LG | V-CB685HT | LG V-CB685HT Owner’s Manual

V-CB685HT
13
4
2
5
6
7
1
3
2
54
6
9
10
7
-2-
8
12
8
11
Suction control switch
9
MAX
FLOOR
CARPET
SOFA
CURTAIN
MIN
OFF
10
14
13
15
18
17
19
16
20
24
21
22
23
-3-
?
Information for your
safety
Please read all the
following information, which
contains important instructions for the safety, the
use and the maintenance of the appliance.
This appliance complies with the following EC
Directives: -73/23/EEC, 93/68/EEC-Low Voltage
use
the
appliance
-
?
furniture
unsu-
the
If the mains lead is
?
appliance
damaged or faulty.
If the mains lead is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid
use
uneven
Always switch the vaccum cleaner off before
changing the dust bag.
changing or cleaning the filters.
If no dustbag is inserted, the cover cannot
Crevice
Tool(8)
Crevice Tool is for
inaccessible
vacuuming in those normally
places i. e. reaching cobwebs, or
down the side of
?
hazard.
a
outlines, books and other
objects.
pervised.
Do not
position head(6) is equipped with a
pedal(7) which allows you to alter its position
according to the type of floor to be cleaned.
Hard floor position(tiles, parquet floors...).
Press on the pedal to lower the brush.
Carpet or rug position.
Press on the pedal to lift the brush up.
Dusting Brush(10)
Dusting Brush is for vacuuming picture frames,
-
Directive-89/336EEC -EMC Directive.
Never allow children to
The 2
:
a
sofa.
Upholstery Nozzle(9)
For vacuuming uphostery, mattresses, etc. The
thread collectors help to pick up the threads and
fluff.
?
?
closed. Please do not
Do not
vacuum
stances(liquids
Do not
be
?
force!
flammable
or
vacuum
use
How to
or
explosive
sub?
gases).
hot
ash, embers
etc. nor
vacuum
water or other
?
do not reach into the
running
sharp
?
liquids.
?
appli-
To
stop it, push
Press the cord reel
remove
head(1) on the
attachment point on the
the flexible hose from the
flexible
vacuum
Fit the
grip
on
the
Carrying
up to MAX.
the tubes
handle onto the end of the
and
storage(14)
When you have switched off and unplugged the
appliance, press on the button (11) to automati-
cally
telescopic
You
rewind the cord.
appliance in a vertical
position by sliding the hook on the large cleaning
head into the clip on the underside of the appli-
tube.
?
steplessly
?
vacuum
cleaner, press on the button(3) situated
head, then pull upwards.
Assembling
control(12)
during vacuuming, for example
to move a small piece of furniture or a rug, use
the Park system to support the cleaning head.
Slide the hook attached to the large cleaning
tool into the slot on the rear of the appliance.
cleaner.
To
use.
increases
capacity
to retract the
For short breaks
the flexible hose
into the
button(11)
Park-System(13)
Push the end of the
hose(2)
position
in the direction of OFF.
Electronic power
How to Use
and
what you want.
down the suction control switch
power cord after
brush roller.
length
Push the suction control switch of the hose han-
Suction
Connecting
use
Pull out the power cord to the desired
plug into the socket.
(12)
When you vacuum with an attachment
ance that has a rotating brush roller:
in and
dle in the direction of the
objects.
Do not
plug
Telescopic tube(4)
Hold spring latch(5).
Pull out the tube to required length.
Release spring latch to lock.
store your
can move or
-
ance.
-
Using
the
cleaning
head and
The
Accessory
large cleaning
dustbag
needs
bag
changing
when the cleaner is
set to maximum power and the cleaner head is off
Nozzles
Fit the
the dust
Changing
-
the floor but the
head onto the end of the
completely
tube.
Even if the
-4-
"bag
full" indicator
window(15)
is
coloured red.
dustbag
does not appear to be full at
this
stage, it should be changed.
It could be that a great deal of very fine dust has
What to do if your
does not work?
up the pores of the dust bag.
Turn off the appliance and unplug it.
clogged
?
?
?
Remove hose from the Vacuum Cleaner.
Open the
lifting it up
cover
until it
Check that the
by pressing the hook(16)
snaps into place.
and
appliance
is
and that the electrical socket
Your
appliance is equipped with either a paper
dust bag or a fabric dust bag(17) (depending on
model).
Take hold of the dust bag by the handle and
pull. Seal bag using the flap(18) on bag cardboard. Remove the bag and throw it away.
To refit a new bag push the cardboard support
of a new bag into the bag mount(19) until it will
appliance
correctly plugged
is working.
in
What to do when the suction
performance reduces?
?
?
?
?
further.
no
?
If your appliance is fitted with
dust bag follow the same instructions
Empty
as
device
cannot
above.
replace it(20). Do not wash it.
as the appliance is fitted with a safety
which checks that the bag is in place you
close the lid if the bag is not fitted correctly.
Cleaning
the motor filter
The motor filter is situated inside the
between the dust
that you
change
bag
to remove the motor
tapping
filter(21)
advise you
and to clean it by
we
to remove the dirt and then
vacuum
Changing
appliance
and the motor. Each time
the air outlet filter
replacing
it in
cleaner.
the air outlet filters
Depending on the model you have chosen your
appliance is equipped with different types of filters
: electrostatic filter or washable HEPA filter(24).
To change these filters remove the cover of the
filter compartment(22) situated at the rear of the
appliance, by sliding the lever toward
unlock(23).
(how to remove the cover : After checking the
lever(23) situated at the position "UNLOCK", you
can remove the cover(22) by sliding the cover
toward "OPEN")
The electrostatic filter should be changed regularly. (approximately every 6 bag changes)
?
?
?
The washable HEPA filter with water at least
once a
year.
are
(option)
-5-
appliance
and
unplug
it.
tubes, flexible hose and cleaning
not blocked.
Check that the dust
bag
is not full.
Replace
it if
necessary.
Check that the air outlet filter is not blocked.
Replace
fabric
it and
Note:
the
a
the
Check that the
tool
?
go
Stop
it if necessary.
-5-
-4-
-3-
-2-
V-CB685HT
Download PDF