LG | NP3530 | LG NP3530 Owner’s Manual

Charging
Product Overview
Bluetooth Connection
App Installation
Wired Connection
To use this unit more comfortably, install “LG Bluetooth Remote” on
your bluetooth devices. Select a way of installation ( , or ).
Wireless Speaker
ON
NP3530
NFC for Easy Pairing: You can pair simply and easily by
tapping your smartphone on to the NFC sticker.
Press and hold to turn on the unit.
Approx. 3 hours
Searching for “LG Bluetooth Remote” on the
Google Play Store.
Note
Operating time is approx. 15 hours. (Based on 30% volume, 1 kHz
signal, 500 mV portable input and fully charged status)
It may vary depending on the battery status and operational
conditions.
Within 10 m
Scanning QR code below.
Press and hold to turn on or off.
Select “LG Portable(XX:XX)” on your Bluetooth device.
(XX:XX means the last four digits of BT address.)
yy Depending on the bluetooth device, you need to enter the PIN code (0000).
yy Once a pairing operation is performed, it does not need to be performed
again every time you turn on the unit. (Only if the PORT.IN is not connected
and the unit is registered on the Bulutooth device.)
ENGLISH OWNER’S MANUAL
Please read this manual carefully before operating your set and retain it
for future reference.
Note: When bluetooth device is connected without BT remote
App, PORT. IN connection does NOT work.
FOR THE GUARANTEE TERMS & CONDITIONS, PLEASE REFER TO LAST
SECTION ON THE OTHER SIDE.
Tagging on the NFC sticker, if available.
Press and hold to disconnect.
http://www.lg.com
Safety Information
About LED Indicator
Using handsfree function
Additional Information
About Ferrite Core (Optional)
LG Bluetooth Remote
Preparation: Your smartphone must be paired with the unit via bluetooth.
Turned on red
Turned on white
Turned off
Beep sound
Scan to install the App.
In Charging
Press to hang up the call.
Fully Charged (Power Off mode)
Resetting
X2
In Charging
Fully Charged (Power On mode)
X2
X2
Power is turned on.
X2
Bluetooth is paired.
X2
X2
X2
5 V 0 2.0 A
Battery is discharged. (Blinks rapidly.)
X2
Press to accept an incoming call.
X2
X2
X2
Reset hole
In case that the unit freezes due to malfunction, press the reset
hole for 5 seconds using an object like a thin pin.
Notice for Auto Power Off
This unit is turned off automatically, if no button is pressed for 6
hours when the bluetooth is disconnected.
How to attach the ferrite core
This ferrite core can reduce noises.
1. Pull the stopper [a] of the ferrite core to open.
2. Wind the portable cable and USB cable on the ferrite core.
3. Close the ferrite core until it clicks.
A button is pressed.
The unit operates abnormally. Leave the unit at room temperature (0 - 35 °C) for a while and try again.
X2
X2
X2
Press and hold to toggle the voice output.
Press and hold to reject an incoming call.
NP3530-B0_BGBRLLK_OM_MFL67786228_20130419.indd 1
2013-04-25 �� 11:55:53
Specification
Power Supply:
-- 5 V 0 2.0 A (AC Adapter)
-- Built-in rechargeable battery
AC Adaptor:
-- Model: WB-10A05FK
-- Manufacturer: Yang Ming Industrial
-- Input: AC100-240 V, 50/60 Hz
-- Output: 5 V 0 2.0 A
Dimensions (W x H x D):
-- Approx. 193 mm x 65 mm x 65 mm
Net Weight:
-- Approx. 520 g
Operating Temperature:
-- 0 °C to 35 °C
Operating Humidity:
-- 5 % to 60 %
External Connector:
-- ø 3.5 mm mini jack
-- Micro USB port for charging battery
Communication:
-- Bluetooth 3.0
Amplifier:
-- 3 W + 3 W (8 Ω at 1 kHz)
-- THD: 10%
Speaker:
-- Type : Built-in
-- Impedance Rate : 8 Ω
-- Rated Input Power : 3 W
-- Max. Input Power : 6 W
Android O/S for App installation:
-- Version 2.3.3 (or higher)
yy Design and specifications are subject to change without notice.
Troubleshooting
No power
yy The battery is discharged. Recharge the battery.
yy Connect the unit to the power supply with the AC adapter
No sound or sound distortion
yy The unit or your smart device’s volume is set to minimum. Check and adjust the
volume of the unit or bluetooth device’s volume.
yy When you use an external device at high volume, the sound quality may be
deteriorated. Lower the volume of the devices.
yy If you use the unit for purposes other than listening to music, the sound quality may
be lowered or the unit may not work properly.
Bluetooth pairing does not work well.
yy Switch bluetooth off and on again on your bluetooth device, then try pairing again.
yy Be sure your bluetooth device is on.
yy Remove the obstacle in the path of the bluetooth device and the unit.
yy Depending on the type of the bluetooth device or surrounding environment, your
device may not be paired with the unit.
yy While using Bluetooth, you may not be able to activate BT app. Disconnect
Bluetooth device you have connected before to use BT app properly.
yy When your Bluetooth device have been already connected with other unit,
disconnect the Bluetooth connection first. Then you can control your unit through
BT app.
yy Depending on the Bluetooth device, BT app may work restrictively not work.
yy The connection you’ve made may be disconnected if you select other application
or change the setting of the connected device via BT app. In such case, please
check the connection status.
The unit does not operate normally.
yy In case of malfunction, LED indicator is lit in red and white alternately. Please use
the unit in proper place where the temperature or humidity is not so high or low.
Safety Information
WARNING:
yy To prevent fire or electric shock hazard, do not expose this product to rain or
moisture.
yy Do not install this equipment in a confined space such as a book case or similar
unit.
CAUTION:
yy The apparatus should not be exposed to water (dripping or splashing) and no
objects filled with liquids, such as vases, should be placed on the apparatus.
yy No naked flame sources, such as lighted candles, should be placed on the
apparatus.
yy Internal lithium battery in the unit should not be replaced by user because of
danger of explosion if battery is incorrectly replaced ,and must be replaced with the
same type battery by expert.
yy Only use the AC adaptor supplied with this device. Do not use a power supply from
another device or another manufacturer. Using any other power cable or power
supply may cause damage to the device and void your warranty.
yy To avoid fire or electric shock, do not open the unit. contact to qualified personnel
only.
yy Do not leave the unit in a place near the heating appliances or subject to direct
sunlight, moisture, or mechanical shock.
yy To clean the unit, use a soft, dry cloth. If the surfaces are extremely dirty, use a soft
cloth lightly moistened with a mild detergent solution. Do not use strong solvents
such as alcohol, benzine, or thinner, as these might damage the surface of the unit.
yy Do not use volatile liquids such as insecticide spray near the unit.Wiping with
strong pressure may damage the surface. Do not leave rubber or plastic products in
contact with the unit for a long period of time.
yy Do not place the unit over the vehicle’s air bag. When the air bag deploys, it may
result in injury. Before using in the car, fix the unit.
yy Do not use the handsfree function during driving a car.
yy Do not leave the unit on an unstable place such as high shelves. it may fall down
because of the vibration of the sound.
Disposal of waste batteries/accumulators
1. When this crossed-out wheeled bin symbol is attached to batteries/
accumulators of Your product it means they are covered by
European Directive 2006/66/EC.
2. This symbol may be combined with chemical symbols for
mercury(Hg), cadmium(Cd) or lead(Pb) if the battery Contains more
that 0.0005% of mercury,0.002% of cadmium or 0.004% of lead.
3. All batteries/accumulators should be disposed separately from the municipal
waste stream via designated collection facilities appointed by the government or
the local authorities.
4. The correct disposal of Your old batteries/accumulators will help to prevent
potential negative consequences for the environment, animal and human health.
5. For more detailed information about disposal of Your old batteries/accumulators,
please contact Your city office, waste disposal service or the shop where You
purchased the product.
For Wireless product European Union Notice
LG Electronics hereby declares that this/these
product(s) is/are in compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC, 2004/108/EC, 2006/95/EC, 2009/125/EC and 2011/65/EU.
CAUTION concerning the Power Cord
Most appliances recommend they be placed upon a dedicated circuit;
That is, a single outlet circuit which powers only that appliance and has no additional
outlets or branch circuits. Check the specification page of this owner’s manual to be
certain. Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall
outlets, extension cords, frayed power cords, or damaged or cracked wire insulation
are dangerous. Any of these conditions could result in electric shock or fire. Periodically
examine the cord of your appliance, and if its appearance indicates damage or
deterioration, unplug it, discontinue use of the appliance, and have the cord replaced
with an exact replacement part by an authorized service center. Protect the power cord
from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in
a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point
where the cord exits the appliance. To disconnect power from the mains, pull out the
mains cord plug. When installing the product, ensure that the plug is easily accessible.
Please contact to the following address for obtaining a copy of the DoC (Declaration of
Conformity).
This device is equipped with a portable battery or accumulator.
Safety way to remove the battery or the battery from the equipment: Remove
the old battery or battery pack, follow the steps in reverse order than the assembly.
To prevent contamination of the environment and bring on possible threat to human
and animal health, the old battery or the battery put it in the appropriate container at
designated collection points. Do not dispose of batteries or battery together with other
waste. It is recommended that you use local, free reimbursement systems batteries and
accumulators. The battery shall not be exposed to excessive heat such as sunshine, fire
or the like.
POWER: This unit operates on a mains supply of 100-240V~, 50/60Hz.
Wiring: This unit is supplied with a BS 1363 approved main plug. When replacing
the fuse, always use of the same rating approved to BS 1362. Never use this plug
with the fuse cover omitted. To obtain a replacement fuse cover contact your
dealer. If the type of plug supplied is not suitable for the mains sockets in your
home, then the plug should be removed and a suitable type fitted. Please refer to
the wiring instructions below:
Warning: A mains plug removed from the mains lead of this unit must be
destroyed. A mains plug with bared wires is hazardous if inserted in a mains socket.
Do not connect either wire to the earth pin, marked with the letter E or with the
earth symbol 6 or coloured green or green and yellow. If any other plug is fitted,
use same rating of fuse in the plug.
Important: The wires in this mains lead are coloured in accordance with the
following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the wires in the mains
lead of this unit may not correspond with the coloured marking identifying the
terminals in your plug, proceed as follows: The wire which is coloured blue must be
connected to the terminal which is marked with the letter N or coloured black. The
wire which is coloured brown must be connected to the terminal which is marked
with the letter L or coloured red.
NOTICE: For safety making information including product identification and supply
ratings, please refer to the main label on the bottom of the apparatus.
NP3530-B0_BGBRLLK_OM_MFL67786228_20130419.indd 2
Disposal of your old appliance
1. When this crossed-out wheeled bin symbol is attached to a product
it means the product is covered by the European Directive 2002/96/
EC.
2. All electrical and electronic products should be disposed of
separately from the municipal waste stream via designated collection
facilities appointed by the government or the local authorities.
3. The correct disposal of your old appliance will help prevent potential negative
consequences for the environment and human health.
4. For more detailed information about disposal of your old appliance, please contact
your city office, waste disposal service or the shop where you purchased the
product.
Contact office for compliance of this product:
LG Electronics Inc.
EU Representative, Krijgsman 1,
1186 DM Amstelveen, The Netherlands
yy Please note that this is NOT a Customer Service contact point. For Customer Service
Information, see Warranty Card or contact the dealer that you purchased this
product.
Technology with the human touch
GUARANTEE
• LG Electronics U.K. Ltd. will provide the following services in order toexpedite this Guarantee.
1. All faulty components which fail due to defective manufacture will be replaced free of charge for a period of 12 months from the
original date of purchase.
2. The dealer (or his service agent) who sold the product will be
reimbursed for any labour provided in the repair of this LG equipment, for a period of 12 months from the original date of
purchase. These claims must be made in accordance with the published scale of
service charges and relevant claims procedure.
PLEASE NOTE:
A. The dealer may restrict the guarantee to the original purchaser.
B. The dealer is not obliged to carry out service under guarantee if unauthorized modifications are made to the apparatus, or if non
standard components are used or if the serial number of the apparatus is removed, defaced, misused, or altered.
C. Any claims made under guarantee must be directed to the dealer from whom the equipment was originally purchased. The
dealer may, before carrying out service under guarantee, require a receipted account as evidence of the date of purchase.
D. We respectfully point out that your dealer is not obligated to replace batteries if they become exhausted or worn in use.
E. Aerial alignment and consumer control adjustments are not covered by this guarantee.
This guarantee does not affect your statutory rights.
• REQUIREMENTS TO MAINTAIN WARRANTY COVERAGE:
RETAIN YOUR RECEIPT TO PROVE DATE OF PURCHASE. A COPY OF YOUR RECEIPT MUST BE SURRENDERED AT THE TIME
GUARANTEE SERVICE IS PROVED.
• Product Registration Card :
It is helpful to complete at least your name, address, phone, model & serial numbers and return it. This will enable LG to assist
you in the future should you lose your receipt, your units be stolen, or should modifications be necessary.
• To obtain information or assistance: Call 0870 873 5454 Monday-Friday 9.00am-4.30pm
MODEL NO.*
SERIAL NO.*
DATE OF PURCHASE.*
Indoor use only.
RF Radiation Exposure Statement
This equipment should be installed and operated with minimum distance 20 cm
between the radiator and your body.
In all cases of difficulty - consult your LG dealer from whom the product was purchased
LGEUK Website : www.lg.com
( service website : www.lgservice.com)
2013-04-25 �� 11:55:54
Download PDF