Samsung | OH75F | Samsung OH75F Quick Setup Guide

Reverse Side
QUICK SETUP GUIDE
USB
HDBT
(LAN IN)
HDMI IN 1
HDMI IN 2
AUDIO
OUT
RS232C
IN
OH75F
1Connect to a USB memory device.
2- Sends the HDMI signal to a connected LAN cable using an HDBaseT transmitter.
- Connects to MDC using a LAN cable.
3Connects to a source device using a HDMI cable or HDMI-DVI cable.
4Outputs sound to an audio device via an audio cable.
5Connects to MDC using an RS232C adapter.
The colour and the appearance may differ depending on the product, and the
specifications are subject to change without prior notice to improve the performance.
Download the user manual from the website for further details.
http://www.samsung.com/displaysolutions
The terms HDMI and HDMI High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing LLC in the
United States and other countries.
BN68-08604K-00
Parts
Checking the Components
Contact the vendor where you purchased the product if any
components are missing.
The pictures may look different from the actual components.
Troubleshooting Guide
Issues
Solutions
Issues
Solutions
The screen keeps
switching on and off.
Check the cable connection between
the product and PC, and ensure the
connection is secure.
Picture quality of the
product is different
from the dealer
shop where it was
purchased.
Use an HDMI cable to obtain highdefinition (HD) picture quality.
The remote control
does not work.
Make sure that the batteries are correctly
in place (+/-).
No Signal is displayed Check that the product is connected
on the screen.
correctly with a cable.
QUICK SETUP GUIDE
Warranty card
(Not available in some locations)
DVD
Remote sensor
Press a button on the remote control pointing at the sensor on the
front of the product to perform the corresponding function.
- Using other display devices in the same space as the remote
control of this product can cause the other display devices to be
inadvertently controlled.
Batteries
(Not available in some
locations)
Remote Control
Check that the device connected to the
product is powered on.
MagicInfo Software
Refer to the Standard Signal Mode Table
and set the maximum resolution and
frequency according to the product
specifications.
Cover-Cap X 16
The images on the
Check the cable connection to the
screen look distorted. product.
The screen appears
unstable and shaky.
There are shadows or
ghost images left on
the screen.
There is no image on
the screen and the
power LED blinks
every 0.5 to 1 second.
BN68-08604K-00_QSG_OH75F_INDIA_ENG.indd 1
Check if the batteries are flat.
Not Optimum Mode is This message is displayed when a
displayed.
signal from the graphics card exceeds
the product’s maximum resolution and
frequency.
Check that the resolution and frequency
of the PC and graphics card are set within
a range compatible with the product.
Then, change the screen settings if
required by referring to the Additional
Information on the product menu and the
Standard Signal Mode Table.
The product is in power-saving mode.
Press any key on the keyboard or move the
mouse to return to the previous screen.
Check for power failure.
Make sure that the power cord is connected.
Check for any special lighting or neon
signs switched on in the vicinity.
A beeping sound is
heard when my PC is
booting.
If a beeping sound is heard when your PC
is booting, have your PC serviced.
The product smells
like plastic.
The plastic smell is normal and
disappears over time.
Small particles are
The particles are part of the product
found on the edges of
design. The product is not defective.
the product.
When I try to change
the PC resolution, a
message The
defined resolution
is not supported.
appears.
The message The defined resolution
is not supported. appears if the input
source resolution exceeds the maximum
resolution of the display.
To resolve the issue, change the PC
resolution to a resolution supported on
the display.
2018-04-09 오전 10:37:13
DBJ: HDMI IN 1 (ARC), HDMI IN 2
DCJ: HDMI IN 1, HDMI IN 2
HDMI IN 1, HDMI IN 2
Connecting to a PC
DBJ, DCJ: DVI/HDMI/AUDIO
IN
Connecting
to an Audio
System
Specifications
Model Name
DBJ, DCJ: DVI/MAGICINFO IN
OH75F
Panel
AUDIO OUT
HDMI IN 1, HDMI IN 2
Size
189.3 cm
Display area
1650.24 mm (H) x 928.26 mm (V)
AC100-240V~ 50/60Hz
Refer to the label at the back of the product as the standard voltage can vary in different countries.
Power Supply
DBJ, DCJ: DVI/HDMI/AUDIO IN
RS232C IN
Operating
DBJ, DCJ: DVI/MAGICINFO IN
Environmental
considerations
RS232C OUT
Storage
HDMI IN 1, HDMI IN 2
DBJ, DCJ: DVI/HDMI/AUDIO IN
Connecting to MDC
RJ45 (LAN OUT)
HDMI IN 1, HDMI IN 2
HDMI IN 1, HDMI IN 2
DCJ: DVI/MAGICINFO IN
Temperature : -30 ℃ – 50 ℃ (-22 °F – 122 °F)
Humidity : 10% – 80%, non-condensing
Temperature : -20 °C – 50 °C (-4 °F – 122 °F)
Humidity : 5% – 95%, non-condensing
- This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to
take adequate measures.
- For detailed device specifications, visit the Samsung Electronics website.
- The PVC Free (except for accessory cables) logo is the self-declared trademark of Samsung.
* Accessory cables: signal cables and power cords
RS232C IN
RS232C OUT
Connecting to a Video Device
RS232C OUT
DCJ: DVI/HDMI/AUDIO IN
DBJ, DCJ: DVI/MAGICINFO IN
HDMI IN 1, HDMI IN 2
DCJ: DVI/MAGICINFO IN
DBJ, DCJ: DVI/HDMI/AUDIO IN
HDBT (LAN IN)
HUB
Warning! Important Safety Instructions
(Please read the appropriate section that corresponds to the marking on your Samsung product before attempting to install the product.)
RJ45 (LAN OUT)
CAUTION
DCJ: DVI/HDMI/AUDIO IN
DBJ, DCJ: DVI/MAGICINFO IN
RISK OF ELECTRIC SHOCK DO NOT OPEN
RS232C OUT
HDMI IN 1, HDMI IN 2
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). THERE ARE NO USER SERVICEABLE
PARTS INSIDE. REFER ALL SERVICING TO QUALIFIED
PERSONNEL.
DBJ, DCJ: DVI/HDMI/AUDIO IN
For details on how to use the MDC programme, refer to Help after
installing the programme.
The MDC programme is available on the website.
HDMI IN 1, HDMI IN 2
RJ45 (LAN OUT)
DCJ: DVI/MAGICINFO IN
Connecting the HDBase-T
DCJ: DVI/HDMI/AUDIO IN
DCJ: DVI/MAGICINFO IN
HDMI OUT
DCJ: DVI/HDMI/AUDIO IN
HDBT (LAN IN)
HUB
»» If your equipment uses an AC adapter:
- Only use the AC adapter with your product by
Samsung.
- Do not use the power cord with other products.
»» Do not install this equipment in a confined space such as a case
or similar.
»» The slots and openings in the cabinet and in the back or bottom
are provided for necessary ventilation. The slots and openings
must never be blocked or covered.
»» The product should be located away from heat sources such as
radiators, heat registers, or other products that produce heat.
This symbol indicates that high voltage is present
inside. It is dangerous to make any kind of contact
with any internal part of this product.
This symbol indicates that this product has included
important literature concerning operation and
maintenance.
»» Do not place a water containing vessel (vases etc.) on this
apparatus, as this can result in a risk of fire or electric shock.
(Apparatus shall not be exposed to dripping or splashing)
»» The apparatus must be connected to an earthed MAINS socketoutlet (Class l Equipment only). Or Use only a properly grounded
plug and receptacle (Class l Equipment only).
»» To disconnect the apparatus from the mains, the plug must be
pulled out from the mains socket, therefore the mains plug shall
be readily operable.
»» As long as this unit is connected to the AC wall outlet, it is not
disconnected from the AC power source even if you turn off this
unit by POWER.
This product is RoHS compliant.
This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g. charger,
headset, USB cable) should not be disposed of with other household waste at the end of their working life. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, please separate these items from
other types of waste and recycle them responsibly to promote the sustainable reuse of material resources.
For more information on safe disposal and recycling visit our website www.samsung.com/in or contact our Helpline numbers
- 1800 40 SAMSUNG (1800 40 7267864) (Toll-Free)
HDBase-T (Tx)
LAN
HDMI IN
HDMI OUT
Contact SAMSUNG WORLD WIDE
If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care centre.
Tel. 1800 40 SAMSUNG (1800 40 7267864) (Toll-Free)
http://www.samsung.com/in/support
LAN Cable
HDMI OUT
BN68-08604K-00_QSG_OH75F_INDIA_ENG.indd 2
2018-04-09 오전 10:37:15
Download PDF