AccuCold | ALF620IF | Use and Care | AccuCold ALF620IF Use and Care

Instructions for
Integrated Frame
(Built-In Application)
Top Hinge
or
DETAIL A
Step 7
Step 8
Top Brace
Frame
1) Remove Door from Chassis by removing
Top and Bottom Hinges. Keep screws,
discard hinges.
A
2) Attach customer supplied handle to Door Panel
using countersunk screws.
3) Screw Door Panel to Frame.
4) Slide Frame over Refrigerator door and attach
with 1 screw on each side, center of door.
5) Screw Bottom Pc to Door.
6) Attach Top Brace to Frame with 1 screw on side.
Attach Bottom Brace in the same manner.
Bottom
Pc
7) Drill a hole thru the Top and Bottom Frame using
the Braces as a guide with a 5/32" drill bit. Install
screws to finish attaching the Top and Bottom
Braces securely to the Frame.
B
8) Drill a hole into the Door Panel from the top and
bottom using the Braces as a guide with a 1/4"
drill bit. Do not exceed 5/8". This is the hole that
the door will pivot on.
9) Remount the door using the supplied Top and
Bottom Hinges.
Door Panel
DETAIL B
Bottom Brace
Summit Appliance
1-718-893-3900
Hinge
Download PDF

advertising