LG | V-WP168NT | LG V-WP168NT Owner’s Manual

Vacuum Cleaner
OWNER'S MANUAL
MODEL: V-WP148NT
V-WP168NT
V-WP188NT
V-WP2600NT
Please read carefully and thoroughly the operating
instructions and safety precautions before installing
and operating your vacuum cleaner.
P/No.: 3828FV3003E
IMPORTANT SAFEGUARDS
When you use an electrical appliance, basic precautions should always be followed, including the
following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE
WARNING: To reduce the risk of fire,electric shock,or injury:
1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
2. Do not use outdoors or on wet surfaces.
3. Do not allow to be used as a toy. Close attention is necessary when used by or near children.
4. Use only as described in this manual. Use only manufacturer's recommended attachments.
5. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
6. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
7. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
8. Do not handle plug or appliance with wet hands.
9. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint,
hair, and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
11. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
12. Do not use without dust filter and/or clean filter in place.
13. Turn off all controls before unplugging.
14. Use extra care when cleaning on stairs.
15. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they
may be present.
-2-
TURN ON/OFF
• You can turn on/off the unit by pressing the
power switch on the top of handle.
Power Switch
Fig.1 Turn On/Off
TO USE FLOOR NOZZLE
• For cleaning the dust on floor, please use the
floor nozzle as following:
1. Insert the telescopic pipe
reelingly.
into handgrip
3
2. Insert floor nozzle
reelingly.
into telescopic pipe
3. Put the hose joint
into the socket
on unit.
2
4. When you want to take the hose out, press
button and pull the hose joint out.
5 4
USE IT AS BLOWER
• You can use the vacuum cleaner as a blower for
cleaning the place where the cleaning head
cannot reach.
1. Put the hose joint
until it is fastened.
6
1
4
7
into the blowing hole
2. When take the hose out, pull the hose joint
out.
Fig.2 Use the Floor nozzle and use it as a blower
-3-
DUST-FULL INDICATOR
• When red drogue appears in the window
continuously, the dust room could be full or
airway could be blocked. You have to deal with it
immediately.
Dust-full indicator
CAUTION
When red drogue appears in the window
continuously, the motor will be burnt
finally if the vacuum cleaner keeps
working.
Fig.3 Dust-full indicator
WARNING
When you hear a whistle or scream, it
means the safety-air-inlet-valve operates.
In this case, you should check as the
above.
DUST BRUSH AND CREVICE TOOL
1. Dust brush : For cleaning small room such
as chairs,sofa,curtain or describing surface.
Insert it into handgrip reelingly.
10
3
2. Crevice tool : It is used for cleaning gap,
corner etc. When use it, insert it into handgrip
.
8
9
SUCTION ADJUSTING
• Adjust the suction power by slipping the
adjusting button.
Fig.4 To use dust brush and crevice tool and
suction adjusting
• The bigger the bear hole is, the lower suction
power is. We suggest that you had better use
lower suction power when clean curtain, jalousie
or elaborate cloth.
-4-
TOOL STORAGE space
• The back of the dolly has a storage for the
dusting brush and crevice nozzle. Place the
attachments on the storage space for handy
retrieval.
Fig. 5 Tool's storage
TO REMOVE DUST
When dust accumulation is excessive, please remove the dust by the following:
1. Turn off the machine and pull out the plug from wall outlet.
2. Remove the hose, and release the clamp
the upper case .
by pulling the lower side of it on each side and take off
3. Take the upper case and shake the cloth filter for about 20 times to remove the clogging dust
from the filter . When fluff remains excessively on the filter, remove it by a brush.
CAUTION
Do not shake it up and down.
4. Take off the filter and dispose of the dust in the tank .
5. Change the filter to the tank, and set the upper case on the tank.
12
12
13
11
14
11
14
14
Fig. 6 To remove dust
-5-
HANG THE POWER CORD
• Refer to Fig.7, wind the power cord
it on the hanger .
and hang
16
15
Fig.7 Hang the power cord
STORAGE
• Hose, telescopic pipe and floor nozzle can be
stored in an assembled condition to the cleaner.
This combination allows you a neat and tidy
storage.
• Coil the hose around the telescopic pipe to
make it compact and stable and rest the
telescopic pipe on the pipe rest as shown in
Fig. 8.
18
17
Fig.8 Storage
-6-
Maintain the filter
• To insure good suction power, after disposing of the dust, please clean the filter at least twice one
year as following steps:
1. Switch the appliance OFF and pull out the plug from the socket before replace the filter.
2. Take the filter ring
out of the filter
.
3. Wash the filter in tepid water or a neutral detergent. If detergent is used, rinse it out thoroughly.
4. Allow the filter to dry naturally.
Caution
• Avoid washing the filter in boiling water or by washing machine.
• Avoid drying over a fire or in hot sun.
• If the filter is used when wet, suction is impaired and the motor may be damaged.
19
20
19
20
Fig.9 Clean the filter
-7-
BEFORE REQUESTING SERVICE
Proper assembly and safe use of your vacuum cleaner are your personal responsibilities.
Read this "Owner's Manual" carefully for important use and safety information.
TROUBLE SHOUTING CHART
Review this chart to find do-it-yourself solutions for minor performance problems
WARNING
Disconnect electrical supply before servicing and/or cleaning the unit. If not, electric
shock could occur and/or cleaner could suddenly start.
Problem
Cleaner won't
run.
Cleaner
suction is low.
Cleaner picks
up movable
rugs or nozzle
pushes too
hard.
Possible Causes
Possible Solution
1. Unplugged at wall outlet.
1. Plug in firmly; push switch button.
2. Push switch is not in "ON" position.
2. Push switch button.
3. No voltage in wall outlet.
3. Check fuse or breaker.
4. Over-heating projection for the
motor is actived.
4. Check dust filter, blockages and
allow the motor to cool down for 2
Hours then switch on.
1. Full or clogged dust tank or airflow
blockage.
1. Clean the dust tank or check the
airflow passage.
2. Hole in hose
2. Replace hose.
3. Clogged nozzle.
3. Clean the airflow passage of
nozzle.
4. Hose is not properly connected to
cleaner.
4. Ensure hose is properly connected.
1. Suction too strong.
1. Regulate power with the knob on
the handle of hose.
-8-
SPECIFICATION
POWER SOURCE:
ON RATING PLATE
CAPACITY:
18L
POWER CONTROL:
PUSH ON/OFF
CORD LENGTH:
9m
NET WEIGHT:
6.6 kg
NET DIMENSIONS:
350 x 389 x 553mm (W x D x H)
PACKING DIMENSIONS: 410 x 422 x 588mm (W x D x H)
ATTACHMENTS
HOSE ........................................................................1 EA
TELESCOPIC PIPE ..................................................1 EA
CREVICE TOOL .......................................................1 EA
DUST BRUSH...........................................................1 EA
NOZZLE ASS'Y.........................................................1 EA
These specifications are subject to change according to the
agent/buyer's request.
-9-
‫ﺟﺎﺭﻭ ﺑﺮﻗﯽ‬
‫ﺭﺍﻩﻨﻤﺎی ﻣﺼﺮﻑ ﮐﻨﻨﺪﻩ‬
‫ﻣﺪﻝ‪V-WP148NT :‬‬
‫‪V-WP168NT‬‬
‫‪V-WP188NT‬‬
‫‪V-WP2600NT‬‬
‫ﻟﻄﻔﺎ ﻗﺒﻞ ﺍﺯ ﻧﺼﺐ ﻭ ﺍﺳﺘﻔﺎﺩﻩ ﺍﺯ ﺩﺳﺘﮕﺎﻩ ﺟﺎﺭﻭ ﺑﺮﻗﻲ‪،‬‬
‫ﺩﻓﺘﺮﭼﻪ ﺭﺍﻩﻨﻤﺎ ﻭ ﻧﻜﺎﺕ ﺍﻳﻤﻨﻲ ﺭﺍ ﺁﺎﻣﻼ ﻭ ﺑﻪ ﺩﻗﺖ‬
‫ﻣﻄﺎﻟﻌﻪ ﻓﺮﻣﺎﺋﻴﺪ‪.‬‬
‫ﺁﺪ ﻓﻨﻲ‪3828 FV – 3003 E :‬‬
-2-
-3-
-4-
-5-
-6-
-7-
-8-
-9-
Download PDF