Samsung | ET-YC200 | Samsung Gear 360 配件套裝 User Manual

繁體中文(香港)
快速入門
指南
ET-YC200
版權 © 2016 Samsung Electronics
Bluetooth® 是 Bluetooth SIG, Inc. 在全球的
註冊商標。
• 使用裝置之前,請先閱讀本指南,以確保安
全和正確使用。
• 圖像可能與實際產品的外觀不同。內
容如有更改,恕不另行通知。請瀏覽
www.samsung.com/hk 以檢視裝置資訊、
最新指南和更多。
• 使用此貴重的工具之前,確保它與您的裝
置兼容。
• 您的消費者權益受產品購買所在國的法律
保護。請聯絡您的服務供應商以瞭解更多
資訊。
A
E
B
根據目標表面使用平面底座 (
面底座 (
)。
1
1
C
3. 使用搭扣將 Gear 360 與底座相連,直到聽
到扣入的聲音。( )
2
2
3
若要從底座取下搭扣,按住搭扣兩端,將搭
扣從底座中滑出,然後旋轉固定螺絲,將搭
扣從 Gear 360 取下。( )
將 Gear 360 連接至搭扣或從中取下
時,請務必旋轉固定螺絲而非 Gear
360,以免損壞元件。
1
a
b
c
使用遙控器
D
e
將三腳架插入 Gear 360,旋轉以緊固。(
Printed in Korea
GH68-46229A Rev.1.0
HK Type 05/2016
指示燈
電池蓋
快門鍵
遙控器盒
電源開關
連接三腳架
)
連接底座
1. 將搭扣插入 Gear 360,旋轉固定螺絲以
緊固。( )
2. 撕下底座背面膠帶上的保護層,將底座按
壓在目標表面上以緊固。( )
3. 遙控器 將電源開關滑動至 ON 以開啟
遙控器。
遙控器與 Gear 360 相互連接,指示燈閃
爍藍色。
如果遙控器無法連接至 Gear 360,按
住快門鍵超過 10 秒以重設遙控器。
錄製影片或拍照
按下快門鍵以拍照或錄製影片。指示燈將閃
爍綠色。
再次按下快門鍵以停止錄製影片。指示燈將
閃爍紅色。
更換電池
裝置結構圖
d
2
1
) 或曲
連接遙控器至 Gear 360
已透過藍牙配對遙控器與 Gear 360 時拍照
與錄製影片。
1. Gear 360 按住功能表鍵。
2. Gear 360 按下功能表鍵,直到遙控器已
選定,然後按下確定鍵進行選擇。
如果按下快門鍵時指示燈未閃爍,請更換
電池。
以打開,然後更換電池。
旋轉電池蓋至
僅可使用 CR1632 電池。
存放遙控器
將遙控器放入遙控器盒,然後將盒子放入三
腳架的任何一根支架中以便保管。
安全資訊
使用裝置前,請先閱讀所有安全資訊以確認
安全和正確使用。若要檢視完全的安全資
訊,請參閱三星網站。
使用製造商認可的配件和用品
請勿用濕手觸碰裝置
請勿使裝置跌落,或對其造成碰撞
請勿過度彎曲或扭曲裝置
裝置可在環境溫度介於 0 ℃ 至 35 ℃ 之間
的位置使用。可以在 -20 ℃ 至 50 ℃ 之間
的環境溫度下存放裝置。在推薦的溫度範圍
以外使用或存放裝置可能會損壞裝置或縮短
電池的壽命
裝置只能用於指定用途
請勿讓兒童或動物咀嚼或吞下裝置
請勿拆卸、改裝或修理裝置
請於 24 小時後確認底座的粘附力已達到最
大。請勿重複使用從表面撕下的膠帶
English
QUICK
START
GUIDE
Copyright © 2016 Samsung Electronics
Bluetooth® is a registered trademark of Bluetooth
SIG, Inc. worldwide.
• Please read this guide before using the device to
ensure safe and proper use.
• Images may differ in appearance from the actual
product. Content is subject to change without
prior notice. Visit www.samsung.com/hk to view
device information, the latest guide, and more.
• Before using the value kit, make sure it is
compatible with your device.
• Your consumer rights are governed by the law of
the country in which you purchased the product.
Please contact your service provider for more
information.
A
2
ET-YC200
1
E
B
Depending on the target surface, use the flat
mount ( ) or curved mount (
).
1
1
2
2
C
3
1
a
b
c
D
3. Attach the Gear 360 with the buckle to the
mount until you hear a click. ( )
To remove the buckle from the mount, slide the
buckle out of the mount while pressing both sides
of the buckle and then rotate the mounting screw
to remove the Gear 360 from the buckle. ( )
Make sure that you rotate the mounting
screw instead of the Gear 360 when
connecting or removing the Gear 360
from the buckle to avoid damaging the
components.
Using the remote control
d
Device layout
Indicator light
Battery cover
Connecting the tripod
Shutter key
Remote control
case
Insert the tripod into the Gear 360 and rotate it to
attach it. ( )
Power switch
e
Connecting the mount
1. Insert the buckle into the Gear 360 and rotate the
mounting screw to attach it. ( )
2. Peel off the cover of the adhesive tape on the
back of the mount and press the mount against
the target surface to attach it. ( )
Connecting the remote control to the Gear
360
Take photos and record videos remotely while
pairing the remote control and Gear 360 via
Bluetooth.
1. Gear 360 Press and hold the Menu key.
2. Gear 360 Press the Menu key until Remote
control is selected, and then press the OK key
to select it.
3. Remote Control Slide the Power switch to
ON to turn on the remote control.
The remote control and Gear 360 are connected
to each other and the indicator light flashes
blue.
If the remote control fails to connect to the
Gear 360, press and hold the Shutter key for
more than 10 seconds to reset the remote
control.
Recording videos or taking photos
Press the Shutter key to take photos or record
videos. The indicator light will flash green.
Press the Shutter key again to stop recording
videos. The indicator light will flash red.
Replacing the battery
If the indicator light does not flash when you press
the Shutter key, replace the battery.
Rotate the battery cover to to open it, and then
replace the battery.
You can only use a CR1632 battery.
Storing the remote control
Insert the remote control into the remote control
case and put the case into any leg of the tripod for
easy storage.
Safety information
Read all safety information before using the device
to ensure safe and proper use. To view the full safety
information, refer to the Samsung website.
Use manufacturer-approved accessories and
supplies
Do not touch the device with wet hands
Do not drop or cause an impact to the device
Do not bend or twist the device excessively
The device can be used in locations with an
ambient temperature of 0°C to 35°C. You can store
the device at an ambient temperature of -20°C to
50°C. Using or storing the device outside of the
recommended temperature ranges may damage
the device or reduce the battery’s lifespan
Use the device only for their intended purposes
Do not allow children or animals to chew or suck
the device
Do not disassemble, modify, or repair your device
Make sure that the maximum adhesion of the
mount occurs after 24 hours. Do not reuse the
adhesive tape after detaching it from the surface
Download PDF

advertising