Whirlpool SA4 844 P IX Installation guide

Health & Safety and Installation guide
EN ENGLISH
Health and Safety guide
Installation guide
2
3
6
SAFETY INSTRUCTIONS
IMPORTANT TO BE READ
AND OBSERVED
Before using the appliance read
these safety instructions.
Keep them for future reference.
These instructions and the
appliance itself provide
important safety warnings, to be
observed at all times.
The manufacturer declines any
liability for failure to observe
these safety instructions, for
inapropriate use of the
appliance or incorrect setting of
controls.
Keep clothes or other flammable
materials away from the
appliance, until all the
components have cooled down
completely.
Excess spillage and any object
must be removed from the oven
cavity before cleaning cycle.
Overheated oils and fats catch
fire easily. Always be vigilant
when cooking food rich in fat,
oil or when adding alcohol (e.g.
rum, cognac, wine) - risk of fire.
Use oven gloves to remove pans
and accessories, taking care not
to touch the heating elements.
At the end of cooking, exercise
SAFETY WARNINGS
caution when opening the door,
Very young (0-3 years) and
by letting the hot air or steam
young children (3-8 years) shall
exit gradually before accessing
be kept away from the appliance the appliance.
unless continuously supervised. Do not obstruct hot air vents at
Children from 8 years old and
the front of the oven.
above and persons with reduced During and after the pyrolysis
physical, sensory or mental
cycle, the animals have to be
capabilities or lack of experience kept away from the area of the
and knowledge can use this
appliance location.
appliance only if they are
supervised or have been given
PERMITTED USE
instructions on safe use and
CAUTION: The appliance is not
understand the hazards
involved. Children must not play intended to be operated by
with the appliance. Cleaning and means of an external timer or
separate remote controlled
user maintenance must not be
system.
carried out by children without
This appliance is solely for
supervision.
domestic, not professional use.
WARNING: The appliance and
Do not use the appliance
its accessible parts become hot
outdoors.
during use, children less than 8
Do not store explosive or
year of age shall be kept away
unless continuously supervised. flammable substances such as
aerosol cans and do not place or
WARNING: Avoid touching
use gasoline or other flammable
heating elements or interior
materials in or near the
surface - risk of burns.
appliance: a fire may break out if
Never leave the appliance
unattended during food drying. the appliance is inadvertently
switched on.
If the appliance is suitable for
No other use is permitted
probe usage, only use the
(e.g. heating rooms).
temperature probe
recommended for this oven.
Do not touch the oven during
pyrolisis cycle. Keep childern
away from the oven during the
pyrolisys cycle (unitl the
complete ventilation of the
room).
EN
EN
INSTALLATION
The appliance must be handled
and installed by two or more
persons. Use protective gloves
to unpack and install the
appliance.
Installation and repairs must be
carried out by a qualified
technician, in compliance with
the manufacturer’s instructions
and local safety regulations. Do
not repair or replace any part of
the appliance unless specifically
stated in the user manual.
Children should not perform
installation operations. Keep
children away during
installation. Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, during and
after the installation.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In
the event of problems, contact
the dealer or your nearest Aftersales Service.
The appliance must be
disconnected from the power
supply before any installation
operation.
During installation, make sure
the appliance does not damage
the power cable.
Only activate the appliance
when the installation has been
completed.
After installation, the bottom of
the appliance must no longer be
accessible.
Carry out all cabinet cutting
works before fitting the
appliance in the furniture and
carefully remove all wood chips
and sawdust.
Do not obstruct the minimum
gap between the worktop and
the upper edge of the oven.
Only remove the oven from its
polystyrene foam base at the
time of installation.
Do not install the appliance
behind a decorative door - Risk
of fire.
3
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3 mm is required
and the appliance must be
earthed.
If the power cable is damaged,
replace with an identical one.
The power cable must only be
replaced by a qualified
technician in compliance with
the manufacturer instruction
and current safety regulations.
Contact an authorized service
center.
