Yamaha CD-NT670 / CD-NT670D firmware update installation manual

Yamaha CD-NT670 / CD-NT670D firmware update installation manual
Updating the firmware
When a new firmware for the unit is released, a message to update your current firmware will be shown on the front panel display (when the unit is connected to the Internet only).
In this page, an updating method via a network using the option setting is shown.
1
Press
• Do not operate the unit or disconnect the power
cable and network cables while updating.
.
• The option menu is shown on the front panel
display.
2
3
4
• When Internet speed is not fast enough or the unit
is connected to the wireless network via a wireless
network adapter, network update may not be
possible depending on the condition of the
wireless connection. In this case, try again or update
the firmware using a USB memory device. The
firmware can be downloaded from the Yamaha
Website.
Select [Firmware Update] with S/T,
and press
.
Select [Update] with S/T and press
.
Select [Network] with S/T, and press
.
• Press ENTER again, then update starts.
1
OPTION
To update the firmware using a USB memory
device
You can download the firmware to the USB memory
device, and connect that USB memory device to the
USB jack on the unit.
• Select [USB] in step 4 to start the update.
• When update finishes, messages are shown in the
following order: “UPDATE SUCCESS”, “PLEASE ...”,
and “POWER OFF!”
5
Press A on the front panel.
2, 3, 4
S/T
ENTER
• Update is applied.
En
45
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement