LG | LD300P-B | LG LD300P-B Owner’s Manual

OWNER'S MANUAL
Color Video Camera
Please read this manual carefully before operating
your set and retain it for future reference.
MODEL
LD300N-B/C/D/E/F
LD300P-B/C/D/E/F
P/NO : MFL62034778
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert
the user to the presence of uninsulated dangerous voltage within the product’s enclosure that
may be of sufficient magnitude
to constitute a risk of electric
shock to persons.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and maintenance (servicing) instructions in
the literature accompanying the
product.
FCC WARNING: This equipment may
generate or use radio frequency energy.
Changes or modifications to this equipment
may cause harmful interference unless the
modifications are expressly approved in
the instruction manual. The user could lose
the authority to operate this equipment if
an unauthorized change or modification is
made.
REGULATORY INFORMATION: FCC
Part 15
This equipment has been tested and found
to comply with the limits for a Class A
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference when the equipment is
operated in a commercial environment. This
equipment generates,uses,and can radiate
radio frequency energy and,if not installed
and used in accordance with the instruction
manual,may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case
the user will be required to correct the interference at his own expense.
• A suitable conduit entries, knock-outs
or glands shall be provided in the
cable entries of this product in the end
user.
• Caution: Danger of explosion if battery is incorrectly replaced. Replaced
only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufacturer’s instructions.
• Holes in metal, through which insulated wires pass, shall have smooth well
rounded surfaces or shall be provided
with brushings.
WARNING
in a confin
similar uni
WARNING
a domestic
cause radi
user may b
measures.
WARNING
accordanc
ANSI/NFP
WARNING
tric shock,
or moisture
CAUTION
exposed to
and no ob
vases, sha
CAUTION
by a qualif
conform to
CAUTION
open the c
fied person
European
LG Electro
Veluwezoo
The Nethe
FCC
nd found
sA
of the
ned
gainst
ipment is
ment. This
n radiate
nstalled
nstruction
rence to
of this
ikely to
h case
the inter-
nock-outs
n the
in the end
n if batReplaced
alent type
acturer.
cording to
ns.
h insulatmooth well
provided
WARNING: Do not install this equipment
in a confined space such as a bookcase or
similar unit.
WARNING: This is a class A product. In
a domestic environment this product may
cause radio interference in which case the
user may be required to take adequate
measures.
WARNING: Wiring methods shall be in
accordance with the National Electric Code,
ANSI/NFPA 70.
WARNING: To reduce a risk of fire or electric shock, do not expose this product to rain
or moisture.
CAUTION: The apparatus shall not be
exposed to water (dripping or splashing)
and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
CAUTION: This installation should be made
by a qualified service person and should
conform to all local codes.
CAUTION: To avoid electrical shock, do not
open the cabinet. Refer servicing to qualified personnel only.
This product is manufactured
to comply with EMC Directive
2004/108/EC and Low Voltage
Directive 2006/95/EC.
Disposal of your old appliance
1. When this crossed-out
wheeled bin symbol is
attached to a product it means
the product is covered by the
European Directive 2002/96/
EC.
2. All electrical and electronic
products should be disposed of separately from the
municipal waste stream via
designated collection facilities
appointed by the government
or the local authorities.
3. The correct disposal of your
old appliance will help prevent
potential negative consequences for the environment
and human health.
4. For more detailed information about disposal of your
old appliance, please contact
your city office, waste disposal
service or the shop where you
purchased the product.
European representative :
LG Electronics Service Europe B.V.
Veluwezoom 15, 1327 AE Almere,
The Netherlands (Tel : +31-036-547-8940)
Important Safety Instructions
Safet
1.
2.
3.
4.
5.
Do not
ble the
6.
7.
8.
9.
10.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near
water.
Clean only with dry cloth.
Do not block any ventilation
openings. Install in accordance
with the manufacturer’s instructions.
Do not install near any heat
sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
Do not defeat the safety purpose
of the polarized or grounding-type
plug. A polarized plug has two
blades with one wider than the
other. A grounding type plug has
two blades and a third grounding prong. The wide blade or the
third prong are provided for your
safety. If the provided plug does
not fit into your outlet, consult an
electrician for replacement of the
obsolete outlet.
Protect the power cord from
being walked on or pinched particularly at plugs, convenience
receptacles, and the point where
they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with apparatus. When a cart is used, use
caution when moving the cart/
apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during
lightning storms or when unused
for long periods of time.
14. Refer all servicing to qualified
service personnel. Servicing is
required when the apparatus has
been damaged in any way, such
as power- supply cord or plug is
damaged, liquid has been spilled
or objects have fallen into the
apparatus, the apparatus has
been exposed to rain or moisture,
does not operate normally, or has
been dropped.
To preven
screws or
serviceab
service pe
Do not
deterge
Use a dry
dirty. If it i
camera, u
it gently.
Before
check p
humidi
ratings
Use the ca
temperatu
Do not
such co
below.
Use in a r
smoke, du
tus.
cesanufac-
tripod,
d by the
h appad, use
cart/
o avoid
ring
unused
lified
ing is
atus has
y, such
plug is
n spilled
o the
has
moisture,
y, or has
Safety Precautions
Do not attempt to disassemble the camera
Avoid the camera with direct
sunlight
Do not use strong solvents or
detergents
Handle the camera with care
To prevent electric shock, do not remove
screws or covers. There are no user
serviceable parts inside. Ask a qualified
service personnel for servicing.
Use a dry cloth to the camera when it is
dirty. If it is hard to remove the dirt on the
camera, use a mild detergent and wipe
it gently.
Before operating, please
check proper temperature,
humidity and power source
ratings.
Use the camera under conditions where
temperature is between -10 °C to +50 °C.
Do not expose the camera in
such conditions as shown
below.
Do not aim the camera at bright objects.
Never face it with direct sunlight or other
extremely bright objects. Otherwise
blooming or smear may be caused.
Do not abuse the camera. Avoid striking,
shaking, etc. The camera could be damaged by improper handling or storage.
Do not expose the camera to
rain or moisture
This product is designed for indoor use
or location where it is protected from
rain and moisture. When exposed to
moisture, turn the power off immediately
and ask a qualified service personnel
for servicing. Moisture can damage the
camera and also create the danger of
electric shock.
Use in a room or area filled with cigarette
smoke, dust or gas.
What's in the box
Cons
Front V
Video Cable
Power Cable
Camera Body
M4 Tapping Screws (2 EA)
(Pan Lock Screw)
Optional
Adapter (DC 12 V, 300 mA)
Side V
Construction
Front View
6-pin Dip Switch
Tilt Base
Focus Lock Screw
Side View
Lens
Tilting Lock Screw
Dome Cover Separatory Spring
Installation
Insta
Camera Installation
Camer
1. Aim the LG logo of the Dome Camera to face the place that you wish to
watch.
2. Tighten the M4 Tapping Screws to fix the Dome Camera on the ceiling,
then adjust the Pan (Left /Right) by moving the Pan Base. Tighten the
M4 Tapping Screws after adjustment.
3. Loosen the Tilting Lock Screw. Adjust the Tilt(Up /Down) by moving the
Tilt Base then tighten Tilting Lock Screw.
4. Loosen the Focus Lock Screw. Adjust the Focus by moving the Focus
Lens then tighten Focus Lock Screw.
5. Install the Dome Cover to the main body by turning it counterclockwise
to the end.
Hole for Fixing
Notes:
•
•
•
When you install the camera, handle with care. The camera could be damaged by improper handling or storage.
If this camera is mounted on the other places except ceiling, you need an
extra bracket for mounting. (not supplied)
When installing the camera with 3,0 mm fixed lens, You must note that a black
image on the coner can be made, depending on the angle of the camera.
Connect
Input Jac
wish to
ceiling,
n the
Installation
Camera Connection
Connect the Power Adapter (DC 12 V, 300 mA; optional) to the Power
Input Jack of the camera as shown below.
Power Input
Jack
Power Adapter
(Not supplied)
Adapter
Jack
ing the
Focus
BNC
ckwise
Monitor
e dam-
ed an
at a black
era.
Installation
Setu
Notes:
6-pin D
•When you disassemble the Dome Cover, lift the Dome Cover
Separatory Spring on the opposite side of LG Logo and turn the
Dome Cover clockwise simultaneously.
This cam
Switch fo
Dome Cover
Separatory Spring
• When you install the camera, handle with care. The camera
could be damaged by improper handling or storage.
•If this camera is mounted on the other places except ceiling,
you need an extra bracket for mounting.(not supplied)
10
1. ELC
ELC
(Auto
The
over
urn the
Setup
6-pin Dip Switch Setting
This camera has the 6-pin Dip
Switch for setting.
2. FL (Flickerless)
Use for removing the flicker of
picture.
The default setting is OFF.
3. AWB/HOLD
AWB (Auto White Balance),
HOLD (White Balance Hold).
The default setting is AWB.
4. BLC
Backlight compensation eliminates strong background light
which makes the camera picture dark such as a spotlight.
You can select the mode for
adjusting the iris lens.
The default setting is OFF.
5. L/L
Not used.
era
ing,
1. ELC / ALC
ELC (Electronic IRIS), ALC
(Auto IRIS) The default setting is ELC.
6. AGC (Auto Gain Control)
If the image are too dark,
change the maximum value to
make the image lighter. The
D&N function is activated automatically AGC ON mode.
The default setting is ON.
11
Troubleshooting
Check the following guide for the
possible cause of a problem before
contacting service.
The picture is poor
Does the Dome Cover have lots of
dust on the surface?
- Use a dry cloth to clean the
camera when it is dirty.
Smear may be caused to the
screen of night than daytime.
- Adjust the Focus by moving the
Focus Lens.
12
Dime
Contrast of the screen is not
clear.
Check the condition of the monitor.
A light source such as a spot light
causes burn-in on the display
screen. Adjust position or angle
of the camera to eliminate strong
background light.
Background screen appears
white extremely.
You can set the backlight
compensation to OFF.
not
Dimension
ø 100
monitor.
ot light
ay
ngle
trong
ars
76,5 mm
26,5 mm
ø 120
ø 90
13
Specifications
Model
Signal System
Total/Effective Pixels
Pick-Up Device
Lens
Angular Field of
View(D)
Focus
Signal Process
Scanning System
Sync. System
Scanning Frequency
Resolution
S/N Ratio
Standard Illumination
Minimun Illumination
Video Output Signal
Gain Control
Shutter speed
White Balance
Back Light
14
LD300P-B/C/D/E/F
LD300N-B/C/D/E/F
PAL
NTSC
470 K / 440 K
410 K / 380 K
8,5 mm interline color CCD(Super HAD)
Fixed Lens
(F=3,0 mm (LD300-B), 3,7 mm (LD300-C), 6,0 mm
(LD300-D), 8,0 mm (LD300-E), 12 mm (LD300-F))
115°(F=3,0 mm), 92°(f=3,7 mm), 54°(f=6 mm),
38,6°(f=8 mm), 25,7°(f=12 mm)
Manual
Digital Signal Process ( SS11X )
2:1 Interlace
Internal
50 Hz(VD)
59,94 Hz(VD)
520 TV Lines
More than 48 dB
2 000 lx (3 200 °K)
0,5 lx
1 Vp-p Composite (75 Ω)
Auto
1/50 to 1/10 000
1/60 to 1/10 000
Auto / Hold
Compensation Auto / OFF
Spec
Pow
Power
Oper
Stor
W
Dim
E/F
K
D)
6,0 mm
300-F))
mm),
Specifications
Model
Power Source
Power Consumption
Operating Temp.
Storage Temp.
Weight
Dimensions
LD300P-B/C/D/E/F
LD300N-B/C/D/E/F
DC 12 V
Less than 2,3 W
-10 ºC to 50 ºC (Humidity :0 % RH to 60 % RH)
-20 ºC to 60 ºC (Humidity :0 % RH to 85 % RH)
205 g
ø 120 (Diameter) x 76,5 mm(H)
)
00
15
AB28
Download PDF

advertising