REFRIGERATOR OWNER'S MANUAL PLEASE READ THIS OWNER'S MANUAL THOROUGHLY BEFORE OPERATING AND KEEP IT HANDY FOR REFERENCE AT ALL TIMES. INSTALLATION ..................................................... FEATURE CHART OPERATION ................................................ ..................................................... 2 3 4~5 Starting Temperature Control Ice Making Defrosting SUGGESTIONS ON FOOD STORAGE CAN SERVER CLEANING ................ ................................................... 6~7 ............................................................ GENERAL INFORMATION IMPORTANT WARNINGS ................................... ..................................... REPOSITIONING THE DOOR HINGE(Option) BEFORE CALLING FOR SERVICE ... 5 8 8 9 10~11 .................... 12 P/No. 3828JS8020L 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지2 THIS REFRIGERATOR IS MANUFACTURED WITH GREAT CARE, AND UTILIZES THE LATEST IN TECHNOLOGY. WE ARE CONFIDENT THAT YOU WILL BE FULLY SATISFIED WITH IT'S PERFORMANCE AND RELIABILITY. BEFORE YOU START YOUR REFRIGERATOR, PLEASE READ THIS BOOKLET CAREFULLY. IT PROVIDES EXACT INSTRUCTIONS FOR INSTALLATION, OPERATION AND MAINTENANCE, AND ALSO SUPPLIES SOME USEFUL HINTS. INSTALLATION 1. Select Place good location. your refrigerator where 5. Clean your refrigerator thoroughly and all dust accumulated during shipping. a 2. Avoid placing the unit sunlight or moisture. near it is easy to use. heat sources, direct 6. Install accessories such in to 3. There must be proper air circulation around your refrigerator to keep it operating efficiently. more refrigerator and 2 inches be elevated 1 inch from the is 4. To avoid outlet. refrigerator must be level. Your required, adjust the leveling screw to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Leveling screw can be turned easily by tipping the cabinet slightly. Turn the leveling screw clockwise to raise the on the cooling. refrigerator is now ready ensure If unit, counterclockwise as Check the flow of cold air carpeted. vibrations, the unit same 8. Prior to use, leave your hours. from the wall. refrigerator should floor, especially if it ice tray, shelf, etc., their proper places.They are packed together prevent possible damage during shipment. the or The off 7. Connect the power supply cord (or plug) to the outlet. Don't double up with other appliances on If your refrigerator is placed in a recessed area in the wall, allow at least a 10 inch or greater clearance above the wipe on for 2 evaporator or to proper for use. 9. When you put in a power cord, please refer to the label situated on the back plate in order to classify to lower it. 2 the rating. 3 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지3 FEATURES CHART Evaporator Collects water Drip Tray during defrosting Thermostat Dial Ice For controlling the temperature in the refrigerator. Tray Door Rack Shelves Crisper or Magnetic Door Seal Can Supporter & Glass lid P.V.C Bar For fruits and Leveling (Optional) vegetables. Bar Screw 3 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지4 OPERATIONS STARTING When your refrigerator is first installed, allow it 2-3 hours to stabilize at normal before filling it with fresh food. If is operation interrupted, wait 5 minutes before operating temperature restarting. TEMPERATURE CONTROL Your the 4 3 refrigerator has a control that temperature in the refrigerator. Initially, 5 temperature, adjust the control to number, and for warmer temperature, adjust 2 control to 6 1 0 7 ICE MAKING To make ice on To cubes, fill the ice tray with the evaporator. remove ice cubes, hold the tray water and place at its ends and twist gently. TIP To regulate set the control at 4. For colder it let you remove before ice cubes easily, run water on the twisting. 4 tray a lower number. a higher the 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지5 OPERATION DEFROSTING It is necessary to regularly defrost your refrigerator in order to ensure efficient operation. The frost on the surface of the evaporator should not exceed a quarter of an inch (6mm) before defrosting. To defrost, turn the control to 0. Before you start the until it stops. When defrosting is defrosting operation, completed, Turn the control dial to a CAUTION: Never remove desired from the the food from the evaporator and drip tray, empty water, dry and put put it back in the fully drip tray fully until it stops. position. sharp evaporator. use remove or any metallic instruments to remove ice, frost, or ice trays SUGGESTIONS ON FOOD STORAGE STORING FOOD Store fresh food in the refrigerator. How food is frozen and thawed is an important factor in maintaining its freshness and flavor. Do not store food which goes bad Allow hot food to cool to higher easily at low prior to storing. Placing temperatures, hot food in the such as refrigerator could spoil other food and lead electric bills! When storing, cover food with vinyl wrap or store in a container with evaporating and helps food to keep its taste and nutrients. Do not open the door temperatures to rise. Do not store bottles Always bananas, pineapples, and melons. frequently. Opening on the evaporator - the door lets they lid. This air enter the prevents moisture from refrigerator, causing may break when frozen. clean food food should be warm a prior to refrigeration. Vegetables and fruits should wiped clean to prevent adjacent food from spoiling. 5 be washed and wiped, and packed 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지6 CAN SERVER Insert cans at the top and pull At least them out from the bottom. No one or more cans FILNGTHERACK Lift up REMOVAL 6 slightly and pull out. 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지7 CAN SERVER Door liner can Cans may fall. RECOMMENDED It is possible to put a can at the bottom when there are no cans 7 in the storage. be torn out. 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지8 CLEANING It is important that your refrigerator be kept clean to prevent undesirable odors. Spilled food should be wiped up immediately, since it may acidify stain plastic surfaces if allowed to settle. Never - and metallic WARNING Before you clean, however, remember that damp objects will stick or adhere to extremely cold surfaces. Do not touch frozen surfaces with wet Always remove the power cord from the wall outlet prior to cleaning in the vicinity of electrical parts. Wipe up excess moisture with a sponge or cloth to prevent water or liquid from getting into any electrical part and causing a electric shock. Do not use flammable or toxic cleaning liquids. or hands. EXTERIOR lukewarm solution of mild soap to clean the durable finish of your - Use detergent refrigerator. Wipe then dry. or of the interior and parts is recommended. Disconnect the power supply, and remove food and shelves, trays, etc. Wash all compartments and shelves, trays etc. with a baking soda solution. Rinse and dry. any surface. damp Regular cleaning interior scouring pads, brushes, coarse cleaners, or strong alkaline solutions on use abrasive INTERIOR a with a clean, damp cloth and GENERAL INFORMATION VACATION TIME IF YOU MOVE average length vacations, you will probably find it best to leave the refrigerator in operation. Remove securely fasten down all loose items inside the refrigerator. To avoid damaging the leveling screw(s), turn them During When you remove all plan the interior thoroughly, prevent to be away for an extended period, food, disconnect the power cord, clean or all the way into the base. and leave the door OPEN to odor formation. ANTI-CONDENSATION PIPE The outside wall of the POWER FAILURE Most power failures are corrected within two and will not affect your refrigerator refrigerator an hour cabinet may sometimes get warm, especially just after or temperatures. However, you should minimize the number of door openings while the power is off. During power failures of longer duration, place a block of dry ice on top of your frozen packages. installation. Don't be alarmed. This is due to the anti-condensation pipe, which pumps hot refrigerant to prevent "sweating" on the outer cabinet wall. 8 Anti-Condensation Pipe 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지9 IMPORTANT WARNINGS DO NOT USE AN EXTENSION CORD If connect the possible, household or refrigerator to its own lights from causing an overload individual electrical outlet to that could cause a prevent power outage. it and other appliances POWER CORD REPLACEMENT If the supply cord service agent. is ABOUT GROUNDING In the event of an an it must be damaged, replaced by a special cord available from the manufacturer or its (EARTHING) electric short circuit, grounding (earthing) reduces the risk of electric shock by providing escape wire for the electric current. In order to Improper prevent possible electric of the grounding plug person if the grounding instructions appliance is properly grounded. use shock, this appliance can result in are not an must be grounded. electric shock. Consult completely understood, or a qualified electrician if you have doubts on or service whether the ACCESSIBILITY OF SUPPLY PLUG The refrigerator-freezer should when accident happens. be so positioned that the This VERY DANGEROUS ATTRACTION An empty refrigerator can be a attraction to children. Remove dangerous the gasket, latch, is accessible for appliance must be quick disconnection grounded (earthed.) DON'T WAIT! DO IT NOW! the entire door from your unused appliance, or take some other action to make it lid, supply plug or NEVER STORE EXPLOSIVES AND CHEMICALS harmless. 9 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지10 REPOSITIONING THE DOOR HINGE(Option) Your to refrigerator is designed with a reversible door so it may open from either the left or the right. reposition the door hinge as necessary at the outset since it is inconvenient to do so later. To change the door hinge, please refer to the diagram below and proceed as It is best follows. F G H CE D A B 1. Remove all loose 2. Carefully lay Take care the not to 3. Unscrew and fittings 6. Gently pull 7. Before remove on the the Adjustable the door downwards to the Foot need assistance to achieve this). (A). Hinge (D) by unscrewing Leg (H) by unscrewing refitting appliance. appliance on its back on the original packing (You will damage the pipework by keeping it clear of the floor. 4. Remove the Lower 5. Remove the from inside the the bolt remove the 2 Bolts attaching it (B). (C). it. door, swap the Hinge Cap (F) by prying it from its the other side of the door. Care should be taken not to Hinge Cap. 10 damage current location and the adjacent surfaces repositioning it when removing 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지11 REPOSITIONING THE DOOR 8. Unscrew the 9. Now secure 10. Replace 11. Carefully and Upper Hinge pin (G) the Lower the Hinge (D) Adjustable stand the Foot appliance screw it into the to the cabinet (A), setting up, (you it at using HINGE(Option) opposite side hole in the the 2 Bolts approximately 20 of the cabinet. top (B). mm. will need assistance to do this,) and position it in its permanent location. 12. Check that the door opens and closes easily. Ensure that the door seal does not bind creating gaps which would allow air into the interior. Adjust the hinges if necessary. This the hinge side firm, level floor with sufficient space for free airflow around it. (At least 10 mm all round and, subject to location, 20 mm beneath the worksurface). Avoid positions close to walls or corners. There must be sufficient room for free ventilation, particularly at the back. The unit should be located away from direct heat sources, such as cookers, radiators, and direct sunlight. If the unit is positioned where the temperature is too low, condensation will form on the outside of the cabinet. Normal room temperature is recommended. appliance should be stood on on a Avoid locations which may be affected by drafts or dampness, product. 11 as this will impair the efficiency of the 3828JD8497F(O/M)씁어내지 2003.5.27 10:26 AM 페이지12 BEFORE CALLING FOR SERVICE SERVICE CALLS CAN OFTEN BE AVOIDED! IF YOU FEEL YOUR REFRIGERATOR IS NOT OPERATING CAUSES FIRST PROPERLY, CHECK THESE POSSIBLE : PROBLEM POSSIBLE CAUSES REFRIGERATOR DOES Has NOT OPERATE Has the power cord plug been removed from the electrical wall outlet? TEMPERATURE Temperature control not set on proper position. Appliance is placed close to wall or heat source. Warm weather-frequent door openings. Door left open for a long time. Large amount of foods are kept in the refrigerator. TOO WARM ABNORMAL NOISE(S) a house fuse blown or circuit breaker Refrigerator is installed in a weak or or leveling screw needs adjusting. Unnecessary objects placed refrigerator. REFRIGERATOR Foods with HAS ODOR or strong tripped? or loosened uneven in the back side of the odors should be tightly covered wrapped. Interior needs DEW FORMS ON THE Not unusual CABINET SURFACE Door may 12 place cleaning. during periods of high humidity. have been left ajar.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project