Whirlpool | WFE515S0EW | Dimension Guide | Whirlpool WFE515S0EW Dimension Guide

30" (76.2 cm) Freestanding Electric Range
PRODUCT DIMENSIONS
PRODUCT MODEL NUMBERS
WFC110M0A
WFC120M0A
WFC130M0A
WFC150MLA
WFC310S0A
WFC340S0A
WFE320M0A
WFC310S0E
WFE330W0A
WFE510S0A
WFE520C0A
WFE524CLA
WFE524CLB
WFE524WLA
WFE525C0B
WFC340S0E
WFE530C0A
WFE540H0A
WFE710H0A
WFE714HLA
WFE720H0A
WFI910H0A
WFC150M0E
WFE320M0E
A
Electrical: To properly install your range, you must determine the type
of electrical connection you will be using and follow the instructions
provided for it here.
• Range must be connected to the proper electrical voltage
and frequency as specified on the model/serial number rating plate.
The model/serial number rating plate is located on the left side frame
behind the storage drawer panel or behnd the top right side
of the oven door. Refer to the figures in the “Product Dimensions”
section of the “Location Requirements” section.
• This range is manufactured with the neutral terminal connected
to the cabinet. Use a 3-wire, UL listed. 40- or 50-amp power supply
cord (pigtail) (see following Range Rating chart). If local codes
do not permit ground through the neutral, use a 4-wire power supply
cord rated at 250 volts, 40 or 50 amps and investigated
for use with ranges.
Range Rating*
Specified Rating of
Power Supply Cord Kit
and Circuit Protection
120/240 Volts
120/208 Volts
Amps
8.8 – 16.5 KW
7.8 – 12.5 KW
40 or 50 **
16.6 – 22.5 KW
12.6 – 18.5 KW
50
*T
he NEC calculated load is less than the total connected load listed
on the model/serial rating plate.
** If connecting to a 50-amp circuit, use a 50-amp rated cord with a kit.
For 50-amp rated cord kits, use kits that specify use with a nominal
13/8" (34.9 mm) diameter connection opening.
• A circuit breaker is recommended.
CABINET OPENING DIMENSIONS
B
C
F
E
D
A. 273/4" (70.5 cm) max. depth with handle
B. 467/8" (119.1 cm) overall height (max.) with leveling legs
screwed all the way in*
C. 36" (91.4 cm) cooktop height (max.) with leveling legs
screwed all the way in*
D. 297/8" (75.9 cm) width
E. 255/16" (64.3 cm) depth – back of range to front of cooktop**
F. Model/serial rating plate (located on the left side frame behind
storage drawer or right side of frame behind the oven door)
IMPORTANT: Range must be level after installation. Follow
the instructions in the “Level Range” section. Using the cooktop
as a reference for leveling the range is not recommended.
* Range can be raised approximately 1" (2.5 cm)
by adjusting the leveling legs.
** Front of door and drawer may extend further forward
depending on styling.
Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and 36"
(91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood
combination above the range, following the range hood or microwave
hoods combination instructions for dimensional clearances
above the cooktop surface.
A freestanding range may be installed next to combustible walls
with zero clearance.
*NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet
is covered by not less than 1/4" (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
Because Whirlpool Corporation includes a continues commitment to improve
our products, we reserve the right to change materials and specifications
without notice.
A
C
B
D
E
F
A. 13" (33.0 cm) max.
upper cabinet depth
B. 30" (76.2 cm) min.
opening width
C. For minimum clearance
to top of cooktop,
see NOTE
D. 301/8" (76.5 cm) min
opening width
E. Outlet – 8" (20.3 cm)
to 22" (55.9 cm) from either
cabinet, 51/2"
(14.0 cm) max. to floor
F. Cabinet door or hinges
should not extend
into the cutout
Dimensions are for planning purposes only. For complete details,
see Installation Instructions packed with product. Specifications
subject to change without notice.
Ref. W10403811C
02/09/15
Download PDF

advertising