possible cause of a problem before
contacting service.
The picture is poor
Does the Dome Cover have lots of
dust on the surface?
- Use a dry cloth to clean the
camera when it is dirty.
Smear may be caused to the
screen of night than daytime.
- Adjust the Focus by moving the
Focus Lens.
Contrast of the screen is not clear.
Check the condition of the monitor.
A light source such as a spot light
causes burn-in on the display screen.
Adjust position or angle of the camera
to eliminate strong background light.
Background screen appears white
extremely.
You can set the background
compensation to OFF.
Dimension
D120P-C1.COMMON_MFL62723790_ENG11 11
ø 80 mm
67.5 mm
ø 88 mm
11
2010.6.11 10:54:19 AM
Specifications
Model
Signal System
Total / Effective Pixels
Pick-Up Device
Lens
Day / Night
Scanning System
Scanning Frequency
Resolution
S/N Ratio
Minimum Illuminance
Video Output Signal
Shutter Speed
Dip switch
Power Source
Power Consumption
Operating Temp.
Storage Temp.
Weight
Dimensions
LD120N
LD120P
NTSC
PAL
410 000 Pixel /
470 000 Pixel /
380 000 Pixel
440 000 Pixel
6 mm Super Had CCD II
3.6 mm(C1) / 2.5 mm(A1)
Auto
2 : 1 Interlace
59.94 Hz(VD)
50 Hz(VD)
More than 540 TV Lines
More than 48 dB
0.05 lx
CVBS 1 Vp-p (75 Ω)
AUTO (1/60 to 1/100
AUTO (1/50 to 1/100
000 SEC)
000 SEC)
AGC/BLC/HSBLC/WIDE BLC
DC 12 V
Less than 1.15 W
-10 °C to 50 °C, 0 % RH to 80 % RH
-20 °C to 60 °C, 0 % RH to 80 % RH
170 g
ø 88 mm x 67.5 mm
12
D120P-C1.COMMON_MFL62723790_ENG12 12
2010.6.11 10:54:20 AM
D120P-C1.COMMON_MFL62723790_ENG13 13
2010.6.11 10:54:20 AM
D120P-C1.COMMON_MFL62723790_ENG14 14
2010.6.11 10:54:20 AM
D120P-C1.COMMON_MFL62723790_ENG15 15
2010.6.11 10:54:20 AM
D120P-C1.COMMON_MFL62723790_ENG16 16
AB28
2010.6.11 10:54:20 AM
Download PDF