LG | V-5000HT | LG V-5000T Owner’s Manual

K
Vacuum Cleaner
OWNER'S MANUAL
MODEL : V-5060CT (Hose-Button Control, Booster, Telescopic Pipe)
V-5000CT (Hose-Button Control, Telescopic Pipe)
V-5000CD (Hose-Button Control, 2-Steel Pipes)
V-5000HT/V-5004HT (Hose-Slide Control, Telescopic Pipe)
V-5000HD (Hose-Slide Control, 2-Steel pipes)
V-5000T (Body Slide Control, Telescopic Pipe)
V-5200T/V-5300T (Body Slide Control, Telescopic Pipe)
V-5000D (Body Slide Control, 2-Steel pipes)
V-5010T
V-5010D
(Body-On/Off, Telescopic Pipe)
(Body-On/Off, 2-Steel Pipes)
Please read carefully and thoroughly the operating instructions and
safety precautions before installing and operating your vacuum
cleaner.
M
K
SAFETY
SAFETY
SAFETY
SAFETY
Solvent
1
2
4
3
Red mark
Yellow mark
3-1
handle
5
6
7
9
10
11
8
12
Dust Indicator
Floor
13
14
15
16
17
18
19
20
1
2
-2-
21
22
CAUTION
23
Take
when setting the
dust bag.
care
Flexible Hose
V-5060CT
Button Switch
Control Cover
V-5000CT
V-5000CD
V-5060CT
V-5000CT
V-5000CD
V-5000HT
V-5004HT
Slide Switch
V-5000T
V-5000D
V-5000HD
V-5000HT
Air
V-5004HT
Adjustment
V-5000HD
V-5010T
V-5010D
V-5000T
V-5000D
Extension
Cord rewind button
V-5010T
pipes
V-5010D
Telescopic Pipe
Control Cover
Plug
(V-5060CT)
(V-5000CT)
(V-5000HT)
(V-5004HT)
(V-5000T)
(V-5010T)
Steel Pipe
(V-5000CD)
(V-5000HD)
(V-5000D)
(V-5010D)
Body
Switch
button
Dust indicator
(ON/OFF)
Suction inlet
Castor
Latch
(depending
on
model)
ACCESSORIES
Nozzle
(depending
on
model)
Accessory holder
-3-
Upholstery nozzle Crevice tool Dusting
brush
IMPORTANT SAFEGUARDS
a
clear
using an electrical appliance, basic safety
precautions should always be followed, to reduce
the risk of fire, electric shock and injury to persons,
including the following:
17 Take electrical
18 Use this
a
READ ALL INSTRUCTIONS BEFORE
USING THIS APPLIANCE
20
WARNING
Disconnect power supply before servicing and/or
the unit. If not, electric shock could occur
21
cleaning
and/or cleaner could
1 Do not leave
suddenly
the outlet when not in
servicing
2 Do not
pick
start.
use or
outdoors
use
3 Do not handle
22
it from
before
home
plug
or
as a
by
toy. Close
1
atten-
tion.
manufacturer's recommended attach-
supply
cord is
by
larly qualified
pull
dle, close
damaged,
a
or
it must be
its service
agent
person in order to avoid
a
(fig.1)
To
hazard.
carry by the power cord as a handoor on cord, or pull the cord around
or corners.
the cord.
Keep
Do not
run
1)
appliance
cord. To
remove
the HOSE.
of the v/cleaner until
pull
depress
the hose
Adjustment.
(V-5000CT, V-5000HT, V-5004HT, V-5010T,
V-5000T,V-5060CT) (fig. 3)
Push the slider control downwards to extend
unplug,
or/ retract extension
pipes.
put any object into openings. Do not use
with any openings blocked; keep free of dust. lint,
hair, and anything that may reduce air flow.
2 Pieces STEEL PIPES
Keep hair, loose clothing, fingers, and all parts of
body away from the openings. Do not use vacuum cleaner(v/cleaner) to pick up sharp hard
objects, small toys, pins, etc.
3)
TELESCOPIC EXTENSION PIPES
(V-5000D,V-5010D,
V-5000CD,V-5000HD,)
Insert the STEEL PIPES firmly each other. (fig.1)
9 Do not
ing,
pick
such
(V-5000CT, V-5000HT, V-5004HT, V-5010T,
V-5000T,V-5060CT) (fig. 3-1)
Push the handle to extend or/ retract extension
pipes.
anything that is burning or smokcigarettes, matches, or fireplace
up
as
4 Pull the main
up flammable
liquid or vapors such as gasoline
where they may exist.
13 Do not
use
to
pick
use vacuum
fiters in the
Always
plug
out of the
vacuum
cleaner and
insert into the socket outlet.
ashes.
12 Do not
clamp
TELESCOPIC EXTENSION PIPES
2)
11 Do not
a
out.
3 EXTENSION PIPES
the cord away from heated
unplug by pulling the
plug, not the cord.
(fig. 2)
body
sound is heard.
button and
grasp the
14
the nozzle, the extension pipes and the
narrow section into the wide sec-
insert the
clicking
simi-
or a
surfaces.
10
:
Insert the HOSE into
replaced
or
sharp edges
8 Do not
out the cord
2 HOSE Connection.
the manufacturer
over
Connecting
handle
children
ments.
7 Do not
beyond the red mark.
Pulling the cord out past the red mark may cause
problems with the cord reel.
Do not use dry cleaning solvent in toxic or
flammable. It may result in the surface damage.
Wipe off the dirty place with a clean cloth.
Do not allow sharp or heavy objects to rest on the
power cord. If the power cord is damaged or
frayed, it may cause a fire or electric shock.
The use of radio transmitting devices close to the
appliance may interfere the function of the appliance, input power may vary.
pull
USING THE VACUUM CLEANER
with wet hands.
appliance
tion is necessary when used
6 If the
cleaner.
vacuum
wet surfaces. Do not
or on
wet material.
or
4 Do not allow it to be used
only
Unplug
.
up the water
5 Use
in.
appliance plugged
inspection when hose is cracked
peeled off.
v/cleaner only for those jobs expected for
and its coat is
19 Do not
or
plug when rewinding
plug to whip when
rewinding.
When
ASSEMBLING
and hold the
path
onto cord reel. Do not allow the
Do not
combustible
or use
cleaner without dust
in
bag
and
moves
unplugging.
when
rewinding.
(fig.4)
beyond the
5 Press the ON/OFF switch
on
rapidly
the cord
red mark.
socket outlet and press the cord reel button. The
cord will be automatically rewound.
the chairs, tables, etc.
keep
Extra care must be taken when cleaning stairs.
16 The cord
v/cleaner
pull
Pulling the cord out past the red mark may cause
problems with the cord rewinding system.
When cleaning is completed, unplug cord from
areas
right place.
turn off all controls before
15 Do not
or
(
). (fig.5)
extinguish slowly when press
off position. (V-5060CT, V-
Power indicator will
switch button in
Provide
5000CT/CD)
-4-
6
the power
Adjusting
9 DUST INDICATOR
1) V-5060CT, V-5000CT, V-5000CD (fig. 6)
GREEN
power with the power control switch in
the handle.
Adjust
Automatic
RED
cleaning mode, this
optimal cleaning is required
appliance sensing the floor condition and
nozzle
mode is used when
by
the
amount of dust
BOOSTER
dirt which is
10
in
deep-embedded
a
or on
automatically.
CAUTION:
(V-5060CT)
MIN
can't
This mode is used for
cleaning at night, or
cleaning required. (V-5000CT/CD)
MAX : This mode is used for cleaning carpets or
similar items which require strong suction force.
OFF : Used to stop appliance operation.
:
power with the
Open
3. Remove the moisture.
in shade for about
1.
2.
mark
(fig
(fig.5)
the floor. Do not exert
Store
pressure. If the suction
power weakened, raise the front end slightly. (fig.10)
Accessories
The crevice tool
the
can
hook.
on
the
cleaner in
Position
a
cool, clean, and dry
:
Push the nozzle holder into
on
the bottom of the v/cleaner.
on
the
rear
of the
v/cleaner.(fig.20)
BEFORE REQUESTING SERVICE
be stored at the tool box in
:
Proper assembly and safe use of your vacuum cleaner
your personal responsibilities. Read this "Owner's
Manual" carefully for important use and safety
For the dust between the ribs of the
DUSTING BRUSH: For
on
or
in the
narrow
gentle vacuuming
information.
gap.
of
Repairs, when necessary, must be performed at an
authorized service facilities. This appliance is intended
a
the furniture, curtain etc.
UPHOLSTERY NOZZLE: For
the
vacuum
(fig. 21)
be stored in the holder with
radiator, between the shelves,
on
Micro Filter
are
CREVICE TOOL
dust
High Efficiency pleated
the holder slot
appliance
delicate fabrics
arrow
(fig.19)
22.
can
keeping
it.
Horizontal Position: Push the nozzle holder into
be attached
using clamping
can
types, like fig
:
with the
clean EXHAUST FILTER.
the holder slot
8 HOW TO USE THE ATTACHMENTS
two
sufficiently
Filter.)
place.
Upright
particularly parquet
by applying only light
Extention wands
on
18-¥L
Carbon
this may damage the flooring,
floors. Best results will be
Holder
the filter
or
V-5060CT, V-5000CT, V-5000CD, V-5000HT,
V-5004HT, V-5000HD, fig 18-¥M : Micro and
obtained
Accessory
a warm
dish-washer
13 HOW TO STORE THE VACUUM CLEANER
over
as
Dry
day.
3. Insert the EXHAUST FILTER
reduced.(fig 8)
lightly
a
a
Open the exhaust cover. (fig 17)
Replace the old EXHAUST FILTER
new one or
7 HOW TO USE NOZZLE
Pass the nozzle
(fig. 16)
12 THE EXHAUST FILTER REPLACEMENT
the air hole in the handle, then suction
excessive pressure,
PHILIPS.
by
soapy water. Do not clean in
in a washing machine.
V-5010D
power will be
genuine LG dust bag. If you
only 'HR6938-OSH' of paper bag
use
use
1. Pull out the MOTOR SAFETY FILTER
3) V-5000T,V-5000D (fig.8,9)
Adjust power with the sliding switch in the body.
(fig.9)
Open the hole in the handle, then suction power
will be reduced.(fig 8)
Press the on/off switch to ON.
Always
2. Shake the dust off and wash filter in
handle.
4) V-5010T,
bag
cleaner off
11 THE MOTOR SAFETY FILTER CLEANING
switch in the
sliding
than 10cm from the floor.
vacuum
get it,
made
is
2) V-5000HT,V-5000HD,V-5004HT (fig.7)
Adjust
bag is full
detaching the
(fig. 5), remove the
by pressing the knob and open the cover by
pressing the latch. (fig. 12)
1) Paper filter bag
Dispose of the bag and set the new one.
2) Cloth filter bag
After sliding the clip off or unzipping the cloth
filter bag, empty the cloth filter bag. (fig. 15)
any bulky obstacles, Power in this mode is
much higher than MAX mode power.
BOOSTER operates for 10seconds and is
when silent
Filter
hose
the floor, and also recommended when the
hose, the pipes, of the nozzle is clogged with
restored to the last mode
use.
bag.
the dust filter
Switch the
removing
carpet
more
Replacing
present.
This mode is suitable for
:
the filter
Watch the dust indicator after
The normal
:
Empty
:
(fig. 11)
Continue to
:
vacuuming
for HOUSEHOLD USE ONLY and not for commercial
or
of the
upholstery.
-5-
industrial
use.
SAVE THESE INSTRUCTIONS
The serial number is found
number is
unique
You should record
this
guide
Date of
Dealer
as a
the bottom of this unit. This
on
to this unit and not available to others.
requested
information here and retain
permanent record of your purchase.
purchase
purchased
from
Dealer address
Dealer
phone
No.
Model No.
Serial No.
TROUBLE SHOOTING CHART
Review this chart to find
WARNING
do-it-yourself
solutions for minor
performance problems.
supply before servicing and/or cleaning
and/or the cleaner could suddenly start.
: Disconnect power
electrical shock could
occur
Possible Cause
Problem
Cleaner won't
1.
run.
Unplugged
at wall outlet.
2. Power control S/W is in
"OFF"
1. Full
Poor suction.
2.
position.
clogged filter bag.
Clogged clean filter.
or
Possible solution
1.
Plug
in
firmly.
2. Push switch button.
3.
Regulate power
1.
Change the filter bag.
Change the clean filter.
Replace hose.
2.
movable
rugs or nozzle
hard.
pushes
control switch.
3.
4.
5. Clean the air passage of
nozzle.
Clogged
nozzle.
cover
open.
5. Close filter
picks
as
3. Hole in hose.
5. Filter
Cleaner
the unit
1. Suction too
strong.
too
-6-
1.
cover.
Regulate power
control lever.
P/No.: 3828Fi3698A
Made in KOREA
Download PDF

advertising