LG | CD-3230A | Owner's Manual | LG CD-3230A Owner’s Manual

LG CD-3230A Owner’s Manual
CD/RADIO
CASSETTE RECORDER
Owner's Manual
MODEL
:
CD-3230A
Please read this manual
carefully
before
operating your
set.
P/NO: 3828R-A030J
WARNING
WARNING
To avoid electrical shock; do not open the cabinet. Refer
servicing to qualified personnel only.
Shock Hazard
-
To reduce the risk of fire
do not open.
this
appliance
or
electric shock, do not expose
to rain or moisture.
CAUTION
Use of controls
procedures
or
adjustments or performance of
specified herein may
other than those
CAUTION
result
in hazardous radiation exposure.
This class B
digital apparatus meets all requirements of
Causing Equipment
the Canadian Interference
CAUTION:
-
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER(OR BACK)
Regulations.
For the customers in
Laser
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER SERVICEABLE PARTS INSIDE.
Europe
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
component in this product is capable of emitting
exceeding the limit for Class 1.
radiation
The
graphical symbols marked on the bottom
mean the following explanation.
or
back of
the set
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
This
as a
Compact Disc player is classified
CLASS 1 LASER product.
KLASS 1 LASER APPARAT
The CLASS 1 LASER PRODUCT
CLASSE 1 PRODUIT LASER
label is located
on
CAUTION:INVISIBLE LASER RADIATION WHEN OPEN AND
INTERLOCKS DEFEATED. AVOID EXPOSURE TO BEAM.
LASERSTRALNING NAR
OPPNAD STRALEN AR FARLIG.
VARNING:OSYNLIG
ATTENTION:Quand
s'exposer
aux
l'appareil
est ouvert,
ne
the exterior.
AR
user
on
to the presence of uninsulated
within the product's
"dangerous voltage"
This label is
located
DENNA DEL
lightning flash with arrowhead within an
equilateral triangle is intended to alert the
The
enclosure that may be of sufficient
magnitude to constitute a risk of electric
the
interior.
shock to persons.
pas
radiations invisibles du faisceau laser.
The exclamation
triangle
The power switch of this unit is secondly mounted and
does not disconnect the whole unit from the mains
supply
This
in the OFF
product
!
position.
is conformed to EMC
regulation
89/336/EEC and is therefore marked with the CE-label.
-2-
point
within an
is intended to alert the
equilateral
user
to the
presence of important operating and
maintenance (servicing) instructions in the
literature
accompanying
the
appliance.
Location of controls
12
3454678
9
10
15
11
14
12
13
16
19
18
17
-3-
1
VOLUME Control
2
FUNCTION Switch
3
CD PLAY/PAUSE buttons
4
CD SKIP/SEARCH buttons (
5
CD REPEAT button
6
CDSTOPbutton( )
7
CDOPENbutton(
8
FM STEREO indicator
9
TUNING dial
10
Deck controls
11
CD SYNC indicator
12
CD TRACK indicator
13
CD Pause indicator
14
CD
15
CD RPT 1/ALL indicator
16
RIF/FM MODE switch
17
AC Power
18
Voltage Selector (optional)
19
Battery compartment
Play
)
indicator
input socket
(
)
,
)
A
Power Source
The AC Power cord Connection
Set(see fig.
A
)
1. Before
2.
connecting the AC power cord, check that the
operating voltage of your set is idential with the voltage
of your local power supplied.
Connect one end of the AC power cord(supplied) to
3.
the AC IN socket located at the backside of your set.
Plug the other end into the wall outlet.
the AC power cord from the wall outlet if you
Unplug
do not to
to mains
use
for
an
period of time.
extended
(wall outlet)
Adjusting
the
voltage(optional)
If your set is equipped with a voltage selector at the back
side, be sure to set it to your local power supplied before
connecting the AC power cord.
B
Battery Installation
Set(see fig.
B
)
1. Press open the battery cover.
2. Put six "C"(R14) batteries(not
compartment making
positioned.
3. Replace the cover.
sure
supplied)
the
+
and
-
into the
are
correctly
NOTE:
1. To avoid
for
an
damage from possible battery leakage,
plan to use the
the batteries if you do not
extended period of time.
remove
2. When the batteries are weak,
replace
set
all the batteries
with new ones.
3.
During
the AC power cord connect to the wall outlet,
are not worn out.
the batteries
-
+
-
+
+
-
+
+
-
+
+
---
6 "C" cells
+
-
(R14)
-4-
Sound
CD
Adjustment
Operation
ToPlayaCD
VOLUME:
Turn VOLUME clockwise to increase the sound level,
anti-clockwise to decrease it.
or
1. Set FUNCTION to CD.
2. Press
3. Load
) to open the disc compartment.
disc with the printed side facing up.
OPEN(
a
4. Close the disc
compartment. The display
will show the
total number of tracks.
Radio
Operation
5. Press
PLAY/PAUSE(
)
to
number will be shown in the
begin play.
display.
The track
6. Press
2. Tune in a station
7.
using TUNING dial.
TAPE(OFF) to turn off your
3. Set FUNCTION to
STEREO
or
8.
set.
Press and hold SKIP/SEARCH
MONO:
1. Set FM MODE to ST. to
listening
search backwards
to an FM stereo
hear the track
broadcast. The FM ST. indicator will
2. Set FM MODE to MONO when
stereo broadcast.
PLAY/PAUSE( ) to pause.
will flash in the display.
a track is paused
Press PLAY/PAUSE(
) again to resume play.
How to search for a particular section of music
the track that is playing:
When
1. Set FUNCTION to AM or FM.
Selecting
light.
listening to
this function will
an
FM
substantially
antenna to
get
more
clear
Press SKIP/SEARCH (
or
) to search
a particular track. After each press of this buttons
the new track number will be shown in the display.
for
angle
out and
and direction for better
STOP( )
to
stop playing
a
disc.
NOTE:
set for better
reception.
telescopic antenna
current
reception.
1. AM: The antenna is built within the set and rotate the
2. FM: Pull the
being played at high speed.
a particular track on the
disc:
10. Press
NOTE:
to
or
forwards, you will be able to faintly
9. How to search for
reduce the noise, however the stereo effect will be lost.
Adjust the
or
on
adjust
reception.
1. Do not tilt or move your set with discs loaded. If you
do you may damage the discs and your set.
the
2. Do not touch the
playing
side of CD; the side without
any printing on it.
3. Clean your CD from the middle outwards with
a
soft
lint free cloth.
Cassette
Repeat Play
Operation
By repeatedly pressing REPEAT
displayed in the display.
1. Set FUNCTION to TAPE.
2.
Open
3. Insert
4. Press
5.
6.
7.
the cassette door
a
by pressing
push close the
playback.
cassette and
the
following options
will be
/
ST/EJ.
door.
PLAY( ) to
Press PAUSE( ) to pause. Press PAUSE again to
resume play.
Press FF(
) or REW(
) to fast forward or rewind
the tape.
/
Press
ST/EJ to stop play. Your cassette deck will
automatically stop at the end of the tape.
-5-
RPT 1
One track is
played repeatedly
RPT ALL
An entire disc is
played repeatedly.
The next press of REPEAT will cancel the feature.
Recording Operation
Specifications
RADIO SECTION
NOTE:
1.
Recording levels have been preset at the factory
optimum conditions and cannot be changed.
Frequency range
under
AM...........................................................520~1,620kHz
2. Your set can record onto Normal ;
FM ...........................................................87.5~108MHz
CrO2 tapes and metal tapes cannot be used.
Intermediate
frequencies
AM .....................................................................455kHz
Basic
FM....................................................................10.7MHz
Recording
Antenna
1. Set FUNCTION to one which you wish to record from.
2. Insert a blank cassette.
3. Press REC
AM....................................................Ferrite bar antenna
FM...................................................Telescopic
PLAY
goes down automatically.
4. Start playing your CD or RADIO.
/
5. Press
ST/EJ to finish recording. Your cassette
deck will
Set RIF
which
.
at the end of the
automatically stop
the side of set to 1,2
on
one
or
antenna
CASSETTE SECTION
tape.
3, depending
on
best reduces the noise when AM broadcast
Recording system......................4 tracks 2 channel stereo
Frequency response....................................125~8,000Hz
S/N ratio................................................35/40dB(rec/play)
recording.
CD PLAYER SECTION
CD
Frequency response..................................100~18,000Hz
ratio..........................................................60dB(1kHz)
Synchro Recording
This feature
automatically
records
S/N
an
entire CD onto
a
GENERAL
cassette.
1. Load a disc and set FUNCTION to CD.
2. Insert a blank cassette
3. Press REC
When
.
PLAY
recording from
a
.
goes down automatically.
CD, the disc will start playing
after about 7 seconds.
4. Press
/
STOP( )
ST/EJ to finish
to
stop playing
recording
a
disc.
and press
Speakers................................................................8Ω x 2
power(10%T.H.D)........................................1.0W x 2
AC operation ................................Refer to the indicated
voltage on the bottom of set
Battery operation .............................DC 9V, six "C"(R14)
batteries(not supplied)
Power consumption...................................................11W
Dimensions(W x H x D) ...................338 x 178 x 230mm
Weight.......................................................................2.7kg
Out
NOTE:
Design and specifications are subject to
change without notice for improvement.
-6-
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising