Summit | SP6DS2D7 | Panel Instructions | Summit SMSP6DS2D7ADA Panel Instructions

Directions for Applying Overlay Panel
Handle
Gasket
Materials Supplied:
1 - Drill Bit 3/16"
4 - Screws M4 x 25 Flat Hd Phillips (For Handle)
8 - Screws #10 x 2.25" Phillips
Step 1
1) Remove both drawers from unit by opening drawers
and pushing in black tabs on either side of the slides.
You must hold in tabs to disengage slide.
2) Peel back gasket (Fig A) and remove 2 screws to
remove handle.
3) Throw out the 2 screws that attach the handle.
Step 2
2 3/4
11/16
2 3/4
1) Drill the bottom 2 holes shown in the drawing
using the supplied drill bit on the drawer front.
2) Cut overlay panels as follows:
Top (outdoor unit):
23-7/16 x 16-5/16
Top (indoor unit):
23-7/16 x 15-11/16
Bottom (outdoor unit): 23-7/16 x 13-3/16
Bottom (indoor unit): 23-7-16 x 12-9/16
1 of 2
Q119
01/04/17
1 1/4
19 3/8
Step 3
1) If reusing the handle that came with the unit, drill two
holes 19 3/8" apart and a minimum of 1 1/4" from the
top.
2) Screw handle on using the supplied screws. Drive screws
flush with panel. Screws are designed for 3/4" overlay panel.
If thickness other than this is used, customer will supply.
M4 x 25
Flat Head
2 Places
Overlay
Panel
#10 x 1.75"
2 Top
Step 4
1) Peel back the gasket and attach the overlay panel
to the drawer face using the 4 supplied screws and
thru the 4 existing clearance holes.
2) Install both drawers back into unit.
#10 x 1.75"
2 Bottom
2 of 2
Q119
01/04/17
Download PDF

advertising