LG | V-C2940NB | LG V-C2940NB Owner’s Manual

V-C2940NB/ND
V-C2940RB/RD/RT
V-C2950RDB/RDR
11
2
3
16
10
1
15
5
6
14
4
8
7
19
13
9
13
11
11
12
10
10
14
12
3
4
4,5
10,11
21
5
14
10
11
12
--2--
22
15
18
17
16
19
(V-C2940RB
/ RD / RT)
(V-C2950RDB/RDR)
MAX
20
MiN
(V-C2940NB/ND/)
21
23
25
27
24
26
28
29
30
--3--
E
Information for your
Assembling
safety
the tubes
(depending on model)
Plastic (4) or metal (5)
Fit together the two
slightly.
?
Please read all the
which contains
following information,
important instructions for the
safety, the use and the maintenance of
appliance.
This appliance complies with the following
the
-
?
EC
Never allow children to
use
the
appliance
by twisting
Telescopic tube (6)
Push spring latch (7) forward.
Pull out tube to required length.
Release spring latch to lock.
-
Directives: -73/23/EEC, 93/68/EEC-Low
Voltage Directive-89/336EEC -EMC Directive.
?
tube.
tubes
-
-
?
unsupervised.
Telescopic tube (8)
Release locking knob (9) (turn clockwise).
Pull out tube to required length.
Turn locking knob anti-clockwise as far as
-
-
?
Do not
is
?
use
the
damaged
or
If the mains lead
appliance
faulty.
-
it will go.
If the mains lead is
damaged, it must be
approved LG Electronics
replaced by an
Service Agent in
?
Always
?
If
cleaning
or
bag
cleaning the
is
filters.
inserted, the
cover
cannot be closed. Please do not
use
force!
?
Do not
vacuum
flammable
substances(liquids
?
Do not
?
or
explosive
Do not
hot ash, embers etc.
nor
vacuum
water
or
other
do not reach into the
The 2
position head (10) is equipped with
pedal (11) which allows you to alter its
position according to the type of floor to be
cleaned. Hard floor position(tiles, parquet
floors...). Press on the pedal to lower the
brush.Carpet or rug position. Press on
the pedal to lift the brush up.
running
If your appliance is equipped with an
automatic cleaning head (12) without
pedal, it automatically adapts to the
type of floor to be cleaned.
The accessories
liquids.
When you vacuum with an attachment
appliance that has a rotating brush roller:
?
?
gases).
obiects.
sharp
?
vacuum
or
head onto the end of the tube.
a
the dust
dustbag
no
hazard.
:
changing
changing
?
a
cleaner off
vaccum
?
before
?
order to avoid
switch the
the cleaning head and Accessory
Nozzles (depending on model) Fit the large
Using
?
For
brush
ible
roller.
vacuuming in those normally inaccessplaces i.e. reaching cobwebs, or down
the side of
WARNING!Should it become necessary to
replace the moulded on plug then the
?
detective
plug should be destroyed to avoid
any possible shock hazard that could occur
should such a plug be inserted into a 13
amp socket elsewhere in the house.
compartment contains
accessory (13).
Crevice Tool (14)
?
How to Use
a
sofa!
Upholstery Nozzle (15)
For vacuuming uphostery, mattresses,
The thread collectors help to pick up
threads and fluff.(option)
Dusting brush (16)
For vacuuming picture
etc.
the
frames furniture
outlines, books and other
uneven
objects.
(option)
Connecting
the flexible hose
(1) on the flexible
Push the end of the head
hose
(2)
vacuum
To
into the attachment
point
on
the
the flexible hose from the
plug
plug
use
To
--4--
length
into the socket.
Press button
cleaner, press on the button (3)
situated on the head, then pull upwards.
in and
Pull out the mains lead to the desired
and
cleaner.
remove
vacuum
How to
(17) to start the vacuum cleaner.
stop it press the button (17) again.
E
the power level
(depending on model)
Suction capacity increases steplessly up to
MAX.(19)
The flexible hose handle (20) has a manual
air flow regulator (21) which allows you to
briefly reduce the suction level.
Adjusting
?
?
and storage
Carrying
When you have switched off and unplugged
the appliance, press on the button (18) to
automatically
?
Use
rewind the cord.
stowage clip
(22).
shown when
as
motor filter
remover
vacuum
(29)and
to clean it
by tapping to
replacing it in the
the dirt and then
cleaner.
Cleaning
the exhaust filter
Check the exhaust filter
?
clean when
?
exhaust filter
Next
?
moter
storing
and
dirty.
Unplug cord from outlet.
Open the exhaust cover
?
(30)
occasion-ally
as
and
remove
shown.
procedures
safety filter.
the
are
same
as
the
the cleaner
Changing
the dust
The
needs
dustbag
changing
when the cleaner
is set to maximum power and the cleaner head
is off the floor but the "bag full" indicator
window
completely coloured red.
if the dustbag does not appear
this stage, it should be changed.
Even
full at
is
(23)
What to do if your
does not work
bag
to be
Check that the
?
?
?
a great deal of very fine dust
up the pores of the dust bag.
Turn off the appliance and unplug it.
Remove hose.
Open
the
cover
(24)
?
Your
appliance is equipped with either
bag or a fabric dust bag (25)
(depending on model)
a
paper dust
bag
(26),
arrow
filter
and
pull
towards the
bag
off the full paper
Remove the
and throw it away.
new paper filter
with the
arrow
pointing
bag
into the unit
downwards
(27).
If your appliance is fitted with a fabric dust bag follow the same instructions
as
above.
Empty
it and
Note:
as
it (28). Wash it periodically.
appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
fitted correctly.
reuse
the
the motor filter
Cleaning
The motor filter is situated inside the
appliance
between the dust
motor. Each time that you
outlet filter
we
bag and the
change the air
advise you to
remove
the
appliance
the
--5--
and
unplug
it.
Check that the tubes, flexible hose and
tool
are
not blocked.
Check that the dust
if necessary.
rear.
Insert the
Stop
cleaning
?
Push the lever forwards in the direction of
the
?
correctly plugged
working.
What to do when the suction
performance reduces?
clogged
?
?
is
in and that the electrical socket is
It could be that
has
appliance
appliance
bag
is not
full.Replace
P/No.: 3828Fi3817V
Download PDF

advertising