GE | GSM2200VBB | Quick Specs | GE GSM2200VBB Quick Specs

GE GSM2200VBB Quick Specs
Spacemaker Dishwasher Dimensions
(Pub. 1-G003 pg. 132B) May 12, 1993
GSM2200V
GE Spacemaker Under-the-Sink Dishwasher
®
DW PLUMBING/ELECTRICAL
ROUGH-IN (IN INCHES)
Dimensions and Installation Information (in inches)
Note: Undersink dishwashers can be installed only
under sinks and not under other appliances.
Plumbing—Hot Water Only: Use 3/8" O.D. copper
tubing or 1/2" O.D. plastic tubing minimum inlet
line. Water valve has 3/8" internal threads. Hand
cut-off valve is recommended.
FRONT VIEW
Plumbing and
wiring must enter
within this area
from either side,
4 rear or bottom
Electrical: Fuse circuit with 15 amp or 20 amp
standard fuse or circuit breaker. Total amp load is
8.6. Dishwasher operates on 120V, 60HZ power,
Two-wire cable (14 Ga. Min.) with ground must be
installed.
Specifications: Inlet water temperature
recommended—minimum 120°F at dishwasher.
Inlet water pressure required—15 to 120 lbs./sq.
inch.
Note: All rough-in, both plumbing and electrical,
must be completed before the dishwasher is
installed. All plumbing and electrical work must be
in accordance with local codes.
6
2" From
cabinet
Cold
Hot
19" From
Cable 24"
wall
from wall
2" From
floor
Ground
Black (line)
White (neutral)
3
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
Specification Revised 1/12
350518
10"
from
cabinet
GSM2200V
GE Spacemaker® Under-the-Sink Dishwasher
Note: A close-fitting elbow or special
shallow sink strainer is necessary to
provide clearance between sink drain
and dishwasher. Dishwasher furnished
with 1/2" I.D. drain hose, 78" long. If using
copper tubing, 2" length of 1/2" I.D. rubber
hose must be provided to connect copper
tubing to pump outlet. Disposer should
have 7/8" I.D. dishwasher drain connector.
Rough-In for Installation with Disposer Dimensions
(in inches)
Waste air gap
To
air
gap
Directional flow tee
FRONT VIEW
Drain
connection
4
1-1/2" MAX.
dia. hole
Waste tee
or disposer
Remove hopper plug
before connecting
dishwasher drain
12" From wall
6
10"
from
cabinet
6" Double-bowl
stainless steel sink
Sink
strainer
assembly
GFC290/300/700
Disposall®
unit
Countertop
25" deep
1-1/2" thick
1-1/2" Close
elbow
1-1/2"
Directional
flow tee
Spacemaker®
dishwasher
Cold water
Hot water
Valve to shut off
water to dishwasher
Dishwasher
water inlet
valve
Electrical
junction box
(on dishwasher)
Allow a 5"
radius to
prevent kinking
Sink
strainer
assembly
GFC290/300/700
Disposall®
unit
Cold water
Hot water
Valve to shut off
water to dishwasher
Rear View Plumbing Arrangement Dimensions
(in inches)
Hot water supply
to dishwasher Dishwasher
drain hose
6" Double-bowl
stainless steel sink
1-1/2"
Directional
flow tee
Allow a 5"
radius to
prevent kinking
Countertop
25" deep
1-1/2" thick
1-1/2" Close
elbow
Spacemaker®
dishwasher
Hot water supply
to dishwasher Dishwasher
drain hose
Dishwasher
water inlet
valve
Electrical
junction box
(on dishwasher)
Listed by
Underwriters
Laboratories
Specification Revised 1/12
350518
GSM2200V
GE Spacemaker® Under-the-Sink Dishwasher
Cabinet Rough-In Dimensions (in inches)
Cabinet Rough-In Note: Either single- or
double-bowl sink may be used, centered
or offset, as shown in the front view
illustration.
The 20-1/2" maximum dimension from wall
to front of sink bowl must be accurate if
dishwasher is to fit properly under sink.
Water lines to sink faucet and drain from
sink can be run through area “A.”
HOT WATER line to dishwasher is installed
in area “B.”
Garbage disposer, water lines to faucet,
trap, waste air gap and water cutoff valve
are installed in 12" wide cabinet shown
in area “C.” Sink opening for garbage
disposer must be dimensioned as shown in
front view, area “C” (7-1/2"). This will provide
clearance for the disposer and plumbing in
cabinet “C” when using double bowl sink.
Cabinet Cut-Out for Sink Dimensions (in inches)
Undersink Dishwasher Wood Insert Dimensions
(in inches)
If the sink bowl is more than 20-1/2"
maximum specified distance form the
wall, or if the base cabinet is less than the
24" minimum depth from the wall, a gap
between the tub front flange and the front
of the base cabinet may result.
Listed by
Underwriters
Laboratories
Specification Revised 1/12
350518
GSM2200V
GE Spacemaker® Under-the-Sink Dishwasher
Features and Benefits
• 4-level PowerScrub™ wash system - Powerful wash cleans dishes thoroughly
• Two-stage filtration with ExtraFine™ filter - Extra filtration keeps water clean
• Piranha™ hard food disposer - Grinds food into small particles that are washed away
• HotStart™ option - Provides optimal water temperature for dependable performance
• 64 dBA - motor runs quietly to keep kitchen peaceful
• Spacemaker® upper rack - Maximizes space without losing cabinets
• D
eluxe silverware basket - Provides convenient space and capacity to clean silverware
efficiently
• Model GSM2200VWW - White on white
• Model GSM2200VCC - Bisque on bisque
• Model GSM2200VBB - Black on black
GSM2200N
Specification Revised 1/12
350518
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising