GE Profile | PT7800SHSS | Spec sheet | GE Profile PT7800SHSS Spec Sheet

PT7800SH
GE Profile™ Series 30" Built-In Combination Convection Microwave/Convection Wall Oven
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
9-1/2" MAX.
RIGHT SIDE ONLY
CUTOUT DEPTH
23-1/2" MIN.
NOTE: Cabinets installed adjacent to wall
ovens must have an adhesion spec of at
least a 194°F temperature rating.
Junction box
location
(Junction box
may be located
in adjacent
cabinet)
F
INSTALLATION INFORMATION: Before
installing, consult installation instructions
packed with product for current
dimensional data.
CUTOUT WIDTH
28-1/2" MIN.
Door handle protrudes 3" from door face.
Cabinets and drawers on adjacent 45°
and 90° walls should be placed to avoid
interference with the handle.
CONDUIT
48"
E
28" MIN. to
bottom of
junction box
28-5/8" MAX.
A
B
CUTOUT HEIGHT
42-3/16" MIN.
42-1/4" MAX.
C
Electric wall ovens are not approved for
installation with a plug and receptacle.
They must be hard wired in accordance
with installation instructions.
Note: These ovens are not
approved for stackable or
side-by-side installations.
KW RATING
Recommended
minimum
cutout location
from the floor
21-5/8"
21"
D
20" MIN.
door opening
allowance
240V 6.8
CL
208V 5.1
BREAKER SIZE
240V 30 Amps
2 x 4 or
equivalent runners
level with bottom of cutout
and flush with sides of cutout
or solid bottom floor.
208V 30 Amps
Suitable
bracing
to support
runners
Dimension and
installation information
are shown in inches.
ATTENTION INSTALLER: All electric wall ovens must be hard-wired (direct-wired)
PK7800
into an approved junction box. A plug and receptacle is NOT permitted on these products.
NOTE: If the cabinet does not have a solid bottom,
two braces or runners must be installed to support
the weight of the oven. For single ovens, the runners
and braces must support 200 lbs (91 kg). For double
ovens, the runners and braces must support 375 lbs.
(170 kg).
NOTE: If marks, blemishes or the cutout opening are
visible above the installed oven, it may be necessary
to add wood shims under the runners and front trim
until the marks or opening are covered.
(must support 275 lbs.)
30 ''
NOTE: If the cabinet does not have a front frame
and the sides are less than 3/4" (1.9 cm) thick, shim
both sides equally to establish the cutout width.
JK3800
PT7800
CABINET
30"
A –Overlap of oven at top of cutout
1"
B –Overlap of oven over side of edges of cutout 3/4"
C –Overlap of oven at bottom of cutout
1"
OVEN
D –Install depth
23-1/2"
E –Overall height with trim
42-3/8"
F –Overall width
29-3/4"
Listed by
Underwriters
Laboratories
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Specification Revised 4/16
PT7800SH
GE Profile™ Series 30" Built-In Combination Convection Microwave/Convection Wall Oven
FEATURES AND BENEFITS
1.7 cu. ft. microwave capacity (1000 watts (IEC-705 test procedure)
Convection microwave (upper oven) - Circulates heat for high-quality results
1 6" turntable (upper oven) - Rotates food throughout the cooking cycle for even
cooking results
rue European Convection (lower oven) - Achieve delicious results from a third heating element and
T
fan combination
Self-clean with steam clean option (lower oven) - Clean your oven the way you want
elf-clean heavy-duty oven racks (lower oven) - Conveniently clean your oven and
S
racks together
Glass touch controls - Set temperatures quickly and clean with little effort
Halogen interior oven lighting (lower oven) - Easily see how your food is baking
en-pass bake element (lower oven) - Even baking is assured with heat that covers
T
more surface area
ight-pass broil element (lower oven) - Get full broil coverage and even browning
E
from edge to edge
• Model PT7800SHSS – Stainless steel
GUARANTEED FIT
Replacing a similar wall oven from GE or another brand? GE wall ovens are
guaranteed for an exact fit to make replacement easy
Visit geappliances.com for more info
PT7800SHSS
Specification Revised 4/16
Download PDF

advertising