LG | V-6380HT | LG V-6380HT Owner’s Manual

V-6380HT/HTV
V-6380ST/STV
5
6
2
13
13
16
15
9
10
213
5
4
6
13
9
10
12
--2--
15
16
18
13
12
17
12
19
20
22
21
MIN
MAX
23
25
26
24
27
30
29
28
--3--
Information for your
safety
Please read all the following information,
which contains important instructions for the
safety, the use and the maintenance of the
appliance.
?
This appliance complies with the following EC
Directives: -73/23/EEC, 93/68/EEC-Low
Voltage Directive-89/336EEC -EMC Directive.
Never allow children to
use
the
appliance
unsupervised.
Do not use the appliance If the mains
lead is damaged or faulty.
If the mains lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent as special tools are
needed to repair it.
Always switch the vaccum cleaner off
before :
changing the dust bag
changing or cleaning the filters.
If no dustbag is inserted, the cover cannot
be closed. Please do not use force!
Do not vacuum flammable or explosive
?
?
substances(liquids
Do not
The fuse cover/carrier must be replaced in
the event of changing the fuse.
The plug must not be used if the fuse
cover/carrier is lost. A replacement cover/
carrier must be obtained from authorised
electrical goods retailers.
The use of radio transmitting devices close
to the appliance may interfere the function
of the appliance, input power may vary.
vacuum
or
gases).
hot ash, embers etc.
nor
sharp objects.
Do not vacuum water or other liquids.
When you vacuum with an attachment
appliance that has a rotating brush roller:
do not reach into the running brush
roller.
Important for users in the UK.
The wires in the mains lead of this appliance are
coloured in accordance with the following code:
BROWN live
BLUE-neutral
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
PROCEED AS FOLLOWS:
The wire which is coloured BROWN must be
connected to the terminal which is marked L or
coloured RED.
The wire which is coloured BLUE must be
connected to the terminal which is marked N or
coloured BLACK!
VERY IMPORTANT:
Neither wire is to be connected to the earth
terminal of a 3 pin plug. If a 13 amp plug is fitted,
fit a 13 amp BS 1362 fuse.
If any other type of plug is used, protect with a 15
amp fuse at the distribution board.
For appliances which come with mains lead and
plug moulded on : the plug moulded on to the
cord incorporates a fuse.
For replacement use a 13 amp BS 1362
fuse. Only ASTA approved or certified fuses
should be used.
WARNING!Should it become necessary to
replace the moulded on plug then the
detective plug should be destroyed to avoid
any possible shock hazard that could occur
should such a plug be inserted into a 13
amp socket elsewhere in the house.
How to Use
Connecting
Assembling
the tubes
(depending
model)
?
?
on
Metal
tube(4)
together the two tubes by twisting slightly.
Telescopic tube (5)
Hold spring latch (6)
Pull out the tube to required length.
Release spring latch to lock.
-
Fit
-
?
-
the flexible hose
Push the end of the head(1) on the flexible
hose(2) into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the
vacuum cleaner, press on the button(3)
situated on the head, then pull upwards.
-
-
the cleaning head and Accessory
Nozzles (depending on model) Fit the large
Using
cleaning head onto the end of the tube.
The 2 position head(9) is equipped with a
pedal(10) which allows you to alter its
position according to the type of floor to be
cleaned. Hard floor position(tiles, parquet
floors...). Press on the pedal to lower the
brush.Carpet or rug position. Press on
the pedal to lift the brush up.
?
Dusting
Dusting
brush & Crevice
Brush is for
Tool(12)
vacuuming picture
frames, furniture outlines, books and other
uneven
objects.
Crevice Tool is for
vacuuming in those
normally inaccessible places i. e.
reaching covwebs, or down the side of
?
a
sofal
Upholstery Nozzle(13)
For vacuuming upholstery, mattresses,
etc. The thread collectors help to pick up
the threads and fluff.
--4--
How to
plug
in and
use
Pull out the mains lead to the desired length
and plug into the socket.
Press button (15) to start the vacuum cleaner.
To stop it press the button (15) again.
the power level
Adjusting
(depending
on
model)
?The flexible hose handle(17) has a manual
air flow regulator(18) which allows you to
briefly reduce the suction level.
?Electronic power control(19)
Suction capacity increases steplessly up to MAX.
Electronic power
OFF:Power off
control(20)
MIN:Low
MAX:Full power.
Park-System(21)
For short breaks
example
to
move
during vacuuming, for
a small piece of furniture
rug, use the Park system to support
the flexible hose and cleaning head.
Slide the hook attached to the large cleaning
tool into the slot on the rear of the appliance.
or a
?
Carrying
and
above.
it and replace it(27). Do not wash it.
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
as
Empty
fitted
the dust
Cleaning
types of filters
filter
?
?
away.
To refit
a new
bag push
: foam filter or electrostatic
anti-odour charcoal filter or washable
.
To change these filters remove the cover of
the filter compartment(30) situated at the rear
of the appliance, by lifting the little catch.
The foam filter, should be cleaned
regularly by tapping it to remove the dirt.
The electrostatic filter or anti-odor
charcoal filter should be changed regularly
(approximately every 6 bag changes)
?
?
The washable HEPA filter with water at
?
least
once a
year.
What to do if your
does not work
appliance
Check that the appliance is correctly plugged
in and that the electrical socket is working.
What to do when the suction
performance reduces?
?
?
?
?
the cardboard
support of a new bag into the bag
(26)until it will go no further.
or
HEPA filter (29)
?
?
lifting it up until it snaps into place.
appliance is equipped with either a
paper dust bag or a fabric dust bag (25)
(depending on model)
Take hold of the dust bag by the handle
and pull. Remove the bag and throw it
the air outlet filters
Depending on the model you have chosen
your appliance is equipped with different
?
and
Your
the motor filter
Changing
bag
The dustbag needs changing when the cleaner
is set to maximum power and the cleaner head
is off the floor but the "bag full" indicator
window(23) is completely coloured red.
Even if the dustbag does not appear to be
full at this stage, it should be changed.
It could be that a great deal of very fine dust
has clogged up the pores of the dust bag.
Turn off the appliance and unplug it.
Open the cover by pressing the hook(24)
correctly.
The motor filter is situated inside the
appliance between the dust bag and the
motor. Each time that you change the air
outlet filter we advise you to remove the
motor filter(28)and to clean it by tapping to
remove the dirt and then replacing it in the
vacuum cleaner.
storage(22)
When you have switched off and unplugged
the appliance, press on the button (16) to
automatically rewind the cord.
You can move or store your appliance in a
vertical position by sliding the hook on the
large cleaning head into the clip on the
underside of the appliance.
Changing
If your appliance is fitted with a fabric dust bag follow the same instructions
mount
--5--
the appliance and unplug it.
Check that the tubes, flexible hose and
cleaning tool are not blocked.
Check that the dust bag is not full.Replace
it if necessary.
Check that the air outlet filter is not
blocked. Replace it if necessary.
Stop
SAVE THESE INSTRUCTIONS
The serial number is found
number is
unique
You should record
this
guide
Date of
Dealer
as a
the bottom of this unit. This
on
to this unit and not available to others.
requested information
here and retain
permanent record of your purchase.
purchase
purchased from
Dealer address
Dealer
phone
No.
Model No.
Serial No.
TROUBLE SHOOTING CHART
Review this chart to find
WARNING
:
do-it-yourself
solutions for minor
performance problems.
Disconnect power supply before servicing and/or cleaning the unit
occur and/or the cleaner could suddenly start.
as
electrical shock could
Possible Cause
Problem
Cleaner won't
1.
run.
Unplugged
at wall outlet.
2. Power control S/W is in
"OFF"
position.
Possible solution
1.
Plug
in
firmly.
2. Push switch button.
3.
Regulate
power control
switch.
Poor suction.
1. Full
2.
clogged filter bag.
Clogged clean filter.
or
3. Hole in hose.
4.
Clogged
5. Filter
nozzle.
cover
1.
2.
3.
Change the filter bag.
Change the clean filter.
Replace hose.
4. Clean the air passage of
nozzle.
open.
5. Close filter
Cleaner
rugs
hard.
or
picks
movable
nozzle
pushes
1. Suction too
strong.
1.
Regulate
lever.
too
--6--
cover.
power control
POSSIBLE SVC PARTS LIST
Part Number
Description
BASE, BODY
3040FI1463A
COVER, HANDLE
3550FI1366B
MOUNT, BAG
3500FI2238D
PACKING, DUST SEAL
3920FI1278A
WHEEL
4660FI2417A
CASTER ASS'Y
4441FI3608B
MOTOR SAFETY
FILTER(MECH),
FILTER
5231FI4518E
ASS'Y, CLOTH
5231FI2444F
HOLDER, UPPER
4930FI2442B
HOLDER, LOWER
4930FI2441B
CORD REEL ASS'Y
4687FI2481C
MOTOR ASS'Y
4681FI2462A
PACKING, ABSORBING
3940FI3646A
PACKING, MOTOR MOUNTING
3920FI2416A
COVER
3551FI2418A
ASS'Y, SOUND
PACKING, SEAL
3920FI3775A
COVER, BODY
3550FI1620A
SWITCH
6601FI3149B
ASS'Y, PUSH
PWB(PCB)
ASS'Y
3550FI1621B
PACKING, FILTER
3920FI3812A
TOOL, CREVICE
5058FI3584A
BRUSH
5203FI2068A
DUST
INDICATOR ASS'Y
COVER,
3550FI1623A
COVER,
WIRE
3550FI3820A
PIPE
ASS'Y, EXHAUST
ASS'Y,
HOSE
5231FI3772B
TELESCOPIC
ASS'Y,
NOZZLE
5201FI2438A
FLEXIBLE
5215FI1331H
FLOOR
5249FI1405G
ASS'Y,
B-3 TYPE
3521FI3696B
TERMINAL
FILTER
CLOTH
6871FX2123C
COVER, FILTER
ASS'Y,
Remark
--7--
3 LAYERS
PRINTED CIRCUIT BOARD
SERVICE CENTER
For
service, please
Area
contact our authorized service center listed below.
Telephone
Number
Fax. Number
Jeddah
(02)
629 2929 ext. 310
(02)
629 1121
Jeddah
(02)
663 2325 ext. 343
(02)
665 2837
(01)
461 5559
(01)
463 3126
(03)
857 2929
(03)
857 7643
Riyadh
Al-Khobar
--8--
SPECIFICATIONS
235mm
305mm
?
POWER
?
CAPACITY
?
CURRENT
?
?
:
IEC-1200W, MAX-1500W
:
:
5.3 l
6A
FREQUENCY
VOLTAGE
522mm
:
:
50 / 60Hz
220V
?
POWER CONTROL
?
CORD LENGTH
?
NET WEIGHT
:
:
:
SLIDE
CONTROL, PUSH ON/OFF
6m
5.8kg
?NETDIMENSIONS:305x522x235(WxDxH)
?PACKINGDINENSIONS:358x577x370(WxDxH)
?
ATTACHMENTS
HOSE ................................................1EA
NOZZLE .............................................1EA
TELESCOPIC PIPE
.......................1(2)EA
PIPE)
DUSTING BRUSH..............................1EA
STEP STEEL
CREVICE TOOL.................................1EA
DUST FILTER BAG............................1EA
UPHOLSTERY NOZZLE ....................1EA
(2
These
specifications
are
subject
to
change according
--9--
to the
agent/buyer's request.
?
Serial Number
How to read Serial Number.
:
There is attached
Example)
a
Serial Number label
on
back side of this
009KB00001
Serial No.
PRODUCT CODE.
MANUFATURED MONTH.
MANUFATURED
YEAR(LAST DIGITAL).
--10--
product.
P/No.
:
3828FI2844E
Download PDF

advertising