GE Monogram | ZDP366NPSS | DL 6b664155755ae5fd81cc787807a9 | GE Monogram ZDP366NPSS DL 6b664155755ae5fd81cc787807a9

GE Monogram ZDP366NPSS DL 6b664155755ae5fd81cc787807a9
MONOGRAM 36" DUAL-FUEL PROFESSIONAL
RANGE WITH 6 BURNERS
DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)
ZDP366NPSS (NATURAL GAS)
35 7/8" width
Professional ranges offer a number of choices in size and
cooktop configurations.
All Dual-Fuel Professional Ranges are factory set for
natural gas.
NOTE
A propane conversion kit is included with the range. High
Altitude kit, WB28K10553 for operation above 3,000 feet
(for Natural and LP gas models), is also available. The
kits must be installed by a qualified service technician at
additional cost.
35 1/4"
to
36 3/4"
height
INSTALLATION INFORMATION
3 1/4"
to 4 3/4"
28 1/4"
Before installing, consult installation instructions packed
with product or online at Monogram.com for current
dimensional data.
Toekick/leg
height
Depth
to front
of door
A 36" or 42" wide professional vent hood with a minimum
600 CFM is recommended for installation over this range.
ADVANCE PLANNING
Refer to dimensional drawings for appropriate placement
and necessary clearances when planning the installation.
•W
orking areas adjacent to the range should have
18" minimum clearance between countertop and
cabinet bottom.
•C
learance between range and side wall or combustible
material must be at least 12" on each side.
• Installation must conform with local codes. In the
absence of local codes, the range must comply with
the National Fuel Gas Code, ANSI Z223.1-1990.
WARNING
Installations without a hood require 48" minimum
to combustibles. A custom hood installation with
exposed horizontal combustible surfaces must
have an Auto-On feature. Refer to hood installation
instructions for specific hood clearances.
The surface of the entire back wall above the range
and below the hood must be covered with a noncombustible material such as metal, ceramic tile,
brick, marble or other stone.
12" minimum
to adjacent wall
48" minimum
to combustibles
13"
max.
18"
min.
Non-Combustible
Material
12" minimum
each side
36" min.
ADDITIONAL CLEARANCES:
Allow 12" minimum clearance to an adjacent wall
on each side.
Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and
the bottom of the wall cabinet.
Listed by
Underwriters
Laboratories
Product Specification Revised 3/18
MONOGRAM 36" DUAL-FUEL PROFESSIONAL
RANGE WITH 6 BURNERS
ZDP366NPSS (NATURAL GAS)
DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)
ELECTRICAL REQUIREMENTS
OPTIONAL BACKSPLASH ACCESSORIES
Ranges must be supplied with 208/240V, 60Hz, and
connected to an individual, properly grounded branch
circuit protected by a circuit breaker or time-delay fuse.
Install a 30-amp circuit for 36" ranges. The receptacle must
be a NEMA 14-50R device to accept the four-prong plug
on the range.
The range requires a 12" minimum clearance to a vertical
combustible surface at the rear. A backsplash is required
for installations with less than 12" clearance. The following
backsplash accessories are available, or a custom, noncombustible backsplash can be used.
UNIVERSAL UTILITY LOCATIONS
ORDER ONE WITH A 36"-WIDE RANGE BACKSPLASH
ZX12B36PSS–12" backsplash
ZXADJB36PSS–30"-36" adjustable-height backsplash
with warming shelf
SIDE VIEW WITH A BACKSPLASH
28-7/8"
to Front
Edge
10-1/2"
4 5/8"
13/16"
13 3/8" 11 3/8"
6 1/2"
G/E
E
2"
30-36"
Optional
Backsplash
Accessories
12"
3-3/16"
Control Panel
Depth
2"
36"
Locate gas and electric as shown
GAS SUPPLY
•T
he LP models are designed to operate at 10" water
column pressure. For proper operation, the pressure of
the LP gas supplied to the regulator must be between
11" and 13" water column.
28-1/4" to
Beveled
Edge of Control
Panel Bullnose
1"
7" Control
Panel Height
27-1/2" to
Beveled Edge
- Maximum
Adjacent
Cabinet
Depth for
Flush
Installation
35-1/4"
to
36-3/4"
•T
he natural gas models are designed to operate at
5" water column pressure. For proper operation, the
pressure of the natural gas supplied to the regulator
must be between 7" and 13" water column.
Countertop level
28-1/4"
to Front of
Door 31-1/16"
to Front of
Handle
12" min. to combustibles or 0" to
a non-combustible material above
the cooking surface
48-1/4"
with Oven Door
Open
0" clearance
to a back or
side wall below
the cooking
surface
Listed by
Underwriters
Laboratories
Product Specification Revised 3/18
MONOGRAM 36" DUAL-FUEL PROFESSIONAL
RANGE WITH 6 BURNERS
ZDP366NPSS (NATURAL GAS)
FEATURES AND BENEFITS
UTHENTIC PROFESSIONAL APPEARANCE
A
Stainless steel with smoothly finished edges, large
electronic control knobs and heavy duty handles
SEALED, DUAL-FLAME STACKED BURNERS
Deliver a full spectrum of heat settings, from an
ultra-low 140˚F simmer to an intense 18,000 BTUs*
ONOGRAM PROFESSIONAL OVEN SYSTEM
M
Combines European, Reverse-Air convection technology
and six heating elements to provide superb baking
results
HEAVY-DUTY, FULL-EXTENSION RACKS
Glide smoothly in and out on stainless steel ball bearings
for easy access, and are designed to
remain in the oven during the self-clean cycle
ED TASK LIGHTS
L
Below the bullnose provide a functional and
theatrical touch
LECTRONIC IGNITION WITH AUTOMATIC REIGNITION
E
Ensures a continuous flame and reignites automatically if
accidentally extinguished
HALOGEN LIGHT COLUMNS
Provide a clear view, regardless of rack position
CATERER'S OVEN
A
Is uniquely sized to accommodate three full-size
sheet trays
REVERSIBLE BURNER GRATES
Flat on one side and uniquely contoured on
the other to accommodate round-bottom woks
MODEL ZDP366NPSS – Natural Gas
*Natural Gas Model
Product Specification Revised 3/18
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising