Interface Board OWNER'S MANUAL Please read this manual carefully before installing the Interface Board. Retain it for future reference. Record model number and serial number of the Interface Board. See the label attached on the Interface Board and quote this information to your dealer when you require service. Model number : Serial number : P/NO : 3828VA0581A Instructions Safety WARNING WARNING To prevent fire expose the Make product to rain to sure this installing shock or unplug product. Otherwise it may electric shock. hazard, do moisture. or the fire cause a not monitor or could before give an SERVICE SER VICE Never remove this the back cover of the monitor expose you to very and other hazards. as If this can does not product high voltage operate properly, call your dealer. AP-42/50EM15 AP-42/50EM15T AP-42/50EX40 AP-42/50EX40T AP-60EZ90 L L R R AUDIO OUPUT MONITOR COMPONENTINPUT1 COMPONENTINPUT2 (MONO) L R VIDEO S-VIDEO OUPUT MONITOR COMPONENTINPUT1 COMPONENTINPUT2 AUDIO Antenna L R A/V INPUT AUDIO PR (MONO) L R VIDEO S-VIDEO AUDIO L R AUDO PR PB Y A/V INPUT AUDO PB Y VIDEO AP-42/50EM16T VIDEO AP-42/50EM16 AV2 AUDIO L VIDEO PR COMPONENTINPUT AV3 R (MONO) AV2 AV1 AUDIO Antenna VIDEO PB PR Y VIDEO S-VIDEO VIDEO S-VIDEO COMPONENTINPUT AV3 (MONO) PB Y L R AV1 For Interface Board customers The Interface Board is for Plasma monitor. To the Interface Board, install this Interface Board on the Plasma monitor. use Refer to Manual for Plasma monitor Owner's this Interface Board. operating Installing Board on Monitor Interface the ACINPUT (L XTENALSEAKER ) L OL R EOT RMO T) RGB1OUTPUT PCDT UTPU VO NPUT OI AUDI NPUT) RGB1NPUT (CDTV I UT) NP BI G RGB2NPUT TALR I E) NPUT C I LSRI 32CO RSCONTR a. Turn the monitor off and disconnect the mains plug. b. As shown, side down Remove the with (In a screen retaining from damage. screws on from the PB PR R A/VINPUT R R Antenna(75Ω) L AUDIO (MONO) VIDEO S-VIDEO R PR L COMPONENTINPUT (MONO) AV3 AV1 S-VIDEO position. the AV2 Antenna(75Ω) VIDEO d. Insert the Interface Board Tighten L AUDIO AUDIO VIDEO PB MONITOR OUPUT L AUDIO VIDEO Y cover. Monitor.) COMPONENTINPUT1 e. cover models, separate the Desktop Stand COMPONENTINPUT2 rect the screwdriver and then lift off the some Y screen cushioned surface that will on a protect the monitor c. the Monitor carefully place Make sure screws. gently into the it is inserted cor- correctly.