Fisher Paykel | WOSV230N | Quick Start Guide | Fisher Paykel WOSV230N Quick Start Guide

QUICK START GUIDE
SETTING THE CLOCK
Wall oven
You set the clock within the user preference menu. To learn more about the user preference menu, refer to your User Guide.
Note: When you first switch your oven on at the wall you will initially be prompted to set the time. If you do not wish to set the time
at this stage, press CANCEL to exit the clock setting. If you want to set the clock later, follow the steps under ‘To change the time’.
US CA
Keep this document handy for easy reference.
●
●
●
When the oven is first switched on at the wall
1 3:1 5
For detailed information on the features of your oven, see your ‘User guide’.
Before using your oven, make sure you read the full ‘User guide’, with special attention to the ‘Safety and warnings’ section.
For contact information or if you require service, assistance or replacement parts, see the end of this document or your
‘Service & warranty’ booklet.
SET TIME
24h
SET TIME
0 0 : 00
13:45
SET TIME
YOUR MODEL
1
2
3
4
5
6
7
WODV30
1
Control panel
Oven vent louvres
Oven light
Telescopic sliding shelf (x3)
Side rack
Oven door and handle
Oven seal
8
2
3 The display will flash either 0:00
(if 12H set) or 00:00 (if 24H set).
Press PLUS or MINUS to adjust the time.
9
Accessories:
Meat probe
Broil rack
Grid
Broil pan
1 3:1 5
13:45
4
SET TIME
Upper oven/
Left Hand display
Lower oven/
Right Hand display
Lower oven
function knob
Lower oven
Temperature
shuttle knob
TIMER: 2H 15M
BAKE
350f
CONDITION THE OVEN
It is important to condition both ovens before using it for cooking and baking. Conditioning will burn off any manufacturing residues
and ensure that you get the best results right from the start.
You can condition both ovens at the same time. Use the appropriate oven knobs.
1 Make sure you have removed any packaging and any cable ties used to secure the shelving during transit.
2 Make sure you have set the clock.
3 Make sure all the shelves are fitted.
BAKE
350f
PROBE: 100 SET: 175
OFF
Timer
If a timer is set:
Displays the remaining
time counting down as
the oven heats up
●
Function halo
Upper oven display
Shows the selected oven
function for the upper oven
Shows the current
temperature and the set
temperature of the upper
oven as it heats up
●
●
Lower oven display
Shows the selected oven
function for the lower oven
Shows the current temperature
and the set temperature of the
lower oven as it heats up
TIMER: 2H 15M
BAKE
350f
BAKE
350f
PROBE: 100 SET: 175
●
●
Accept/Lock button
Locking the control panel
To lock, press and hold
ACCEPT for 1 sec. LOCKED
will display in the Oven
function display.
To unlock, press and hold
ACCEPT for 5 secs. LOCKED
will disappear from the
Oven function display.
Menu
button
Setting
selection
buttons
Cancel
button
-
Temperature halo
Clock
If set:
Shows the current time of day
4 Rotate the upper oven function knob clockwise
to select BAKE function.
●
The halo will glow orange.
●
Each function has a preset temperature.
The oven will start heating at the BAKE
preset temperature of 350 F.
●
●
●
Meat probe (shows in either display)
(see ‘Using the meat probe’ in
User guide)
Using the temperature shuttle knob:
Rotate the temperature knob to the right to increase the temperature.
●
Release the knob and it automatically returns to the OFF position.
Rotate the temperature knob to the left to decrease the temperature.
●
Release the knob and it automatically returns to the OFF position.
Holding the knob to the right or the left will speed up the increments
that the temperature increases or decreases by.
IMPORTANT!
The knob only rotates a certain amount in either direction.
Do not force the knob to rotate further.
If a meat probe is in use (either oven):
Shows the current temperature and
the set temperature of the probe.
Actual
Temp
Set
Temp
BAKE
115 400f
Timer
button
+
14 : 1 5
BAKE
350f
Temperature halo
4 Press ACCEPT to confirm.
The time is now set and will
show in the display.
2 Press PLUS to select SET TIME.
The current set time will flash.
3 Press PLUS or MINUS to adjust
the time.
To change the clock settings
In the user preference menu you can also change between 12H and 24H.
Refer to your User guide to learn more about this feature.
THE CONTROL PANEL
●
14:45
!1
7
6
Function halo
SET TIME
!0
Upper oven shown
Upper oven
Temperature
shuttle knob
1 3 : 45
5
1 Press and hold MENU for a
few seconds to enter the user
preference menu.
Upper oven
function knob
4 Press ACCEPT to confirm.
The time is now set and will
show in the display.
To change the time (within the user preference menu)
3
8
9
!0
!1
1 The display will flash 24h
2 Press PLUS or MINUS to scroll
between 24H and 12H.
Press ACCEPT to confirm.
14 : 1 5
BAKE
400f
Automatic cooking
(see ‘Automatic cooking’ in User guide)
If Automatic cooking is set:
Shows the time until the cooking
starts and the time until the
cooking ends.
5 Rotate the upper oven temperature shuttle knob clockwise to increase the temperature to 400oF for 30 minutes.
The halo will glow white, while the oven is heating up.
●
The oven display will show the actual and set temperatures.
●
When the oven has reached set temperature, the display reverts to that temperature, a tone will sound and the halo will turn orange.
●
continued >
CONDITION THE OVEN
USING THE TIMER
(CONTINUED)
●
●
CONV BROIL
350f
CONV BROIL
355 400f
●
●
6 After 30 minutes is up, select the
CONV BROIL function.
●
The oven heats at the CONV BROIL
preset temperature of 350f.
7 Set the temperature to 400oF for
5 minutes.
●
The halos will remain orange.
●
The temperature display may show
the actual and set temperatures.
You can use the timer at any time, even if you are not using the oven.
The timer is set independently of the two ovens. Only one timer can be set at a time.
If the time is more than an hour, the display will count down in minutes ( h : m ). If it is less than an hour, it will count down in seconds
( m : s ).
You can set the timer for up to 23 hours 59 minutes.
IMPORTANT!
8 After 5 minutes is up, turn
the upper oven function knob
counter clockwise back to OFF.
●
both halos will go out.
The timer does NOT turn the oven off.
To set the timer
13 : 1 5
TIMER
●
●
There will be a distinctive smell and a small amount of smoke during the conditioning of the oven.
This is normal, but make sure the kitchen is well ventilated during the conditioning.
Once cooled, wipe out the oven with a damp cloth and mild detergent, and dry thoroughly.
Placing the telescopic sliding shelves on the side racks provides EIGHT cooking
positions to choose from. Refer to the User guide for suggested shelf positions.
8
7
6
5
4
3
2
1
Note: generally, the shelf positions in the top of the oven are suitable for broiling.
Those in the middle or lower region of the oven are suitable for baking, roasting and casseroles.
●
●
●
●
●
●
●
●
●
Always position oven shelves BEFORE heating the oven.
To remove a sliding shelf, grip it by its two front corners (making sure you are gripping the wire shelf
and the sliding frame together), tilt upwards and pull it out of the oven.
To place a sliding shelf in the oven correctly, position it so that the front bar is toward you, as shown.
Check that the sliding frame is not extended.
Check the guard rail (as shown) to make sure the shelf is the right way up.
Position the shelf so that it is level and the rear shelf tags on both sides of the sliding frame rest on the
side racks (as shown).
Then push the sliding shelf all the way to the back of the oven, until the front shelf tags drop into place.
For your safety, the wire shelves and telescopic sliding frames are built together as one unit and are not
separable. This means that when placed properly on the side racks, the slides will prevent the wire shelves
from tilting when pulled towards you.
To prevent the tags from lifting off the side racks, take care to slide the shelves forward horizontally.
TIMER
0h 00m
6 Press TIMER. 0h 00m will flash in the
display to indicate the timer is ready
to be set.
REPOSITIONING THE SHELVES (EITHER OVEN)
13 : 1 5
13 : 1 5
0h 30m
6 Press PLUS or MINUS to adjust the
length of the timer.
●
Holding the buttons down will speed
up the time adjustments.
TIMER
2h 45m
6 Press ACCEPT to confirm. The timer is
now set and will begin counting down.
●
The display will revert automatically
to the home screen, with the Timer
setting in the top left screen.
To modify the timer setting
Adjusting the timer setting is the same process as setting a new timer.
1 Press TIMER. The previous timer setting will flash in the display.
2 Press PLUS or MINUS to modify the length of the timer.
2 Press ACCEPT to confirm. The timer is now set and will begin counting down.
Shelf positions
To cancel the timer setting
1 Press TIMER.
2 Press and hold CANCEL to clear the timer setting.
When the set time is up
1 The timer will show 00m. A tone will sound.
2 Press ACCEPT or CANCEL to stop the tone sounding.
Guard rail
Mounting
slots
Side rack
Side rack
FOR MORE INFORMATION
Lock
stud
●
●
●
●
Wire shelf
Shelf tag
Sliding frame
(push fully into place)
For detailed information on the
features of your oven
see your ‘User guide’
For warranty information
see your ‘Service and warranty’ booklet
If you…
have any questions or comments
need a Fisher & Paykel authorized
technician to service your product
need replacement parts or accessories
want to register your product
see your ‘Service and warranty’ booklet or contact us
USA
CA
toll-free, 24/7
toll-free, 24/7
1 888 936 7872
1 888 936 7872
www.fisherpaykel.com
Retaining wire
Front bar
591010B
01.18
Download PDF

advertising