LG | V-CA241NT | LG V-CA241NT Owner’s Manual

V-CA241NT**
V-CA241HT**
Table of contents
Information for Your
Safety......................................................................................3
How to Use.................................................................................................................4
Assembling
Using
the
Emptying
cleaner ...............................................................................................................4
cleaning
head and
Accessory
Nozzles..................................................................6
the Dust Chamber .................................................................................................8
Operation...............................................................................................................................9
How to
Plug
Adjusting
the Suction level ....................................................................................................9
Park-System
2
in and use..........................................................................................................9
..........................................................................................................................9
Cleaning
the Motor Filter ....................................................................................................10
Cleaning
the Dust Chamber ................................................................................................11
Cleaning
the Exhaust Filter .................................................................................................11
Information for Your
Safety
Please read all the
following information, which contains important instructions for the safety,
appliance.
This appliance complies with the following EC Directives: -73/23/EEC,
93/68/EEC-Low Voltage Directive-89/336EEC -EMC Directive.
Never allow children to use the appliance unsupervised.
Do not use the appliance If the power cord is damaged or faulty.
If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent
Always switch the vacuum cleaner off before:
Emptying the dust chamber.
Cleaning or changing the filters.
Do not vacuum flammable or explosive substances(liquids or gases).
Do not vacuum hot ash, embers etc. nor sharp objects.
Do not vacuum water or other liquids.
Do not unplug by pulling on cord.
Use only LG's recommended filters.
When you vacuum with an attachment appliance that has a rotating brush roller:
Do not reach into the running brush roller.
the
use
and the maintenance of the
Thermal
case
protector: This
of motor
hazard.
cleaner has
If the cleaner
cleaner. Check the cleaner for
hose
a
a special thermostat that protects the cleaner in
suddenly shuts off, turn off the switch and unplug the
possible source of overheating such as a full dust chamber, a blocked
vacuum
overheating.
to avoid
a
clogged filter. If these conditions are found, fix them and wait at least 30 minutes
before attempting to use the cleaner. After the 30 minutes period, plug the cleaner back in
turn on the switch. If the cleaner still does not run, contact a qualified electrician.
or
and
3
How to Use
Assembling Cleaner
Fit the
the end of the tube.
large cleaning head into
Spring
2
latch
Telescopic
tube
1
The 2
Push
position
telescopic
nozzle outlet.
head
tube into
Telescopic tube (depending
?
Press the
?
Pull out the tube to the desired
?
Release
?
4
spring
spring
on
model)
latch to release.
length.
latch to lock the tube in
position.
Push telescopic tube into hose
(V-CA241NT**/V-CA241HT**)
handle
firmly.
Head
Flexible Hose
(V-CA241NT**)
(V-CA241HT**)
Attachment Point
Button
3
Connecting
?
the flexible hose
Push the end of the head
into the attachment
?
To
remove
pull
on
on
the flexible hose
the
vacuum
the flexible hose from the
cleaner, press
then
point
on
the button situated
the head out of the
vacuum
cleaner.
vacuum
on
the
head,
cleaner.
5
How to Use
Using
the
cleaning
head and
Accessory
Nozzles
Tear the vinyl bag and pull out accessories. Attach the accessory holder onto the telescopic tube.
And then, fit the Dusting Brush, Crevice Tool and Upholstery Nozzle onto the accessory holder. Fit the accessory onto the end of the tube.
Upholstery
Dusting
2
1
Upholstery
brush
Nozzle
Upholstery Nozzle is for vacuuming
upholstery, mattresses, etc.
The thread collectors help to pick up
the threads and fluff.
Dusting
nozzle
Crevice tool
3
Brush
Dusting Brush is for vacuuming
picture frames, furniture frames,
books and other irregular surfaces.
Crevice Tool
Crevice Tool is for
vacuuming in those
normally hard-to-reach
places such as
reaching cobwebs, or
between the cushions
of
6
a
sofa.
1
2
3
4
4
5
5
Pedal
Brush
The 2
Brush
Brush is for
motor filter.
position head
(V-CA241NT**/V-CA241HT**)
cleaning the
(Air cleaner)
?
?
?
The 2
position cleaning head
equipped with a pedal which allows
you to alter its position according to
the type of floor to be cleaned.
Hard floor position
(tiles, parquets floor)
Press the pedal to lower brush.
Carpet or rug position
Press the pedal to lift the brush
up.
7
How to Use
Emptying
The dust chamber needs
emptying
reaches the MAX indicator
the dust tank.
on
the dust chamber
when dust
?
Turn off the
?
Your
and
vacuum
vacuum
a
cleaner and
cleaner is
dust chamber
pull
the dust chamber forward.
Remove the dust chamber cap and empty the dust chamber.
To reinstall the dust chamber, replace the dust chamber cap and
push
8
a
motor filter.
Press the button and
?
unplug it.
equipped with both
the dust chamber into the tank mount
as
far
as
it will go.
Operation
2
1
3
MAX
MIN
How to
?
Plug
Adjusting the Suction
(depending on model)
in and Use
Pull out the power cord to the desired
plug into the socket.
length
?
Adjust
level
suction with the suction
(V-CA241HT**)
?
Push the suction control switch of the hose
handle in the direction of the position what
you want. (V-CA241HT**)
To stop it, push down the suction control
switch in the direction of OFF.
(V-CA241HT**)
?
?
Press switch button to start the vacuum
cleaner. (V-CA241NT**)
To stop it, press the switch button again.
?
control switch in the hose handle.
and
?
Park
?
The flexible hose handle has
regulator which
adjust the suction level
briefly. (V-CA241NT**)
a
manual air flow
allows you to
?
System
To store after
vacuuming
and
pause while vacuuming.
For deposit after vacuuming, for
example
to
furniture
or a
system
to
hose and
-
move a
rug,
the
rear
piece
the Park
support the flexible
cleaning
Slide the hook
cleaning
small
use
on
head.
the
large
head into the slot
on
of the dust chamber.
(V-CA241NT**)
?
Press the cord reel button to retract the power
cord after use.
9
of
How to Use
Cleaning
the Motor Filter
The reusable motor filter is situated under the dust chamber
cap and you can use it
Press the button and
?
?
?
?
permanently.
pull the dust chamber
forward.
Gently
Shake off
Clean the motor filter with the brush under cold
Do not
running
Allow the motor filter to
dry
in
a
shaded location for
a
day.
The motor filter should be cleaned at least every 6 months.
runs
clear. Do not
excess
use
separately
under
detergent
or a
microwave
completely dry.
Re-assemble and
place
If the filter is
a cold running water until the water
washing machine or dishwasher.
water from the filter.
tumble/spindry,
Ensure the filter is
Please
10
rinse both parts
the dust chamber cap.
Remove the motor filter by rotating it counter-clockwise.
Open
water.
?
WARNING!
or
place
in
oven or on
it back in your machine, filter frame.
damaged, do
call the Helpline.
not
place them
in the machine.
direct heat.
Cleaning
Open
the Dust Chamber
the dust chamber cap.
Cleaning
Remove two
plates
from
?
The exhaust filter is
?
To
the dust chamber.
change
the filter
Gently
a
washable reusable HEPA filter.
the exhaust
cover on
the
filter,
Pull out the exhaust filter.
?
Clean it with
use
remove
body by
?
Do Not
Wash both
the Exhaust Filter
cold, running
release hook.
water.
the brush
-Using
the brush will
dust to
bypass
cause
permanent damage and allow
the filter.
?
Allow exhaust filter to
?
The exhaust filter should be cleaned at least
dry
in
a
shaded location for
parts with soft cloth.
parts
rinse both
under cold
running
a
once a
water.
11
dry.
year.
What to Do if Your Vacuum Cleaner Does Not Work
Check that the
vacuum
cleaner is
correctly plugged
in
correctly
and that the electrical socket is
What to Do When Suction Performance Decreases
?
Turn off the
?
Check the
?
Check that the dust chamber is not full.
?
Check that the motor filter
?
Check that the exhaust filter is not blocked. Clean the exhaust
12
vacuum
cleaner and
telecsopic tube,
it.
unplug
flexible hose and
light
is not
cleaning tool for blockages
Empty if necessary.
on.
Clean the motor
or
obstructions.
filter, if necessary.
filter, if necessary.
working.
Notes
13
Notes
14
P/No.: 3828Fi2842A
Download PDF