Panasonic | CQC5300W | Operating instructions | Panasonic CQC5300W Operating Instructions

Panasonic CQC5300W Operating Instructions
E
N
G
L
I
S
H
E
N
G
L
I
S
H
Electrical Connections
Caution:
≥ This product is designed to operate with a 12 V
DC, negative ground battery system.
≥ To prevent damage to the unit, be sure to follow
the connection diagram below.
≥ Remove approximately 5 mm of protective
covering from the ends of the leads before
connecting.
≥ Do not insert the power connector into the unit
until the wiring is completed.
35
≥ Be sure to insulate any exposed wires from
a possible short-circuit from the car chassis.
Bundle all cables and keep cable terminals free
from touching any metal parts.
≥ Remember, if your car has a drive computer or
a navigation computer, the data of its memory
may be erased when the battery terminals are
disconnected.
Antenna
36
Subwoofer cord
(red)
S.W-OUT
(white)
CQ-C5400W
CD changer input cord
R (red)
CQ-C5300W
CQ-C5100W
CD.C-IN
L (white)
CQ-C5400W
AUX input cord
Wiring Diagram
CQ-C5300W
R (red)
AUX-IN
L (white)
Accessory used for wiring
No.
6
Item
Power connector
Q’ty
Monaural
Pre-amp output connector
(rear)
1
(front)
L (white)
R (red)
CD changer control connector
Fuse (mini auto fuse type, 15 A)
≥ If the fuse (rear panel) blows frequently, they may be
something wrong with the unit or wiring connection.
Consult your nearest Panasonic service station for service.
6 Power connector
External amplifier control power lead (max. 500 mA)
This lead is for connection to the power amplifier.
(Blue/white stripe)
(White)
Note:
≥ This lead is used for power control when an external
power amplifier is connected. The power supply of a
power amplifier will be activated when turning on the
power of this unit.
+
Front speaker lead
Left
(White/black stripe)
+
FRONT SP
(Gray)
To front
speaker
Right
-
Antenna control lead
(to motor antenna) (max. 100 mA)
This lead is not intended for use with switch actuated power antenna.
(Gray/black stripe)
(Blue)
(Green)
Note:
≥ The power antenna extends automatically when the
AM/FM radio mode is selected.
Rear speaker lead
(Green/black stripe)
REAR SP
+
Left
+
(Violet)
ACC power lead
To ACC power, i12 V DC.
Battery lead
To the car battery, continuous i12 V DC.
Ground lead
To a clean, bare metallic part of the car chassis.
58
CQ-C5400/5300/5100W
ACC
To rear
speaker
Right
-
(Red)
(Violet/black stripe)
BATTERY 15 A
(Yellow)
L
R
Caution:
≥ Do not connect more than
one speaker to one set of
speaker leads.
(Black)
CQ-C5400/5300/5100W
59
E
N
G
L
I
S
H
E
N
G
L
I
S
H
Electrical Connections (continued)
Upgrading the System
Speaker System Connection
37
Note:
≥ For wiring, carefully read the operating
instructions for the devices connected.
Example combination
≥ CD changer (CX-DP880, option)
CD changer
(CX-DP880, option)
R (red)
Example combination
≥ Stereo/mono power amplifier (CY-M7052EN,
option)
≥ 4 channel power amplifier (CY-M9054EN,
option)
≥ Subwoofer (option)
≥ Front speaker, rear speaker (option)
RCA cord (R)
Subwoofer
(option)
RCA cord (option)
CD changer input cord
CD.C-IN
38
Note:
≥ For wiring, carefully read the operating
instructions for the devices connected.
RCA cord (L)
Subwoofer cord
L (white)
Stereo/mono power amplifier
(CY-M7052EN, option)
(bridged connection)
DIN cord
CD changer control
connector
S.W-OUT
Extension cord
(supplied with CX-DP880)
Pre-amp output connector
(front)
(rear)
Ground lead (black)
Battery lead (yellow)
6 Power connector
External amplifier
control power lead
(Blue/white stripe)
Front speaker
(option)
RCA cord
(option)
Remove the vinyl
cap.
Rear speaker
(option)
4 channel power amplifier
(CY-M9054EN, option)
(bridged connection)
60
CQ-C5400/5300/5100W
CQ-C5400/5300/5100W
61
E
N
G
L
I
S
H
Specifications
39
Power supply:
General
Current consumption:
Maximum power output:
Tone adjustment range:
Equalizer center frequency:
Variable range of equalizer:
Speaker impedance:
FM Stereo Radio
DC 12 V (11 V–16 V),
test voltage 14.4 V,
negative ground
Less than 2.2 A
(CD mode;
0.5 W 4-speaker)
50 Wk4 (at 1 kHz)
volume control maximum
Bass: d12 dB at 62 Hz
Treble: d12 dB at 16 kHz
60 Hz, 160 Hz, 400 Hz,
1 kHz, 3 kHz, 6 kHz,
16 kHz
`12 dB to 12 dB
(2 dB step)
4–8 ≠
Frequency range:
87.50 MHz–108.00 MHz
Usable sensitivity:
10.2 dBf. (0.9 ¨V, 75 ≠)
50 dB quieting sensitivity: 15.2 dBf. (1.6 ¨V, 75 ≠)
Frequency response:
30 Hz–15 kHz (d3 dB)
Alternate channel selectivity: 75 dB
Stereo separation:
35 dB (1 kHz)
Image response ratio:
75 dB
IF response ratio:
100 dB
Signal to noise ratio:
62 dB
E
N
G
L
I
S
H
CD Player
Sampling frequency:
DA converter:
Pick-up type:
Light source:
Wave length:
Frequency response:
Signal to noise ratio:
Total harmonic distortion:
Wow and flutter:
Channel separation:
8 times oversampling
4 DAC system
Astigma 3-beam
Semiconductor laser
780 nm
20 Hz–20 kHz (d1 dB)
96 dB
0.01 % (1 kHz)
Below measurable limits
75 dB
40
AM Radio
Frequency range:
Usable sensitivity:
531 kHz–1 602 kHz
28 dB/¨V
(11 ¨V, S/N 20 dB)
CQ-C5400W
Pre-amp output voltage: 5 V
(CD mode; 1 kHz, 0 dB)
Subwoofer output voltage: 5 V
Pre-amp output impedance: 60 ≠
Subwoofer output impedance: 60 ≠
CQ-C5300W CQ-C5100W
Pre-amp output voltage: 2.5 V
(CD mode; 1 kHz, 0 dB)
Subwoofer output voltage: 2.5 V
Pre-amp output impedance: 200 ≠
Subwoofer output impedance: 200 ≠
Note:
≥ Specifications and design are subject to
modification without notice due to improvements.
Dimensions (WkHkD): 178k50k155 mm
Weight:
1.6 k
62
CQ-C5400/5300/5100W
CQ-C5400/5300/5100W
63
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising