Whirlpool | UH4 1T W | Setup and user guide | Whirlpool UH4 1T W Setup and user guide

QUICK START GUIDE
EN
Read the Instructions for Use carefully before
using the appliance.
TEMPERATURE setting
Press the Temperature button on the control
panel to adjust the temperature from the warmest
through the lower to the coldest level.
Pressing the Temperature button, the temperature
setting will change cyclically.
At first plug-in of appliance temperature setpoint is
present at medium position (factory setting).
Following table shows temperature setpoints:
1
2
3
4
Indicator of temperature seetings
5
6
7
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
high temp.
FAST FREEZING function
9
10
Control panel
Ice tray*
Drawer divider*
Bottle rack*
Glass shelves
Rating plate with commercial name
Door reversibility kit
Area for freezing fresh food or to store frozen food
Area for storing frozen foods
Door seal
The use of this function is recommended
to increase the cooling speed when
placing a very high quantity of food in the
freezer compartment. To activate this
function press the Temperature button on
the control panel repeatedly until 3 LED’s
flash and then remain lit.
med-high temp.
medium temp.
med-low temp.
low temp.
The function is automatically deactivated
after 48 h.
Led
Led ON
ON
TEMPERATURE ALARM indicator
When the product is plugged in to the mains, during the first 10 minutes
of working, any temperature sensor failure will be displayed on the control
panel.
* Available on selected models
HOW TO START THE APPLIANCE
After plugging the appliance to the mains, it starts the
operation automatically. After starting the appliance,
wait at least 4-6 hours before placing food into the
appliance. When the appliance is connected to the
power supply, the display lights up and all the icons
appear on the display for approximately 1 second.
The default (factory) values of the fridge compartment
settings light-up.
Legend:
Led ON
Note: The Temperature alarm may activate if the door is left open for a
prolonged period of time or following the introduction of fresh food in the
freezer compartment; this temporary rise in temperature does not affect
the storage of already frozen food in any way.
Specifications, technical data and images may
vary from model to model
STAND-BY button
To put the product in Stand-by, press and hold for
3 seconds the Stand-by button. All the indicators
turn off. To reactivate the appliance press once
(briefly) or for 3 seconds this button.
Printed in Italy
To receive the assistance call the number shown on
the warranty booklet or follow the instruction on the
web site www.hotpoint.eu
Note: Displayed set points correspond to the
average temperature throughout the whole freezer.
Led
Led
flashing
OFF
The appliance will work anyway preserving the food stored, but it is
necessary to contact after-sales service and provide alarm code.
HOW TO REVERSE THE DOOR SWING
- see enclosed Instructions for Use
Is recommended to reverse door swing by two persons.
There is not foreseen door reversibility for:
- models with integrated handle
- models with glass panel on the door.
Led
Led OFF
OFF
03/16 - Whirlpool® Registered trademark/TM Trademark of Whirlpool, USA - © Copyright Whirlpool Europe s.r.l. 2014. All rights reserved - http://www.whirlpool.eu
8
DE
IT
TR GB
19514476200
Download PDF

advertising