It must be possible to
disconnect the appliance from
the power supply by unplugging
it if plug is accessible, or by
means of an accessible multipole switch installed upstream
of the socket in conformity with
national electrical safety
standards.
The rating plate is on the front
edge of the oven (visible when
the door is open).
In case of replacement of power
cable, contact an authorized
service center.
If the fitted plug is not suitable
for your socket outlet, contact a
qualified technician.
The power cable must be long
enough to connect the
appliance, once fitted in its
housing, to the main power
supply. Do not pull the power
supply cable.
Do not use extension leads,
multiple sockets or adapters.
Do not operate this appliance if
it has a damaged mains cord or
plug, if it is not working
properly, or if it has been
damaged or dropped. Keep the
cord away from hot surfaces.
The electrical components must
not be accessible to the user
after installation.
Do not touch the appliance with
any wet part of the body and do
not operate it when barefoot.
4
CLEANING AND
MAINTENANCE
Never use steam cleaning
equipment.
WARNING: Ensure that the
appliance is switched off before
replacing the lamp to avoid the
possibility of electric shock.
Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean the appliance door glass
since they can scratch the
surface, which may result in
shattering of the glass.
Remove all accessories before
running the pyrolytic function
(also the lateral grids).
Wear protective gloves for
cleaning and maintenance.
The appliance must be
disconnected from the power
supply before any maintenance
operation.
Ensure the appliance is cooled
down before carrying out any
cleaning or maintenance
operation.
If the oven is installed below a
hob, make sure that all burners
or electric hotplates are
switched off during the
selfcleaning (pyrolytic) function.
EN
SAFEGUARDING THE ENVIRONMENT
DISPOSAL OF PACKAGING
MATERIALS
The packaging material is 100%
recyclable and is marked with the
recycle symbol . The various parts
of the packaging must therefore be
disposed of responsibility and in full
compliance with local authority
regulations governing waste disposal.
SCRAPPING OF HOUSEHOLD
APPLIANCES
When scrapping the appliance, make
it unusable by cutting off the power
cable and removing the doors and
shelves (if present) so that children
cannot easily climb inside and
become trapped.
This appliance is manufactured with
recyclable or reusable materials.
Dispose of it in accordance with local
waste disposal regulations.
For further information on the
treatment, recovery and recycling of
household electrical appliances,
contact your competent local
authority, the collection service for
household waste or the store where
you purchase the appliance.
This appliance is marked in
compliance with European Directive
2012/19/EU, Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed
of correctly, you will help prevent
potential negative consequences for
the environment and human health,
which could otherwise be caused by
inappropriate waste handling of this
product.
on the product or on
The symbol
the accompanying documentation
indicates that it should not be treated
as domestic waste but must be taken
to an appropriate collection center for
the recycling of electrical and
electronic equipment.
ENERGY SAVING TIPS
Only preheat the oven if specified in
the cooking table or your recipe.
Use dark lacquered or enamelled
baking moduls as they absorb heat far
better.
Standard cycle (PYRO): which is
suitable for cleaning a very dirty oven.
Energy-saving cycle (PYRO EXPRESS/
ECO) - only in some models - : which
consumes approximately 25% less
energy than the standard cycle.
Select it at regular intervals (after
cooking meat on 2 or 3 consecutive
occasions).
DECLARATION OF CONFORMITY
This appliance has been designed,
constructed and distributed in
compliance with the requirements of
European Directives:
LVD 2014/35/EU, EMC 2014/30/EU and
RoHS 2011/65/EU.
This appliance, which is intended to
come into contact with foodstuffs,
complies with European Regulation
n. 1935/2004.
This appliance meets the Eco Design
requirements of European Regulations
n. 65/2014, and n. 66/2014 in
conformity to the European standard
EN 60350-1.
5
x2
90°C
6
EN
20
423
557
97
478
595
89° max
525
570
5
4
595
549
min 560
min 560
560
600
40
560
583+2
40
5
7
=
001
8
=
x2
4 0 0 010 9 0 4 015
Printed in Italy