LG | V-G1 | Owner's Manual | LG V-G1 Owner's manual

LG V-G1 Owner's manual
V-G1
7
2
1
8
3
3
6
4
5
4
9
8
7
10
6
11
13
14
12
Information for your
Always
safety
before
switch the
vaccum
cleaner off
:
changing the dust bag
changing or cleaning the filters.
If no dustbag is inserted, the cover
?
Please read all the following information,
which contains important instructions for the
safety, the use and the maintenance of the
appliance. This appliance complies with the
following EC Directives: -73/23/EEC,
93/68/EEC-Low
DirectiveVoltage
89/336EEC -EMC Directive.
Never allow children to use the appliance
unsupervised.
Do not use the appliance If the mains
lead is damaged or faulty.
If the mains lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent as special tools are
needed to repair it.
--2--
?
cannot
be closed. Please do not use force!
Do not vacuum flammable or explosive
substances(liquids
Do not
vacuum
or
gases).
hot ash, embers etc.
nor
sharp objects.
Do not vacuum water or other liquids.
Please make sure when using the
carrying starp that it is securely fitted.
When you vacuum with an attachment
appliance that has a rotating brush roller:
do not reach into the running brush
roller.
?
Important for users in the UK.
The wires in the mains lead of this appliance
are coloured in accordance with the
following code:
Using the
Accessory
BROWN live
BLUE-neutral
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the
terminals in your plug,
?
-
PROCEED AS FOLLOWS:
The wire which is coloured BROWN must
be connected to the terminal which is
marked L or coloured RED.
The wire which is coloured BLUE must be
connected to the terminal which is marked N
or coloured BLACK!
VERY IMPORTANT:
Neither wire is to be connected to the earth
terminal of a 3 pin plug. If a 13 amp plug is
fitted, fit a 13 amp BS 1362 fuse.
If any other type of plug is used, protect with
a 15 amp fuse at the distribution board.
For appliances which come with mains lead
and plug moulded on : the plug moulded on
to the cord incorporates a fuse.
For replacement use a 13 amp BS 1362
fuse. Only ASTA approved or certified fuses
should be used.
The fuse cover/carrier must be replaced in
the event of changing the fuse.
The plug must not be used if the fuse
cover/carrier is lost. A replacement cover/
carrier must be obtained from authorised
electrical goods retailers.
WARNING!Should it become necessary to
replace the moulded on plug then the
detective plug should be destroyed to avoid
any possible shock hazard that could occur
should such a plug be inserted into a 13
amp socket elsewhere in the house.
How to Use
Fitting
?
?
?
How to
?
?
plug
in and
model) Fit the large cleaning head onto the
end of the tube.
The 2 position head(4) is equipped with a
pedal(5) which allows you to alter its
position according to the type of floor to be
cleaned. Hard floor position (tiles,
parquet floors...). Press on the pedal to
lower the brush.Carpet or rug position.
Press on the pedal to lift the brush up.
If your appliance is equipped with an
?
automatic cleaning head(6) without
pedal, it automatically adapts to the
type of floor to be cleaned.
Crevice Tool(7)
For vacuuming in those normally inaccessible places i.e. reaching cobwebs, or down
the side of a sofa!
?
Upholstery Nozzle(8)
For vacuuming uphostery, mattresses,
The thread collectors help to pick up
?
use
(3)
Release the power cord which is wound on
the two cord retainers and plug into the
socket.
Press button to start the vacuum cleaner.< >
To stop it press button.<
>
etc.
the
threads and fluff.
Changing
the dust
bag
Turn off the appliance and unplug it.
Open the cover.(9)
Your appliance is equipped with either
paper dust bag or a fabric dust bag (10)
?
?
(depending
on
a
model)
Push the lever forwards in the direction of
the arrow(11) and pull off the full paper
filter bag towards the rear. Remove the
bag and throw it away.
Insert the new paper filter bag into the unit
with the arrow pointing downwards (12).
?
?
If your appliance is fitted with a fabric
dust bag follow the same instructions as
above. Empty it and replace it(13). Do not
wash it.
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
fitted correctly.
Cleaning
the handle
Fit the tube(1) to the upper section and
press down firmly.
Fit the handle(2) to the tube and press
down firmly.
Fit the handle(2) to the upper section and
press down firmly.
cleaning head and
Nozzles (depending on
the motor filter
The motor filter is situated inside the
appliance between the dust bag and the
motor. Each time that you change the air
outlet filter we advise you to remove the
motor filter(14)and to clean it by tapping to
remove the dirt and then replacing it in the
vacuum cleaner.
What to do if your
does not work
appliance
Check that the appliance is correctly plugged
in and that the electrical socket is working.
--3--
P/No.: 3828Fi2004A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising