LG | WP-1050RS | LG WP-1050RS Owner’s Manual

SPECIFICATION
W
Washing Machine
D
OWNER'S MANUAL
MODEL : WP-891R(S)(P)/WP-988RSP
WP-970(N,Q,R)(S)(P)
WP-971Q(S)(P)/WP-980Q(S)(P)
WP-1050R(S)(P)/WP-1150R(S)(P)
WP-1070R/WP-1070RB
H
Power source
Please read the operating instructions carefully
and thoroughly before installing and operating
your washing machine.
This washing machine is designed and manufactured
for household use only.
ON SPECIFICATION LABEL
Water Level
H : 61 , M : 54 , L : 46
Water Pressure
Less than 100kPa (1kgf/cm 2 )
Dimension
820 X 482 X 986 mm. (W X D X H)
Weight
For Non-Pump Model
For Pump Model
31.5
32.1
kg
kg
How to read the manufactured month and year from the label stuck on the
back of the product.
EX) 4 0 1 T W A A 0 0 0 0 1
Serial No.
Password code
Product code
Month
Year (The last digit to year)
Part name
- WASH MOTOR
- SPIN MOTOR
- S.D. BASKET
- CYCLE TIMER ASSEMBLY
- CAPACITOR
- GEAR CASE ASM
Remark
90 W (Output)
40 W (Output)
PLASTIC
Specification
(N,Q,R) : Pulsator Type
(S)
: See Through Cover Only
(P)
: Pump Model Only
P/No. : 3828EY3044A
8
FEATURES
CAUTION
Installation Area
Avoid watering on the
switch area.
It may cause
electric shock
or fire.
Volatile Material
Avoid electric heater, candle light,
cigarette light, bug smoker,
etc. near the machine.
It may ignite or
deform
plastic part.
Install the washing machine on
a horizontal support.
Otherwise,
it may cause
vibration and noise.
WASHING
COVER
SPIN DRYER
COVER
Use for WP-****N(S)(P)
WATER SUPPLY
SELECTOR LEVER
Hot water
SAFETY
COVER-2
OVER FLOW
FILTER
Avoid using hot water
over 50°C. It may
deform plastic parts
or cause malfunction.
Use for WP-****Q(S)(P)
SPIN DRYER
BASKET
ROTATION
FILTER-C
EARTH WIRE
(For models with
two prong plug)
In Operation
Do not use volatile material such as
Benzene, Gasoline, bug killer.
Do not leave strong alkaline substance
such as bleach inside
the tub. Damage on
plastic surface and
rubber parts may occur.
Installation
DRAIN HOSE
Heat
Avoid area exposed to snow,
rain, or where humidity
is high. It may cause
electric shock.
Switch Area
*For Pump
Model Only*
Pulsator Table
CAUTION
Do not insert the hand inside the spin
dryer basket while the machine is in
operation (Do not let children climb on
the machine or climb into
the tub. Injury may occur.)
TUB
PULSATOR
Use for WP-****R(S)(P)
(See detail in Pulsator Table)
POWER CORD
3
Power Cord
If the power supply cord is damaged, it
must only be replaced by the
manufacture or its service agent or a
similarly qualified person in order to
avoid a hazard.
Electric Outlet
Avoid connecting several electric
Be sure to disconnect the power cord
devices to single outlet. It may cause
from the electric outlet before starting
fire.
care and maintenance.
Be sure to earth the washer to prevent electric shock. To reduce
the risk of electric shock, do not install the washer in humid spaces.
Connecting the drain hose
Push the clamp toward the body of the washing machine as
shown in the figure.
For Non-Pump Model
Be sure to reroute the hose so that it is not kinked; kinks or sharp
bending in the hose will prevent proper drainage.
Make sure water is draineded smoothly by placing a base under
the machine or by applying other appropriate mean.
For Pump Model
4
2
6
Drain Selector
Spin Timer
Off
WASH
Wash Timer
Wash Program
Water Supply Selector
2
1. Water Supply Inlet
Connect here with the inlet hose from the
water faucet to feed water to the tub.
2. Water Selector
Select "WASH" to supply water for
washing and rinsing and "SPIN" for spin
shower rinse.
3. Wash Timer
Select the desired time for washing or
rinsing.
4. Wash Program
Set the program to "GENTLE","NORMAL",
"STRONG" according to kinds and
quantity of the laundry.
L
L <= 1 m.
5
1
3
**For pump model only**
5. Drain Selector
For Non-Pump Model
Select “Wash Rinse” for washing and
rinsing and “Drain” to drain the water
out of the tub.
For Pump Model
Select “Wash Rinse” for washing and rising
and “Drain” to drain the water out of the
Cabinet, and “Off ” to turn off the drain pump.
6. Spin Timer
Select the desired time for spinning. The
maximum limit is 5 min. Don’t rotate the knob
more than prescribed limit.
INSTALLATION
Installation area
Set on flat and firm floor.
Incorrect installation may course
severe noise and break down.
●
●
INSTALLATION & HOW TO WASH
●
●
Maintain more than 10 cm. between
the side of drain hose and the wall.
A carpet must not obstruct the
ventilation openings.
Connecting the earth wire
Install the earth wire to prevent short-circuit due to leaking current and electric shock.
It is attached at the back of the washer.
Gas pipe
Connect it to the metal water pipe.
If the water pipe is made of plastic,
it does not have the earth effect.
● Do not connect the earth wire to the
Earth
gas pipe, lightning arrester. telephone
wire
connecter, etc.
Warning-the appliance with two-pronged plug must be grounded.
Before washing
1. Check the washing instruction labels on the clothing to be washed.
2. Remove all objects from the pockets of the clothing.Objects left in the pockets may
damage clothing or the washing machine (could cause the drain hose to clog).
3. After separating oiled or dyed clothing, wash.
4. For your convenience hang up the wash cover on the right or left side of the
washing machine tub when not in use.
●
●
Connecting the power plug
r
How to wash
water supply and
the wash
1 Set the drain selector 3Open
fill water till your desired
5 Select
program to "GENTLE",
level of tap
For Non-Pump Model
Set as "WASH
position.
RINSE"
For Pump Model
Set as "OFF"
position.
Insert the power plug into the outlet.
Before connecting the power plug, check if the voltage
setting of the washer matches the outlet voltage.
● If AC outlet with ground terminal is used, grounding is not
needed. If not, never forget earthing (earthing method above).
● The appliance must be positioned so that the plug is accessible.
●
●
2
Voltage Change (only for dual voltage)
●
Connect to the
earthing-only outlet.
6
●
Earth
wire
Set the desired wash
time.
When installing it in an
area where earthing is
not possible, purchase a
short-circuit breaker
connect it to the outlet.
Earth
wire
Earth copper plate
the appropriate amount
4 Put
of detergent and the laundry
into the wash
Water Selector
Other earthing method
After connecting the earth
wire to the earth copper
plate, bury it at least 75cm
deep under the wet
ground.
Drain Selector
Set the water selector
to "WASH"
WASH
This washer is assembled for 220V, but can be changed from
220V to 110V(or 127V).
Check your electrical source and follow the diagram below
to convert voltage.
●
Drain Selector
Short-circuit breaker
7
tub. And add
water to the
desired water
level which
you want.
Wash Timer
Drain Selector
Interim spin rinse
4
2
3
REFERENCE
Note for spinning
1. Put the laundry evenly into the spin
dryer basket.
2. Put the laundry down lightly.
3. Place the safety cover horizontally
over the laundry.
4. Close the spin dryer cover.
Safety cover
If the spin dryer basket is off-balance and vibrates excessively, stop the
spinning, rearrange the clothes evenly, and then resume spinning.
CARE
Overflow filter & Rotation filter-C
1. Lift up the area A of the over flow filter and take out the rotation filter-C by pulling
in direction as shown.
