Swan STV 407W (UK) Instruction for Use

Add to my manuals
4 Pages

advertisement

Swan STV 407W (UK) Instruction for Use | Manualzz
Instruction booklet
TUMBLE DRYER
STV 407W
STV 407B
This symbol reminds you to read this booklet.
WHERE TO INSTALL THE TUMBLE DRYER
10 mm
If you are going to install the
appliance under a work
counter be sure to leave a
10 mm space between the
top and any other objects on
or above the machine and a
15 mm
15 mm
15 mm space between the
sides and any kitchen units
or walls to ensure proper air circulation. The
dryer must never be installed behind a lockable
door, a sliding door or a door with a hinge on the
opposite side to that of the dryer door.
The appliance must be installed with the rear
surface placed against a wall.
VENTILATION
When the dryer is in use there has to be adequate
ventilation to avoid the back flow of gases into
the room from appliances burning other fuels,
including open fires. The vent tube should not exceed 2.4
metres in length. The tube should be kept clear of the air intake
vent and kinks or ‘U’ bends must be avoided as these will obstruct
the tube and trap condensation.
VENTING
Air intake vent
Do not block or obstruct
Caution: Hot!
B
A
Vent Tube fitted here
Wall mounting
Keep the tube as short and as straight
as possible to prevent condensation
forming in the vent pipe.
The duct in the wall should slope
slightly downwards.
Window mounting
The hole in the window should be as
low down as possible and the tube should be kept as short as
possible.Depending on how often you use your tumble dryer, it is
essential that areas A and B are checked periodically to remove
lint or debris.
Open window venting
The end of the tube should be
directed downwards, to prevent
warm moist air from condensing in
the room or dryer.
Do not discharge exhaust
air into a flue which is used
for exhaust fumes from
other appliances that burn gas or other fuels.
Do not discharge exhaust air into an extraction system or any duct
with an extractor fan. This will affect the way the thermal controls
operate and can result in a fire hazard.
ELECTRICAL CONNECTIONS
The socket must be grounded. The power supply
cord should be checked periodically. If the
supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazar
LEVELLING YOUR DRYER
The dryer must be installed level for
correct operation. When you have
installed your dryer in its final location
check that it is first level side to side and
then back to front.
If the dryer is not level use a wooden
block to support it while adjusting the
two front legs up or down until your dryer is level.
BEFORE YOU START USING YOUR DRYER
Once you have installed your dryer and before you
use it clean the inside of the drum to remove any
dust that could have accumulated during transport.
Step 1
Open the door of your dryer
Step 2
Pull out the filter (using the
two finger grips)
Step 3
Clean the fluff off the filter
and replace it correctly.
Ensure that the filter is
pushed fully home.
Step 4
Make sure the filter is pushed fully home
NEVER run the dryer without the filter in position
Failure to clean the filter after EVERY drying
cycle will affect the drying performance of your
machine. It will take longer to dry and as a result
will use more electricity during drying.
At least every two or three months you MUST
clean fluff build up around the filter housing and
the vent tube.
Check the vent tube and any permanent venting fixture to make sure that there has been no
accumulation of fluff or lint. Remove lint that collects around the filter and the outlet vents.
Warnings
! This appliance has been designed and built according to
international safety standards. These warnings are given for
safety reasons and must be followed carefully.
GENERAL SAFETY
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use
of the appliance in a safe way and understand the
hazards involved.
This tumble dryer has been designed for home,
and not professional, use.
Do not touch the appliance while barefoot or with
wet hands or feet.
Unplug the machine by pulling on the plug, not
the cord.
Children should be supervised to ensure that
they do not play with the dryer.
Cleaning and user maintenance shall not be
made by children without supervision.
Children of less than 3 years should be kept
away from the appliance unless continuously
supervised.
The appliance must be installed correctly and
have proper ventilation. The air intake vents
behind the machine, the outlet vents and the vent
tube should never be obstructed
Never direct the vent tube outlet towards the air
intake at the back of the machine.
Never allow the tumble dryer to recycle exhaust air.
Never use the dryer on carpeting where the pile
height would prevent air from entering the dryer
from the base.
Check to see if the dryer is empty before loading it.
The back of the dryer could become very hot.
Never touch it while in use.
Do not use the dryer unless the filter is securely
in place
Do not overload the dryer
Do not load items that are dripping wet.
Carefully check all instructions on clothing labels
Do not tumble dry large, very bulky items.
Do not tumble dry acrylic fibres at high
temperatures.
Do not turn off the dryer when there are still
warm items inside.
Clean the filter after each use
Do not allow lint to collect around the dryer.
Never climb on top of the dryer. It could result in
damage.
Always follow electrical standards and
requirements
Always buy original spare parts and accessories
To minimise the risk of fire in your tumble
dryer, the following should be observed:
Tumble dry items only if they have been washed
with detergent and water, rinsed and been
through the spin cycle. It is a fire hazard to dry
items that HAVE NOT been washed with water.
Do not dry garments that have been treated with
chemical products.
Do not tumble dry items that have been spotted
or soaked with vegetable or cooking oils, this
constitutes a fire hazard. Oil-affected items can
ignite spontaneously,especially when exposed to
heat sources such as a tumble dryer. The items
become warm, causing an oxidisation reaction
with the oil, Oxidisation creates heat. If the heat
cannot escape, items can become hot enough to
catch fire. Piling, stacking or storing oil-effected
items can prevent heat from escaping and so
create a fire hazard.If it is unavoidable that fabrics
containing vegetable or cooking oil or those that
have been contaminated with hair care products
be placed in a tumble dryer they should first be
washed with extra detergent - this will reduce,
but not eliminate the hazard. They should not
be removed from the dryer and piled or stacked
while hot.
Do not tumble dry items that have previously
been cleaned in or washed in, soaked in or
soiled with petrol/gasoline, dry cleaning solvents
or other flammable or explosive substances.
Highly flammable substances commonly used
in domestic environments including cooking
oil, acetone, denatured alcohol, kerosene, spot
removers, turpentine, waxes and wax removers.
Ensure these items have been washed in hot
water with an extra amount of detergent before
being dried in the tumble dryer.
Do not tumble dry items containing foam rubber
(also known as latex foam), or similarly textured
rubber like materials. Foam rubber materials
can, when heated, produce fire by spontaneous
combustion.
Fabric softener or similar products should not be
used in a tumble dryer to eliminate the effects of
static electricity unless the practice is specifically
recommended by the manufacturer of the fabric
softener product.
Do not tumble dry undergarments that contain
metal reinforcements eg. bras with metal
reinforcing wires. Damage to the tumble dryer
can result if the metal reinforcements come loose
during drying.
Do not tumble dry rubber, plastic articles such
as shower caps or babies waterproof covers,
polythene or paper.
Do not tumble dry rubber backed articles, clothes
fitted with foam rubber pads, pillows, galoshes
and rubber coated tennis shoes.
Remove all objects from pockets such as lighters
and matches.
WARNING: Never stop the dryer before the end
of the drying cycle unless all items are quickly
removed and spread out so that the heat is
dissipated.
Laundry
Dryer Description
Max Load:Natural fibres: 7kg
Control panel
WASH CARE LABELS
TIMER
Knob
START
Button
HEAT
Button
Synthetic fibres: 3kg
The TIMER knob: the 0 position swithes off the dryer.
The TIMER knob sets the drying time: rotate it clockwise, NEVER
COUNTER-CLOCKWISE, until the indictor is pointing to the drying
time you want to select.
CHOOSING A PROGRAMME
Look at the labels on your garments when tumble drying. The
following symbols are the most common.
May be tumble dried
Do NOT tumble dry
Tumble dry at high heat setting
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type.
3. Open the door and make sure the filter is clean and in place.
4. Load the machine and make sure items are not in the way of the
door seal. Close door.
Tumble dry at low heat setting
5. Set the temperature with the HEAT button. High heat for Cotton
and synthetics. Low heat for delicates and acrylics.
ITEMS NOT SUITABLE FOR TUMBLE
DRYING
6. Select a drying time by rotating the TIMER knob clockwise.
The tables below show APPROXIMATE drying times in minutes.
Weights refer to dry garment weights.
1. Articles that contain rubber or rubber-like materials or plastic
film, any flammable articles or objects that contain flammable
substances.
7. Press the START button to begin. During the drying programme,
you can check on your laundry and take out items that are dry
while others continue drying. When you close the door again
press the START button in order to resume drying.
2. Glass fibres.
8. About 10 minutes before the programme is completed it enters
the final COOL TUMBLE phase (fabrics are cooled) which should
always be allowed to complete.
9. Open the door, take the laundry out, clean the filter and
replace it.
10. Unplug the dryer.
3. Items which have been dry cleaned.
4. Large bulky items (quilts, sleeping bags, etc). These expand
when drying and prevent airflow through the dryer.
Troubleshooting
Before you call the service centre go through the following
troubleshooting suggestions:
PROBLEM:
The dryer won’t start.
Standard Cotton - High (full) Heat
This is the most efficient program in terms of energy consumption (EU 392/2012). To reach maximum efficiency, select the
highest temperature option.
Drying times 800-1000rpm spin in washing machine
1-2kg
3-4kg
5-6kg
7kg
20-45mins
45-70mins
70-100mins
90-120mins
POSSIBLE CAUSES/SOLUTION:
• The plug is not in the socket or making contact.
• There has been a power failure.
• The fuse has blown. Try to plug another appliance into the
socket.
• You are using an extension cord? Try to plug the dryer directly
into the socket.
• The timer knob has not been set properly.
• The start button has not been pressed.
Synthetics - High (full) Heat
• The start button was pressed with the door open. Make sure the
door is closed before pressing the start button.
Drying times on reduced spin in washing machine
1kg
2kg
3kg
20-30mins
35-45mins
45-60mins
PROBLEM:
It is taking a long time to dry.
Acrylics - Low (gentle) Heat
POSSIBLE CAUSES/SOLUTION:
Drying times 800-1000rpm spin in washing machine
• The filter has not been cleaned.
1kg
2kg
25-40mins
40-60mins
• The temperature setting is not correct.
• The correct time has not been selected.
• The vent tube or air intake vent is obstructed.
• The items were too wet.
• The dryer was over loaded.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European Directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE) requires that old household electrical
appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in
order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation that when you dispose of the appliance it
must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct
disposal of their old appliance.
Power consumption
off-mode (Po) - Watts
0.00
left-on mode (Pl) - Watts
N/A
Programs
Kg
kWh
Minutes
Standard cotton*
7
4.55
117
Standard cotton
3.5
2.34
66
Synthetics
3
1.11
40
* This is the reference program for the energy label
and suitable to dry normal wet cotton laundry. This
is the most efficient programme in terms of energy
consumption for drying wet cotton laundry.
Swan Products Ltd
Shop Direct Group
L70 1AB
BoxMPRC8
http://www.swan-brand.co.uk/
19512508402
10/2017
INFORMATION ON RECYCLING
AND DISPOSAL
As part of our continual commitment towards environmental
protection, we reserve the right to use recycled quality
components to reduce costs for our customers and to minimise
materials wastage.
• Disposing of the packaging materials: follow local regulations to
allow for recycling of packaging materials.
• In order to minimise the risk of injury to children, remove the
door and plug, then cut the power supply cord flush with the
appliance. Dispose of these parts separately to prevent the
appliance from being connected to a power supply socket.
SAVE ENERGY AND RESPECT
THE ENVIRONMENT
Wring out all items to eliminate excess water before tumble
drying (if you use a washing machine first, select a high spin
cycle). Doing this will save time and energy during drying.
Always dry full loads - you save energy: single items or small
loads take longer to dry. Clean the filter after each use to contain
energy consumption costs
AFTER SALES SERVICE
UK: 0330 1003394
REPUBLIC OF IRELAND: 0818 904010
OUR ADVISORS WILL REQUIRE THE FOLLOWING INFORMATION:
• name, address and postal code
• telephone number
• type of malfunction
• date of purchase
•
•
•
model number
serial number
This information can be found on the data plate located
behind the door.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement