Cafe | CSB42WSKSS | Dispatcher Quick Specs | Cafe CSB42WSKSS Dispatcher Quick Specs

CSB42WSK
GE Café™ Series 42" Built-In Side-By-Side Refrigerator
DIMENSIONS AND INSTALLATION INFORMATION
PRODUCT CLEARANCES
STAINLESS STEEL WRAPPED REFRIGERATORS
These refrigerators are equipped with a 2-position
door stop. The factory set 130° door swing can be
adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.
Stainless Steel wrapped refrigerators have wrapped
doors and grille panels, and beveled edges. These
models are shipped ready for installation.
25-3/8"
CASE DEPTH
A
130° DOOR SWING
B
90° DOOR SWING
41"
CASE WIDTH
23-7/8"
BEHIND
FRAME
C
D
*81-3/4"
AT REAR
D
MODELS
42"
A
B
C
D
12-3/16"
16"
24"
4"
*84" FROM
FLOOR TO
TOP FRAME
Allow minimum clearances for Freezer door
(Dimension A) and Fresh Food door (Dimension B)
for a full 130° door swing and to allow for drawer
removal.
Four inch (4") minimum clearance is required when
door swing is adjusted to 90°. If the 90° door stop
position is used, drawer access is maintained, but
drawer removal is restricted.
42" FRAME-TO-FRAME
DEPTH INCLUDING
HANDLES 27"
For answers to your Monogram, GE Profile Series
or GE® Series appliance questions, visit our website
at geappliances.com or call GE Answer Center®
service, 800.626.2000.
™
Total volume and shelf
area are calculated by
the Association of Home
Appliance Manufacturers’
standards.
*Shipping height
*The front height may be adjusted from
83-1/2" to 84-1/2" by adjusting front
and rear leveling legs a maximum of 1".
Listed by
Underwriters
Laboratories
Specification Revised 10/15
CSB42WSK
THE INSTALLATION SPACE
GE Café™ Series 42" Built-In Side-By-Side Refrigerator
3"
*Finished Width
DIMENSIONS AND INSTALLATION INFORMATION
GROUNDING THE REFRIGERATOR
SIDE PANELS
IMPORTANT—PLEASE READ CAREFULLY
Side panels (not supplied)
must be used whenever
the sides of the refrigerator
will be exposed. The 1/4"
*84"
side panels will slip into
the side case trim. Order
side panels from your
cabinet manufacturer.
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED.
The power supply cord of this appliance is
equipped with a three-prong (grounding) plug
which mates with a standard three-prong
(grounding) wall receptacle to minimize the
possibility of electric shock hazard from this
appliance.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN ADAPTER PLUG
TO CONNECT THE REFRIGERATOR
TO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD
WITH THIS APPLIANCE.
24"
Electrical
Area
84 1/2" max
83 1/2" min
Finished
Opening
7"
74"
From Floor
to Bottom
of Electrical
24"
5"
Water
Supply
5"
3 1/2"
3 1/2"
*Depending on installation height.
*The finished
cutout width must
be: 41-1/2" for
42" models
THE CUTOUT DEPTH MUST BE 24"
*3" TO 4"
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
Where a standard 2-prong wall outlet is
encountered, it is your personal responsibility
and obligation to have it replaced with a properly
grounded 3-prong wall outlet.
7"
1-1/2"
The refrigerator will project forward, slightly beyond
adjacent cabinets, depending on your installation.
ADDITIONAL SPECIFICATIONS
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that
is at the same height as the rest of the flooring.
This surface should be strong enough to support
a fully loaded refrigerator, or approximately 1500 lbs.
NOTE: Protect the finish of the flooring. Cut a
large section of the cardboard carton and place
under the refrigerator where you are working.
WATER AND ELECTRICAL LOCATIONS
The opening must be prepared with the
electrical and water supply located as shown.
For answers to your Monogram, GE Profile Series
or GE® Series appliance questions, visit our website
at geappliances.com or call GE Answer Center®
service, 800.626.2000.
™
A 120 volt, 60Hz, 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be located
on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not recommended.
Water line can enter the opening through the floor or
rear wall. The water line installed should be 1/4" O.D.
copper tubing or GE SmartConnect™ tubing between
the cold water line and water connection location. The
line should be long enough to extend to the front of the
refrigerator. Installation of an easily accessible shutoff
valve in the water line is required.
Total volume and shelf
area are calculated by
the Association of Home
Appliance Manufacturers’
standards.
Listed by
Underwriters
Laboratories
Specification Revised 10/15
CSB42WSK
GE Café™ Series 42" Built-In Side-By-Side Refrigerator
FEATURES AND BENEFITS
42" built-in configuration
LED Lighting – Illuminates the fresh food compartment, vegetable drawer
and climate-controlled drawers to spotlight food without compromising space
TM
Advanced temperature management system – A multi-shelf air tower keeps
foods fresh by evenly distributing air through the refrigerator
Upfront temperature controls with actual temperature display – Features
easy-to-reach, easy-to-read temperature controls and displays the actual
temperature setting
Advanced water filtration uses MWF replacement filter – Removes trace
pharmaceuticals from water and ice* and uses replacement filter MWF
(*Removes ibuprofen, atenolol, fluoxetine, progesterone and trimethoprim.
These pharmaceuticals are not necessarily in all users’ water)
Humidity-controlled drawers – Help preserve fruits, cheeses and vegetables
Adjustable spillproof glass shelves – Raised edges help contain spills to make
clean up quick and easy
Large door bins – Offer ideal space for storing large containers in the door,
freeing up valuable shelf space
Model CSB42WSKSS – Stainless steel
CSB42WSK_CSB48WSK
Specification Revised 10/15
Download PDF

advertising