2. Pull the overflow filter forward from the wash tub in the direction of the arrow.
3. Turn the net over and rinse in water.
4. Use a brush or hand to remove all of the lint which has adhered to the overflow filter.
5. Insert the overflow filter back into the wash tub.
6. Insert the rotation filter-C back into the overflow filter.
4
A
Type of clothing
Under shirt
Handkerchief
Bath towel
Shirt
Socks (1 pair)
Pajama (shirt and pants)
Winter undershirt
Workclothes
Blouse
Weight per piece
150g(53oz)
50g(1.8oz)
300g(10.6oz)
200g(7.1oz)
50g(1.8oz)
500g(17.6oz)
600g(21.2oz)
800g(28.2oz)
200g(7.1oz)
5
6
Amount of
Type of Wash Wash Water
Amount of
Amount of
detergent (g)
fabric Selector Time Level
laundry (kg)
Water (l)
Synthetics,
46
0.5 ~ 4.0
42 ~ 46
L
2~5
Silk,
4.0 ~ 5.0
54
51 ~ 55
M
GENTLE min.
Woolen,
5.0 ~
61
56 ~ 60
H
Knits
42 ~ 46
46
L
0.5 ~ 4.0
5 ~ 10
Cotton,
54
51 ~ 55
NORMAL
4.0
~
5.0
M
Linen
min.
5.0 ~
61
56 ~ 60
H
46
L
Very soiled
42 ~ 46
0.5 ~ 4.0
10 ~ 15
54
cotton and STRONG
M
51 ~ 55
4.0 ~ 5.0
min.
linen
61
5.0 ~
H
56 ~ 60
Amount of laundry is based on dry laundry.
Detergent amount is based on a general synthetic detergent.
If washing and spinning mest be operated together, starting washing and spinning
operation shall be done at the same time to cope with EMC requirement.
TROUBLESHOOTING GUIDE
Before Requesting Service
Problem
Motor does not operate,
Spin dryer basket does
not operate.
No draining
For Non-Pump Model
For Pump Model
6
Type of fabric
Cotton
Cotton
Cotton
Mixed fabric
Mixed fabric
Cotton
Cotton
Mixed fabric
Mixed fabric
TABLE 2. GUIDE FOR WASHING
Spin Timer
3
Drain Selector
TABLE 1. WEIGHT GUIDE FOR CLOTHES
Interim spin rinse prior to regular rinsing helps removing sudsy water from the
laundry and improve rinsing efficiency. Also is helpful to water saving.
After interim spin
Set the water
After washing.
selector to "SPIN".
rinse, move the
Move the laundry into
SPIN
laundry into the
the spin dryer basket.
Water Selector
Place the safety cover
wash tub for rinsing.
horizontally on the
Set the desired
laundry.
spin flow
appropriately.
2
R
8
Spinning in the spin
dryer basket.
Move the laundry into
the spin dryer basket.
Put the laundry down
lightly.
Place the safety cover
horizontally on the
laundry.
Set the desired
spin time
with the
spin timer.
5
HOW TO RINSE & HOW TO SPIN
1
For Pump Model
Off W
4
1
Wash Program
When washing is finished,
locate the drain selector to
"DRAIN" position and drain
the water out.
For Non-Pump Model
75cm
"NORMAL" or
"STRONG" according
to the kinds and
quantity of the laundry.
(Refer to Tabel 2)
mark. That
is because
clothes can
absorb
adequate amount of water
and water will not short.
Off
Checking point
Is the power cord firmly plugged in?
Is the timer turned to a suitable point except "OFF" ?
Is there any clothing dropped between the basket and tub?
Is the spin dryer cover closed?
Is the laundry gathered to one side of the spin dryer basket?
Is there lint stuck in the plunger valve?
Is the end of the drain hose guide located at an exceed height?
Is the drain pump operated?
7
Download PDF