LG | V-CB584STR | LG V-CB584HTV Owner’s Manual

V-CB564ST/VTCB574SD
V-CB574ST/HT/HTQ/HTU/HEU/HEQ
V-CB584ST/STQ/SEQ/HT/HTQ/HTU/HEQ/HEU
Information for your
safety
-
If you stretch the elbow
to its
Please read all the
which contains
following information,
important instructions for the
safety, use and maintenance of the
appliance.
This appliance complies with the following EC
Directives:
Voltage
-73/23/EEC, 93/68/EEC-Low
Using
the
use
the
cleaning
Fit the
?
appliance
The
2-position head (6) is equipped with a
pedal (7) which allows you to alter its
position according to the type of floor to be
cleaned.
Hard floor
before
the
brush.
?
substances(liquids
Do not
vacuum
or
hot
?
cannot
or
vacuum
Turbine brush nozzle
explosive
-
embers etc.
sharp objects.
Do not
(30)
of hard floors
-
gases).
ash,
Hard Floor Nozzle
Efficient
force!
use
flammable
vacuum
water or other
or
cleaning
linoleum, etc.)
?
Do not
rug position. Press
lift the brush up.
Carpet
pedal to
?
be closed. Please do not
position (tiles, parquet
on the pedal to lower the
Press
floors...).
:
changing the dust bag.
changing or cleaning the filters.
If no dustbag is inserted, the cover
liquids.
How to Use
?
the flexible hose
Push the end of the
hose(2)
vacuum
To
situated
on
the flexible
point
on
the
the flexible hose from the
cleaner, press on the button(3)
the head, then pull upwards.
?
on
Assembling
the tubes
(depending on model)
Plastic (34) or metal (35) tube.
Fit together the two tubes by twisting
slightly.
?Telescopic tube(4)
Push spring latch(5) forward.
the
(wood,
(31)
pile carpet.
Cleaning turbine
brush nozzle (33)
Press the button on the rear side of the
nozzle to separate the air cover.
Use the dusting brush & crevice tool to
vacuum clean the brush and fan.
Crevice Tool
(8)
vacuuming
inaccessible places
or
?
cleaner.
remove
vacuum
head(1)
into the attachment
on
Air adjustment (32)
Slide the air control lever to the right for
long pile carpet and to the left for short
For
Connecting
Accessory
model)
head onto the end of
large cleaning
Do not
appliance if the supply
cord is damaged or faulty.
If the main lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent in order to avoid a hazard.
Always switch the vacuum cleaner off
on
the tube.
unsupervised.
use
head and
Nozzles (depending
Directive-89/336EEC -EMC Directive.
Never allow children to
tube, it is returned
position.
down the side of
in
i.e.
a
those
normally
reaching cobwebs,
sofa!
Dusting brush (9)
For vacuuming picture frames,
furniture
outlines, books and other
objects.
uneven
Upholstery Nozzle (10)
For vacuuming uphostery, mattresses, etc.
The thread collectors help to pick up the
threads and fluff.
?
-
-
-
Pull out tube to
required length.
Release
latch to lock.
spring
?Elbow tube(28)
-
The elbow tube is for
uses
such
How to
Adjusting
as
cleaning
(depending
be bent.
tube and the
the
grip
latch(29),
handle.
the elbow tube
can
use
the power level
on
model)
?
The flexible hose handle (13) has a
manual air flow regulator (14) which allows
you to briefly reduce the suction level.
?
Electronic power control (15)
Suction capacity increases smoothly up to
MAX.
-
telescopic
If you pull
in and
supply cord to the desired
length and plug into the socket.
Press button (12) to start the vacuum
cleaner. To stop it press the button (12) again.
under the sofa, table and bed easily.
Fit the elbow tube onto the end of the
-
plug
Pull out the
--4--
?
Electronic power control(26)
OFF:Power off MIN:Low power
The motor filter is situated inside the
MAX:Full power
appliance
example
to
move
outlet filter
during vacuuming, for
a small piece of furniture
the Park system
to support
rug,
the flexible hose and cleaning head.
or a
?
use
Slide the hook attached to the
tool into the slot
on
the
large cleaning
appliance.
of the
rear
Storage(17)
When you have switched off and unplugged
the appliance, press the button (11) to
automatically rewind the cord.
You
can
store your
move or
vertical
position by sliding
large cleaning head into
underside of the appliance.
the dust
Changing
The
dustbag
needs
appliance
the hook
the
clip
in
motor
window(18)
the dirt and then
cleaner.
Changing
on
the
is
the
bag
?
very fine dust
dust bag.
completely
?
?
clog
coloured
appliance is equipped with either a
paper dust bag (20) or a fabric dust bag
(25).(depending on model)
Take hold of the dust bag by the handle
and pull. Remove the bag and throw it
bag push
mount
If your appliance is fitted with a
fabric dust bag follow the same
as
it and
as
or
cleaned
the dirt.
anti-odor
be
changed
bag
every 6
Wash the washable HEPA filter with water
once a
year.
appliance
is
appliance
correctly plugged
working.
in and that the electrical socket is
What to do when the suction
performance reduces?
the
Check that the tubes, flexible hose and
cleaning tool are not blocked.
Check that the dust
unplug
it.
Stop
?
?
appliance
and
?
bag
is not
full.Replace
if necessary.
above.
replace it(25). Do not wash it.
appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
fitted correctly.
Empry
Note:
be
remove
should
filter
cover
the cardboard
support of a new bag into the bag
(21) until it will go no further.
instructions
it to
The electrostatic filter
Check that the
?
new
filter should
What to do if your
does not work?
appliance and unplug it.
Open the cover by pressing the hook(19)
and lifting it up until it snaps into place.
a
foam
at least
Turn off the
away.
To refit
of
rear
The
the
situated at
up the pores of the
Your
?
remove
compartment(23)
the appliance.
regularly. (approximately
changes)
does not appear to be
it should be changed, as
can
these filters
change
charcoal
dustbag
stage,
To
of the filter
?
full at this
the air outlet filters
regularly by tapping
when the
it in the
types of filters : foam filter or electrostatic
filter(24) or anti-odour charcoal filter or
washable HEPA filter(27).
?
changing
replacing
Depending on the model you have chosen
your appliance is equipped with different
?
the
red.
Even if the
bag and the
change the air
advise you to remove the
and to clean it by tapping to
remove
a
on
we
filter(22)
vacuum
cleaner is set to maximum power and the
cleaner head is off the floor but the "bag full"
indicator
between the dust
motor. Each time that you
Park-System(16)
For short breaks
the motor filter
Cleaning
?
the
--5--
Check that the air outlet filter is not
blocked.
Replace
if necessary.
http://www.lge.com/
P/No.: 3828Fi5891A
Download PDF

advertising