Aeg-Electrolux | AG941 | User manual | Aeg AG935 User Manual

2
Front
Back
1
22
3
23
4
5
5
2
12
13
14
11
20
19
17
21
18
6
15
7
16
8
9
10
Content
3
English
Thank you for choosing an AEG Ergorapido vacuum
cleaner. Ergorapido is a rechargeable handheld
stick vacuum cleaner intended for use on light dry
household debris. In order to ensure the best results,
always use original AEG accessories. They have been
designed especially for your vacuum cleaner.
Table of contents
Unpacking and assembly. . . . . . . . . . . . . . . . . . . . . . 4
Charging. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Vacuuming. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Emptying and cleaning. . . . . . . . . . . . . . . . . . . . . . . . 7
Cleaning brush roll, hose and wheels. . . . . . . . . . . . . 8
Removing the batteries. . . . . . . . . . . . . . . . . . . . . . . 10
Safety precaution . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Consumer information. . . . . . . . . . . . . . . . . . . . . . . . 11
Features/Accessories
1 On/off button
2 On/off button, hand unit
3 Handle
4 Locking screw
5 Release button, hand unit
6 Charging station, wall unit
7 Charging station, floor unit
8 Adaptor
9 Fine filter (inner filter)
10 Pre filter (outer filter)
11 Release button, dust container
12 Battery display, Lithium version*
13 Dust container
14 Vacuum cleaner lid
15 Brush
16 Crevice nozzle
17 Brush roll release button*
18 Hatch cover for brush roll*
19 Brush roll
20 BRUSHROLLCLEAN™ TECHNOLOGY button*
21 Nozzle front lights
22 Charging indicator, NiMH version*
23 Parking strip
* Certain models only
4
Unpacking and assembly
Unpacking and assembly
1. Check that all parts are in the box. Fit the handle
by carefully inserting it into the lower main body.
Make sure that the cable does not jam.
2. Secure the handle by tightening the locking screw
supplied. Use a screwdriver or a coin.
Charging station
1. Position the charging station well away from
heat sources, direct sunlight or wet places. Insert
the adaptor into the mains and connect it to the
charging station.
2. On the bottom of the charging station there is a
hollow space where unused cable can be wound.
3. The wall unit can also be mounted on a wall.
Separate it from the floor unit. Always ensure that
the wall can withstand the weight of Ergorapido.
Charging
5
Charging
1.Ergorapido: The indicator light will come on
once the Ergorapido is positioned correctly in the
charging station. When fully charged, the LED will
be on for a few seconds per minute.
2. Ergorapido Plus: The battery capacity display
lights will come on one after another as the
machine is charging after being positioned
correctly in the charging station.
3. When fully discharged, approximately 16 hours’
charging is required to regain full battery capacity
(4 hours for Ergorapido Plus). Leave Ergorapido
on charge when not used to maintain battery
performance.
2. If a red light is lit: Unit is too hot. Clean filters,
brush roll, hose and put on charge.
3. If a red light is blinking: Motor is overloaded.
Clean brush roll.
4. When fully charged the LED’s* will turn off
and go into standby mode = much lower power
consumption, indicated with one blink per minute.
5. The red and blue light are blinking: please refer
to page 9.
Battery capacity display*
1. 3 blue lights: battery capacity >75%
2 blue lights: battery capacity 75-25%
1 blue light: battery capacity <25%
1 blue blinking light: battery capacity – empty
*Ergorapido Plus
6
Vacuuming
Vacuuming floors and carpets
1. You should regularly check that the nozzle
wheels and the brush roll are clean in order to
avoid scratching sensitive floors.
2. Start Ergorapido by pushing the on/off button.
3. Adjust the power level by pushing the lower part of
the on/off button:
2. Attach the crevice nozzle to facilitate cleaning
of areas difficult to reach, or attach the brush for
dusting.
3. Start/stop the hand unit by pushing the start
button.
Vacuuming furniture, car seats etc.
1. Remove the hand unit by pressing the release
buttons. The crevice nozzle and small brush are
stored in the charging station.
Emptying and cleaning
7
Emptying and cleaning
Ergorapido’s dust container must be emptied
regularly and the dust container and the filters need
to be cleaned to maintain a high suction power.
Never wash dust containers or filters in a dishwasher.
3. Quick cleaning of the fine filter. (Recommended
every cleaning). Release the dust container, pull/
release spring 5-6 times to dislodge dust.
1. Quick emptying of the dust container. Open the
vacuum cleaner lid. Clean the dust container by
placing the hose of another vacuum cleaner at the
opening.
2. Emptying of the dust container. Remove the
filters, empty the contents into a dustbin. Return
filters and click dust container back into place.
4a.Cleaning of dust container and filters.
(Recommended every 5th cleaning). Release dust
container, take out both filters by pressing release
buttons.
4b.Separate both filters. Dust container and filters
can be shaken clean or rinsed in warm water
(never in dishwasher). All parts must be dry before
reassembled in reverse order.
8
Cleaning
Cleaning the brush roll with the BRUSHROLLCLEAN™ TECHNOLOGY function*
The brush roll, the hose and the wheels may need to
be cleaned if they become blocked or jammed for any
reason.
Some Ergorapido models are equipped with
BRUSHROLLCLEAN™ TECHNOLOGY – a brush
cleaning function that helps to keep a clean brush
easily.
Please note that the BRUSHROLLCLEAN™
TECHNOLOGY function might not be able to remove
thick threads, wires or thick carpet fibres caught in the
brush roll.
It is recommended to use this function once a week.
For best results use the BRUSHROLLCLEAN™
TECHNOLOGY function when the Ergorapido is fully
charged.
The BRUSHROLLCLEAN™ TECHNOLOGY function
is equipped with an overheating protection. It will
deactivate the brush roll if the BRUSHROLLCLEAN™
TECHNOLOGY function has been activated for more
than 30 sec (constant or interrupted) within one
discharging period.
1. Make sure the cleaner is switched on and
stands on hard even surface. Do not use the
BRUSHROLLCLEAN™ TECHNOLOGY function on
deep carpets or long haired rugs.
2. Press the BRUSHROLLCLEAN™ TECHNOLOGY
button with your foot while the cleaner is switched
on. Hold for ca. 5 seconds or until all dirt and hair
is removed. Release the button.
There will be a cutting noise during this process,
this is normal
1. Ergorapido plus:
If - while holding the BRUSHROLLCLEAN™
TECHNOLOGY button pressed down – the brush
stops rotating, the nozzle front lights switch off
and the battery indicator light blinks red and blue,
release the BRUSHROLLCLEAN™ TECHNOLOGY
button.
2.Ergorapido:
If - while holding the BRUSHROLLCLEAN™
TECHNOLOGY button pressed down – the brush
stops rotating and the nozzle front lights switch off,
release the BRUSHROLLCLEAN™ TECHNOLOGY
button.
When the button is released, the brush is rotating and the nozzle front lights are on again. You can continue to use the Ergorapido for vacuuming as usual. The
BRUSHROLLCLEAN™ TECHNOLOGY function will remain disabled. To reset, the Ergorapido must be charged continuously for at least 10 minutes in the charging stand.
* Certain models only
Cleaning
Cleaning the brush roll
To remove thicker threads or wires as well
as on models that are not equipped with the
BRUSHROLLCLEAN™ TECHNOLOGY, the brush
should be cleaned according to the following
instructions.
1. First turn Ergorapido off. Push the brush roll
release button. The hatch cover will come slightly
free and the brush roll can be removed.
2. Lift out the brush roll and clean it. Use a sharp
object to remove threads. Reassemble the roll,
making sure it can spin freely. Close hatch cover.
2. If the wheels needs to be cleaned, remove them
carefully by using a small screwdriver.
3. Remove objects that may have become
jammed in the wheel shafts. Reassemble the
wheels by pressing them back into their tracks.
Cleaning the hose and wheels
1. Loosen the catch and pull the hose from the
attachment. Remove any debris. Put the hose
back, lock using the catch.
9
10
Removing the batteries
Removing batteries
Improper handling of the batteries may be
hazardous. Return the complete handheld unit to a
recycling station. Batteries must be removed from
the appliance before it is scrapped or recycled.
Never dispose used batteries with household waste.
1. Batteries should always be run flat before
removed. Ergorapido must be disconnected
from the charging station when removing the
batteries. Undo the screws. Carefully lift the hood.
2. Cut the connecting cables, remove the batteries,
put tape over the visible metal areas. Place
batteries in suitable packaging.
Safety precautions / Consumer information
Ergorapido should only be used by adults and only for
normal vacuuming in a domestic environment. Make
sure the vacuum cleaner is stored in a dry place.
All servicing and repairs must be carried out by an
authorized AEG service centre.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Please remove the plug from the socket outlet before
cleaning or maintaining the appliance.
Children should be supervised to ensure that they do
not play with the appliance.
Packaging material, e.g. plastic bags should not be
accessible to children to avoid suffocation.
Each vacuum cleaner is designed for a specific
voltage. Check that your supply voltage is the same
as that stated on the rating plate on the charging
adaptor. Use only the original charging adaptor
designed for this model.
Never use the vacuum cleaner:
• In wet areas.
• Close to flammable gases, etc.
• When housing shows visible signs of damage.
• On sharp objects or fluids.
• On hot or cold cinders, lighted cigarette butts, etc.
• On fine dust, for instance from plaster, concrete,
flour, hot or cold ashes.
• Do not leave the vacuum cleaner in direct sunlight.
• Avoid exposing the vacuum cleaner or battery to
strong heat.
• The battery must not be dismantled, shortcircuited, placed against a metal surface or
exposed to strong heat.
• Never use the vacuum cleaner without its filters.
• Do not try to touch the brush roll while the
cleaner is switched on and the brush roll is
turning.
Using the vacuum cleaner in the above circumstances
may cause serious damage to the product. Such
damage is not covered by the warranty.
11
Servicing or repairs
In cases of breakdown or faults, your Ergorapido
must be taken to an authorized AEG service centre.
If the supply cord or charger is damaged, it must be
replaced by AEG or its service agent or an equally
qualified person in order to avoid a hazard.
Consumer information
AEG declines all responsibility for all damages arising
from any improper use of the appliance or in cases of
tampering with the appliance.
This product is designed with the environment
in mind. All plastic parts are marked for recycling
purposes.
For details see our web site: www.aeg.co.uk If you
have any comments on the cleaner or the Instructions
for Use booklet please e-mail us at: floorcare@aeg.
co.uk
Please visit our website at www.aeg.co.uk, or for
Customer Care please call 08445 614614. Calls to this
number will be charged at 5p per minute at all times
from a BT Landline.
on the product or on its packaging
The symbol
indicates that this product may not be treated as
household waste. Instead it should be handed over
to the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product. For
more detailed information about recycling of this
product, please contact your local city office, your
household waste disposal service or the shop where
you purchased the product.
Share more of our thinking at www.electrolux.com
AG92x-4xEN-2-rev-4
Download PDF

advertising