Whirlpool | WRS588FIHZ | Dimension Guide | Whirlpool WRS588FIHZ Dimension Guide

Whirlpool WRS588FIHZ Dimension Guide
Bottom Mount Refrigerator
PRODUCT MODEL NUMBERS
WRS588FIH
PRODUCT MODEL NUMBERS
KRSC500E
KRSF505E
PRODUCT DIMENSIONS
Side by Side Refrigerator
PRODUCT DIMENSIONS
KRSC503E
Electrical: A 115-volt, 60-Hz, AC-only, 15- or
20-ampElectrical:
fused, grounded
electrical
supply
is 15- or
A 115 volt,
60 Hz,
AC only,
required.
It is recommended
thatelectrical
a separate
20-amp
fused, grounded
supply is
circuit required.
serving only
your r efrigerator
It is recommended
thatbea separate
provided.
Useserving
an outlet
thatyour
cannot
be turned
circuit
only
refrigerator
be prooff by avided.
swit ch.
usethat
ancannot
extensibeonturned off
UseDo
an not
outlet
cord.
by a switch. Do not use an extension cord.
NOTE: Before performing any type of
Water: A cold water supply with water
installation, cleaning, or removing a light
pressure
of between
30 and 120 psi (207
bulb, turn
the control
(Thermostat,
and 827
is required
operate the
Refrigerator
or kPa)
Freezer
Control to
depending
on
water
dispenser
and
ice
maker.
If you
the model) to OFF and then disconnect
thehave
questions
about
your water
pressure,
refrigerator
from the
electrical
source.
When call a
plumber.
you arelicensed,
finished,qualified
reconnect
the refrigerator to
the electrical
source
and reset
theSupply:
control
Reverse
Osmosis
Water
(Thermostat,
Refrigerator
FreezerofControl
IMPORTANT:
The or
pressure
the water
depending
oncoming
the model)
desired
supply
out oftoathe
reverse
osmosis
setting.system
See “ Using
Controls.”
going the
to the
water inlet valve of the
Water:refrigerator
A cold water
supply
water 30 and 120
needs
to bewith
between
pressure
andkPa).
120 psi (207 and
psibetween
(207 and30827
827 kPa) is r equired to operate ice maker
If a reverse osmosis water filtration system is
and water dispenser. If you have questions
connected to your cold water supply, the
about your w ater pressure, call a licensed,
water
pressure to the reverse osmosis
qualified
plumber.
system needs to be a minimum
IMPORTANT:
Thepsipressure
of the
water
of 40 to 60
(276 to 414
kPa).
coming out of a reverse osmosis system
going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kP a).
Reverse Osmosis Water Supply: If a
reverse osmosis water filtration system is
connected to y our cold water supply, the
water pressure to the reverse osmosis
system needs to be a minimum of 40 to
60 psi (276 to 414 kPa).
LOCATION REQUIREMENTS
LOCATION REQUIREMENTS
/ " (1.27 cm)
12
12
/ " (1.27 cm)
2" (5.08 cm)
2" (5.08 cm)
A
not incl.
handle
C
top of
cabinet
D
B
overall
incl.
handle
E
F
90˚
90˚
Handle and door style will vary
with model.
Dimensions “C” and “D” include
rollers extended ³⁄₄" (1.9 cm).
Model
Model Size
Model
Number
Model22.5
Size
KRSC500E
WRS588FIH
28.5 cu. ft.
KRSC503E
22.7
KRSF505E
25.6
Depth
without
Depth with
Handle
Handle
Depth
Without
Depth “A”
“B”
With Handles
Cabinet
Height
“C”
Overall
Height
“D”
Cabinet
Width
“E”
Handles
“A”
27¹⁄₂"
(69.9 cm)
32¾"
(83.2
27¹⁄₂"cm)
29³⁄₄" “B”
(75.6 cm)
(69.9 cm)
cm)
(88.6 cm)
30"
71" (174.9 cm)71¹⁄₄" (175.3 35³⁄₄"
(76.2 cm)
(180.3 cm)
(181 cm)
(90.8 cm)
32¹⁄₈"
(81.6 cm)
34"
(86.4 cm)
34⁷⁄₈"
Cabinet Height
Overall Height
“D”35¹⁄₂"
68⁷⁄₈"
69"
69"
68⁷⁄₈" “C”
(175.3 cm)
(174.9 cm)
68³⁄₈"
(173.7 cm)
69"
(175.3 cm)
(90.2 cm)
35³⁄₄"
(90.8 cm)
Depth “F”
with Doors
Open 90°
Cabinet Width
“E”
45⁷⁄₈"
(116.5 cm)
36"
(91.445⁷⁄₈"
cm)
Depth “F” with
Doors Open 90°
511⁄₈"
(129.9 cm)
(116.5 cm)
50¹⁄₂"
(128.3 cm)
To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.27 cm) of space on each side
and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If your refrigerator has
an ice maker, allow extra space at the back for the water line connections. When installing your
is designed
indoor
only. on
refrigerator next IMPORTANT:
to a fixed wall, This
leaverefrigerator
a 2" (5.08 cm)
minimumforspace
onhousehold
each side use
(depending
1
To ensure
proper
ventilation
your model) to allow
the doors
to swing
open. for your refrigerator, allow for a ⁄2" (1.27 cm) space on
each side and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If
NOTES:
your isrefrigerator
has
maker, make
you leave some
extra
This refrigerator
intended for
useaninice
a location
wheresure
the temperature
ranges
fromspace
a at the
the to
water
line connections.
minimum of back
55°F for
(13°C)
a maximum
of 110°F (43°C). The preferred room temperature
performance,
whichrefrigerator
reduces electricity
and provides
range for optimum
If you are
installing your
next to ausage
fixed wall,
leave 2"superior
(5.08 cm)
cooling, is between
60°F
andside
90°F(depending
(32°C). It isonrecommended
thatallow
you for
do not
minimum
on (15°C)
the hinge
your model) to
the install
door tothe
refrigerator near a heat source, such as an oven or radiator.
swing open.
Normal minimum cabinet cut-out width required for product installation is 36" (91.44 cm).
NOTES:
This
refrigerator
is intended
for use
a location
where
the temperature
wallinand
the ability
to remove
the crisper ranges from
However, if the
product
is placed
against
an extended
a minimum
of 55°F
a maximum
110°F
room temperature
pans is desired,
an additional
18"(13°C)
(45.72tocm)
of cabinetofwidth
is (43°C).
required,The
so apreferred
total cabinet
range
for(137.16
optimum
performance,
which reduces electricity usage and provides superior cooling,
opening width
of 54"
cm)
is recommended.
is between 60°F (15°C) and 90°F (32°C). It is recommended that you do not install the
refrigerator near a heat source, such as an oven or radiator.
■ Normal minimum cabinet cut-out width required for product installation is 36" (91.44 cm).
However, if the product is placed against an extended wall and the ability to remove the crisper
pans is desired, an additional 18" (45.72 cm) of cabinet width is required, so a total cabinet
opening width of 54" (137.16 cm) is recommended.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10768947A
1/17
Ref. W10768783B
5/15
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising